2014 TOYOTA PRIUS PLUS child seat

691-1. For safe use
1
PRIUS +_OM_OM47888E_(EE)
For safety and security
Remove the head restraint. (→P. 178)
Place the child restraint sys-
tem on the seat facing the
rear of the vehicle.
Run the seat belt through the
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted. Keep the
lap portion of the belt tight.
Install a locking clip near the
tab of the lap and shoulder
belt by inserting the lap and
shoulder webbing through
the recesses of locking clip.2
3
4
5

701-1. For safe use
PRIUS +_OM_OM47888E_(EE)■
Forward-facing
 Child seat
Adjusting the angle of the seatback.
XSecond seats
While pulling the lever (either [outboard seats only] or
), fold the seatback for-
ward and then back to the 1st
lock position (most upright
position) until it locks into
place. Adjust the seatback to
the 5th lock position.
1st lock position
5th lock position
Move the seat as far back as
possible.
XThird seats
Adjust the second seat for-
ward so that it does not inter-
fere with the child restraint
system.
While pulling the lever, fold
the seatback forward and
then back to the 1st lock
position (most upright posi-
tion) until it locks into place.
1
1
2
A
B

711-1. For safe use
1
PRIUS +_OM_OM47888E_(EE)
For safety and security
Remove the head restraint. (→P. 178)
Place the child restraint sys-
tem on the seat facing the
front of the vehicle.
Run the seat belt through the
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted. Keep the
lap portion of the belt tight.
Install a locking clip near the
tab of the lap and shoulder
belt by inserting the lap and
shoulder webbing through
the recesses of locking clip.2
3
4
5

721-1. For safe use
PRIUS +_OM_OM47888E_(EE)■
Junior seat
Adjusting the angle of the seatback.
XSecond seats
While pulling the lever (either [outboard seats only] or
), fold the seatback for-
ward and then back to the 1st
lock position (most upright
position) until it locks into
place. Adjust the seatback to
the 5th lock position.
1st lock position
5th lock position
Move the seat as far back as
possible.
XThird seats
Adjust the second seat for-
ward so that it does not inter-
fere with the child restraint
system.
While pulling the lever, fold
the seatback forward and
then back to the 1st lock
position (most upright posi-
tion) until it locks into place.
1
1
2
A
B

731-1. For safe use
1
PRIUS +_OM_OM47888E_(EE)
For safety and security
Place the child restraint sys-
tem on the seat facing the
front of the vehicle.
Sit the child in the child
restraint system. Fit the seat
belt to the child restraint sys-
tem according to the manu-
facturer’s instructions and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
Check that the shoulder belt is
correctly positioned over the
child’s shoulder and that the lap
belt is as low as possible.
(→ P. 38)
Press the buckle release button
and fully retract the seat belt.
2
3
Removing a child restraint installed with a seat belt

741-1. For safe use
PRIUS +_OM_OM47888E_(EE)
Adjusting the angle of the seatback.
While pulling the lever (either or ), fold the seatback for-
ward and then back to the 1st
lock position (most upright posi-
tion) until it locks into place.
Adjust the seatback to the 5th
lock position.
1st lock position
5th lock position
Move the seat as far back as
possible.
Remove the head restraint. ( →P. 178)
Installation with ISOFIX rigid anchor (ISOFIX child restraint sys-
tem) (second outboard seats only)
1
12
A
B
2

751-1. For safe use
1
PRIUS +_OM_OM47888E_(EE)
For safety and security
Open the fasteners on the
lower part of the seatback.
Check the positions of the
exclusive fixing bars, and install
the child restraint system to the
seat.
The bars are installed in the clear-
ance between the seat cushion
and seatback.
If the child restraint has a top strap,
the top strap should be latched
onto the anchors.
3
4

761-1. For safe use
PRIUS +_OM_OM47888E_(EE)
Latch the hook onto the anchor
bracket and tighten the top strap.
Make sure the top strap is securely
latched.
■When installing a child restraint system
You need a locking clip to install the child restraint system. Follow the instruc-
tions provided by the manufacturer of the system. If your child restraint sys-
tem does not provide a locking clip, you can purchase the following item from
any authorized Toyota dealer or re pairer, or another duly qualified and
equipped professional:
Locking clip for child restraint system
(Part No. 73119-22010)
Child restraint systems with a top strap (second outboard seats
only)