Page 535 of 666
Towing Requirements — Trailer Lights And Wiring
Whenever you pull a trailer, regardless of the trailer size,
stoplights and turn signals on the trailer are required for
motoring safety.
The Trailer Tow Package may include a four- and seven-
pin wiring harness. Use a factory approved trailer har-
ness and connector.
NOTE:Do not cut or splice wiring into the vehicles
wiring harness.
The electrical connections are all complete to the vehicle
but you must mate the harness to a trailer connector.
Refer to the following illustrations.
Four-Pin Connector
1 — Female Pins 4 — Park
2 — Male Pin 5 — Left Stop/Turn
3 — Ground 6 — Right Stop/Turn
5
STARTING AND OPERATING 533
Page 543 of 666

HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located in the
lower center area of the instrument panel.Press the switch to turn on the Hazard Warning
flasher. When the switch is activated, all direc-
tional turn signals will flash on and off to warn oncoming
traffic of an emergency. Press the switch a second time to
turn off the Hazard Warning flashers.
This is an emergency warning system and it should not
be used when the vehicle is in motion. Use it when your
vehicle is disabled and it is creating a safety hazard for
other motorists.
When you must leave the vehicle to seek assistance, the
Hazard Warning flashers will continue to operate even
though the ignition is placed in the OFF position.
NOTE: With extended use the Hazard Warning flashers
may wear down your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
• On the highways — slow down.
• In city traffic — while stopped, place the transmission
in NEUTRAL, but do not increase engine idle speed.
NOTE: There are steps that you can take to slow down
an impending overheat condition:
• If your air conditioner (A/C) is on, turn it off. The A/C
system adds heat to the engine cooling system and
turning the A/C off can help remove this heat.
• You can also turn the temperature control to maximum
heat, the mode control to floor and the blower control
to high. This allows the heater core to act as a
supplement to the radiator and aids in removing heat
from the engine cooling system.
6
WHAT TO DO IN EMERGENCIES 541
Page 576 of 666
▫Appearance Care And Protection
From Corrosion ..................... .602
▫ Cleaning The Instrument Panel Cupholders . .608
FUSES ............................. .609
▫ Totally Integrated Power Module ..........610
VEHICLE STORAGE ....................618
REPLACEMENT BULBS .................619
BULB REPLACEMENT ..................620
▫ Headlamps ........................ .620
▫ Front Park/Turn Signal Lamps ............621▫
Fog Lamps ......................... .621
▫ Rear Tail, Stop, Turn Signal, Side Marker And
Backup Lamps ...................... .622
▫ Center High-Mounted Stop Lamp (CHMSL) . .623
▫ License Lamp ....................... .623
FLUID CAPACITIES ....................624
FLUIDS, LUBRICANTS AND
GENUINE PARTS ..................... .625
▫ Engine ............................ .625
▫ Chassis ........................... .626
574 MAINTAINING YOUR VEHICLE
Page 622 of 666

Exterior Bulbs
Bulb Number
Headlamp H11
Fog Lamp – If Equipped PSX24W
Front Side Marker, Park/
Turn Signal 3757A or PY27/7W
Rear Tail, Stop, Turn Sig-
nal Lamp LED (Serviced at Autho-
rized Dealer)
Center High-Mounted
Stop Lamp LED (Serviced at Autho-
rized Dealer)
Backup Lamp 3157
License 168
NOTE: All of the interior bulbs are glass wedge base or
glass cartridge types. Aluminum base bulbs are not
approved and should not be used for replacement.
BULB REPLACEMENT
NOTE: Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Headlamps
1. Raise the hood to access the rear of the headlamp housing.
2. Slide the red lock tab rearward on the connector, then depress the tab and remove the connector from the
bulb.
3. Twist the headlamp bulb and pull the bulb from the headlamp housing.
4. Install the new headlamp bulb and twist until locked into the headlamp housing.
620 MAINTAINING YOUR VEHICLE
Page 623 of 666

