2014 Ram ProMaster engine overheat

Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately.To minimize the possibility of catalytic converter damage:
• Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
• Do not try to start the engine by pushing or towing the
vehicle.
• Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery.
You will never have to add water, nor is periodic main-
tenance required.
332 MAINTAINING YOUR VEHICLE

NOTE:
•Some vehicles require special tools to add coolant
properly. Failure to fill these systems properly could
lead to severe internal engine damage. If any coolant is
needed to be added to the system please contact your
local authorized dealer.
•
Mixing engine coolant (antifreeze) types is not recom-
mended and can result in cooling system damage.
If HOAT and OAT coolant are mixed in an emergency,
have a authorized dealer drain, flush, and refill with
OAT coolant (conforming to MS-12106) as soon as pos-
sible.
Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of engine
coolant (antifreeze), and to ensure that engine coolant
(antifreeze) will return to the radiator from the coolant
recovery tank. The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.
WARNING!
•
Do not open hot engine cooling system. Never add
engine coolant (antifreeze) when the engine is
overheated. Do not loosen or remove the cap to cool
an overheated engine. Heat causes pressure to
build up in the cooling system. To prevent scalding
or injury, do not remove the pressure cap while the
system is hot or under pressure.
• Do not use a pressure cap other than the one
specified for your vehicle. Personal injury or en-
gine damage may result.
342 MAINTAINING YOUR VEHICLE

DrivingThrough Flowing, Rising, or Shallow Standing
Water ............................... .209
Electric Remote Mirrors ......................73
Electronic Brake Control System ...............216
Brake Assist System .....................218
Electronic Speed Control (Cruise Control) ........101
Electronic Stability Control (ESC) ..............218
Electronic Vehicle Information Center (EVIC) Exit Trip ............................. .147
NewTrip ............................ .147
Start Of Trip Procedure ...................147
Trip Computer ........................ .147
Trip Functions ........................ .148
Emergency, In Case of Freeing Vehicle When Stuck ................314
Jump Starting ......................... .308
Emission Control System Maintenance ..........323Engine
Air Cleaner .......................... .329
Block Heater ......................... .196
Break-In Recommendations .................63
Checking Oil Level ..................... .327
Compartment ......................... .321
Compartment Identification ................321
Coolant (Antifreeze) .....................339
Cooling ............................. .338
Exhaust Gas Caution .....................64
Fails to Start .......................... .195
Flooded, Starting ...................... .195
Fuel Requirements ..................... .255
Jump Starting ......................... .308
Oil................................. .327
Oil Selection .......................... .327
Oil Synthetic ......................... .329
Overheating .......................... .283
Starting ............................. .194
10
INDEX 395

Capacity............................ .370
Change Interval ....................... .327
Checking ............................ .327
Disposal ............................. .329
Filter ............................... .329
Filter Disposal ........................ .329
Identification Logo ..................... .328
Materials Added to ..................... .329
Recommendation ...................... .327
Synthetic ............................ .329
Viscosity ............................ .328
Oil Filter, Selection ....................... .329
Onboard Diagnostic System ..................322
Operator Manual (Owner’s Manual) .............4
Outside Rearview Mirrors ....................72
Overhead Console .........................114
Overheating, Engine ...................... .135
Owner’s Manual (Operator Manual) .............4Paint Care
............................. .348
Parking Brake ........................... .212
ParkSense® System, Rear ....................106
Passing Light .............................94
Placard, Tire and Loading Information ..........231
Power Mirrors ...............................73
Steering ............................. .210
Windows ..............................23
Power Steering Fluid ...................... .373
Pregnant Women and Seat Belts ................37
Pretensioners Seat Belts ..............................36
Radial Ply Tires ......................... .238
Radiator Cap (Coolant Pressure Cap) ...........342
Radio Operation ......................... .186
Rear Camera .............................112
Rear ParkSense System .....................106
10
INDEX 401