Page 498 of 546
Bulb Number
Center High Mounted Stop Lamp 921
Rear Cargo Lamp 921
Box Off Tail Lamps –
Stop/Turn/Tail/License Plate 1157
Box Off Tail Lamps – Back Up 1156
BULB REPLACEMENT
NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Base Quad / Premium Bi-Halogen: Low Beam
Headlamp, High Beam Headlamp, Front Park And
Turn — If Equipped
1. Open the hood.
2. Disconnect and isolate the negative battery cable.
3. Remove the six plastic push-in fasteners that secure the upper radiator seal to the grille support and both
fender ledges.
4. Remove the two plastic push-in rivets that secure the upper radiator seal to the radiator.
5. Remove the upper radiator seal from the vehicle.
6. Remove the two headlamp assembly attachment screws.
496 MAINTAINING YOUR VEHICLE
Page 511 of 546

•Check windshield washer fluid level
• Check the tire inflation pressures and look for unusual
wear or damage
• Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering and automatic trans-
mission as needed
• Check function of all interior and exterior lights
Required Maintenance
Refer to the Maintenance Schedules on the following
pages for required maintenance.
At Every Oil Change Interval As Indicated By Oil Change Indicator System:
•Change oil and filter.
At Every Oil Change Interval As Indicated By Oil
Change Indicator System:
•Rotate the tires. Rotate at the first sign of irregu-
lar wear, even if it occurs before the oil indicator
system turns on.
• Inspect battery and clean and tighten terminals as
required.
• Inspect automatic transmission fluid if equipped
with dipstick.
• Inspect brake pads, shoes, rotors, drums, hoses
and park brake.
• Inspect engine cooling system protection and
hoses.
• Inspect exhaust system.
• Inspect engine air cleaner if using in dusty or
off-road conditions.
• Lube the front drive shaft fitting.
8
M
A I
N T
E
N
A
N
C E
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 509
Page 529 of 546

Fluid Type........................... .474
Shifting ............................. .300
Special Additives ...................... .474
Axle Fluid ............................. .471
Axle Lubrication (Axle Fluid) .................471
Battery ................................ .455
Keyless Transmitter Replacement (RKE) ........28
Belts, Seat ...............................50
Body Builders Guide ........................6
Body Mechanism Lubrication .................457
B-Pillar Location ......................... .351
Brake Control System, Electronic ..............333
Brake Fluid ............................ .469
Brake System ........................... .330
Anti-Lock (ABS) ....................... .331
Fluid Check .......................... .469
Master Cylinder ....................... .469
Parking ............................. .328Warning Light
........................ .202
Brake/Transmission Interlock .................300
Bulb Replacement ........................ .496
Bulbs, Light .............................114
Cab Top Clearance Lights ...................501
Capacities, Antifreeze (Engine Coolant) ..........503
Capacities, Fluid ......................... .503
Caps, Filler Oil (Engine) .......................... .453
Power Steering ........................ .327
Radiator (Coolant Pressure) ................465
Carbon Monoxide Warning ..................110
Cargo Light ............................ .159
Car Washes ............................ .478
Cellular Phone .......................... .268
Center High Mounted Stop Light ..............499
Center Lap Belts ...........................59
Center Seat Storage Compartment .............187
10
INDEX 527
Page 537 of 546

Locks..................................35
Automatic Door .........................37
Child Protection .........................38
Door .................................35
Power Door ............................37
Low Tire Pressure System ...................372
Lubrication, Body ........................ .457
Lug Nuts .............................. .420
Maintenance Free Battery ....................455
Maintenance Procedures ....................450
Maintenance Schedule ..................... .508
Malfunction Indicator Light (Check Engine) .......448
Manual, Service ......................... .522
Manual Transmission Fluid Level Check ...................... .473
Memory Seat ........................... .143
Methanol .............................. .382
Mirrors ................................119 Electric Powered
....................... .128
Heated .............................. .129
Memory ............................. .143
Outside ............................. .126
Rearview .............................119
Trailer Towing ........................ .131
Modifications/Alterations, Vehicle ...............7
Monitor, Tire Pressure System ................372
Mopar Parts ............................ .449
MTBE/ETBE ........................... .382
Multi-Function Control Lever .................160
New Vehicle Break-In Period .................108
Occupant Restraints ........................47
Occupant Restraints (Sedan) ..................67
Octane Rating, Gasoline (Fuel) ................380
Oil, Engine ............................. .451
Capacity ............................ .503
10
INDEX 535
Page 543 of 546

Weight.............................. .394
Towing Vehicle Behind a Motorhome ...........410
Traction ............................... .323
Traction Control ......................... .334
Trailer Sway Control (TSC) ..................343
Trailer Towing .......................... .389
Cooling System Tips .....................406
Hitches ............................. .393
Minimum Requirements ..................396
Mirrors ............................. .131
Trailer and Tongue Weight .................395
Wiring .............................. .404
Trailer Towing Guide ...................... .394
Trailer Weight ........................... .394
Transfer Case ........................... .473
Electronically Shifted .....................316
Fluid ............................... .506
Transmission Automatic ........................... .300Fluid
............................... .506
Maintenance .......................... .474
Shifting ............................. .297
Transmitter Battery Service (Remote Keyless Entry) . .28
Transmitter Programming (Remote Keyless Entry) . . .23
Transmitter, Remote Keyless Entry (RKE) .........23
Tread Wear Indicators ..................... .365
Turn Signals ............................ .160
Uconnect® Customer Programmable Features ...........258
Uconnect® Settings ..................... .258
Uconnect® Settings Customer Programmable Features ............40
Passive Entry Programming .................40
Uconnect® Settings ..................... .256
Uniform Tire Quality Grades .................523
Unleaded Gasoline ....................... .380
10
INDEX 541
Page 545 of 546

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.