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
5. Connect the wiring connector to bulb and slide red lock tab forward.
Front Park/Turn Signal Lamps
1. Raise the hood to access the rear of the headlamphousing.
2. Twist the turn signal socket and remove from the headlamp housing, then pull the bulb out.
3. Push the new bulb into the socket and reinstall the socket by twisting until locked into the headlamp
housing.
Fog Lamps
NOTE: Access to the fog lamp bulb is from the rear of
the fascia. On the left rear side of the fascia, remove the
push pin and lower the hinged access door on the air
dam.
1. From behind the bumper fascia, or the access panel on the air dam, squeeze the two tabs on the side of the
bulb socket and pull straight out from the fog lamp.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
2. Disconnect the wire harness from the bulb.
7
MAINTAINING YOUR VEHICLE 621
Page 624 of 666
3. Reconnect the wiring harness to the new bulb andreinstall by inserting the new bulb straight into the fog
lamp until it locks into place.
Rear Tail, Stop, Turn Signal, Side Marker And
Backup Lamps
1. Raise the liftgate.
2. Remove the tail lamp assembly by removing the twoscrews from the inboard side. Use a fiber stick or
similar tool to gently pry the light on the outboard side
to disengage the two ball studs.
NOTE:•If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
• The PRY location is best closest to the studs while
dislodging them separately.
Tail Lamp Assembly Screws
622 MAINTAINING YOUR VEHICLE
Page 651 of 666

Event Data Recorder........................85
Exhaust Gas Caution ........................54
Exhaust System .......................... .101
Exterior Lights .......................... .105
Fabric Care ............................. .605
Filler Location Fuel ....................... .302
Filters Air Cleaner .......................... .583
Air Conditioning ...................... .434
Engine Oil ........................... .583
Engine Oil Disposal .....................582
Flashers Hazard Warning ....................... .541
Turn Signal .......................... .105
Flash-To-Pass ........................... .210
Flexible Fuel Vehicles Cruising Range ........................ .517
Engine Oil ........................... .517Fuel Requirements
..................... .514
Maintenance .......................... .518
Replacement Parts ...................... .518
Starting ............................. .517
Flooded Engine Starting ....................442
Floor Console ........................... .269
Fluid Capacities ......................... .624
Fluid Leaks ............................ .105
Fluid Level Checks Automatic Transmission ..................601
Brake ............................... .598
Cooling System ........................ .592
Power Steering ........................ .461
Fluids, Lubricants and Genuine Parts ...........625
Fog Lights ............................. .206
Fog Light Service ........................ .621
Fold in Floor (Stow n Go) Seating.............178
Freeing A Stuck Vehicle .....................568
Fuel .................................. .510
10
INDEX 649
Page 660 of 666

Reclining............................ .173
Stow n Go (Fold in Floor) .................178
Security Alarm ............................17
Selection of Coolant (Antifreeze) ...............625
Sentry Key (Immobilizer) ....................15
Sentry Key Programming ....................17
Sentry Key Replacement .....................16
Service Assistance ........................ .635
Service Contract ......................... .637
Service Engine Soon Light (Malfunction Indicator) . .300
Service Manuals ......................... .640
Settings, Personal ........................ .325
Setting the Clock ......................... .333
Shift Lever Override ...................... .569
Shoulder Belts ............................58
Side Airbag ..............................80
Signals, Turn ........................... .105
Sliding Door .............................43
Snow Chains (Tire Chains) ...................498 Snow Tires
............................. .491
Spare Tire .............................. .493
Speed Control (Cruise Control) ................219
Speedometer ............................ .302
Starting ............................... .441
Automatic Transmission ..................441
Cold Weather ......................... .442
Engine Fails to Start .....................442
Remote ...............................30
Starting and Operating .....................441
Starting Procedures ....................... .441
Steering Power .............................. .460
Tilt Column .......................... .215
Wheel, Heated ........................ .216
Wheel, Tilt ........................... .215
Steering Wheel Audio Controls ...............412
Steering Wheel Mounted Sound System Controls . . .412
Storage ............................... .618
658 INDEX