PETROL INJECTION
Fault finding – Replacement of components17B
17B - 15V12 MR-372-J84-17B000$180.mif
SAGEM 3000
Program No.: A7
Vdiag No.: 44, 48PETROL INJECTION
Fault finding – Replacement of components
1. PROGRAMMING, REPROGRAMMING OR REPLACING THE COMPUTER
The system can be programmed and reprogrammed via the diagnostic socket using the RENAULT CLIP diagnostic
tool (Consult Technical Note 3585A or follow the instructions provided by the diagnostic tool).
Whenever the computer has been programmed, reprogrammed or replaced:
–switch off the ignition;
–start and then stop the engine (to initialise the computer) and wait for 30 seconds,
–switch on the ignition again and use the diagnostic tool to carry out the following steps:
– run command VP010 Enter VIN,
– deal with any faults declared by the diagnostic tool. Clear the computer memory.
– program the flywheel sensor target and throttle stops,
– carry out a road test followed by another check with the diagnostic tool.
2. REPLACING OR REMOVING THE TDC SENSOR
When the TDC sensor is replaced or removed, the flywheel target has to be programmed.
3. REPLACING THE MOTORISED THROTTLE VALVE
When the throttle valve is replaced, the throttle stops must be programmed.IMPORTANT
–switch on the diagnostic tool (mains or cigarette lighter supply),
–connect a battery charger (during the entire computer (re)programming procedure, the motor-driven fan
assemblies are triggered automatically),
–observe the engine temperature instructions of the diagnostic tool before (re)programming.
IMPORTANT
It is not possible to test an injection computer from the Parts Department because it can no longer be fitted on any
other vehicle.
IMPORTANT
Never drive the vehicle without having programmed the throttle stops.
JSAA741.0
MR-372-J84-17B000$180.mif
