2014 Ram 1500 mirror controls

Resetting the Power Folding Outside Mirrors
You may need to reset the power folding mirrors if the
following occurs:
•The mirrors are accidentally blocked while folding.
• The mirrors are accidentally manually folded/
unfolded.
• The mirrors come out of the unfolded position.
• The mirrors shake and vibrate at normal driving
speeds.
To reset the power folding mirrors: Fold and unfold them
by pressing the button (this may require multiple button
pushes). This resets them to their normal position.Power Mirrors — If Equipped
The controls for the power mirrors are located on the
driver’s door trim panel.
The power mirror controls consist of mirror select but-
tons and a four-way mirror control switch.
Power Mirror Controls Location
142 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To adjust a mirror, press either the L (left) or R (right)
button to select the mirror that you want to adjust.Using the mirror control switch, press on any of the four
arrows for the direction that you want the mirror to move
Power Mirror Controls
1 — Mirror Select Buttons
2 — Four-Way Mirror Control SwitchPower Mirror Movement
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 143

STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belt.
The starter should not be operated for more than 15-
second intervals. Waiting a few seconds between such
intervals will protect the starter from overheating.
WARNING!
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Leaving children in a
vehicle unattended is dangerous for a number of
reasons. A child or others could be seriously or
fatally injured. Children should be warned not to
touch the parking brake, brake pedal or the shift
lever. Do not leave the Key Fob in or near the vehicle,
or in a location accessible to children, and do not
(Continued)
WARNING!(Continued)
leave the ignition of a vehicle equipped with keyless
Enter-N-Go in the ACC or ON/RUN mode. A child
could operate power windows, other controls, or
move the vehicle.
Normal Starting
Normal starting of either a warm or cold engine is
obtained without pumping or pressing the accelerator
pedal. Cycle the ignition to the START position and
release when the engine starts. If the engine fails to start
within 10 seconds, cycle the ignition to the OFF position,
wait five seconds, then repeat the “Normal Starting”
procedure.
390 STARTING AND OPERATING

Switch.............................. .170
Head Restraints ......................... .160
Heated Mirrors .......................... .144
Heater ................................ .361
Heater, Engine Block ...................... .399
High Beam/Low Beam Select (Dimmer) Switch . . . .180
Hitches Trailer Towing ........................ .594
Hoisting ............................... .671
HomeLink® (Garage Door Opener) ............214
Hood Release ........................... .168
Hub Caps .............................. .669
Ignition .................................16
Key..................................12
Ignition Key Removal .......................16
Illuminated Entry ..........................23
Immobilizer (Sentry Key) ....................19
Infant Restraint ...........................83 Inflation Pressure Tires
.....................561
Information Center, Vehicle ..................297
Inside Rearview Mirror .....................132
Instrument Cluster ....................... .284
Instrument Panel and Controls ................281
Instrument Panel Lens Cleaning ...............730
Integrated Trailer Brake Controls ..............604
Interior Appearance Care ....................728
Interior Lights .......................... .175
Intermittent Wipers (Delay Wipers) .............181
Introduction ..............................4
Inverter Outlet (115V) ..................... .232
Jack Location ........................... .633
Jump Starting ........................... .671
Key Fob Programming Additional Key Fobs ...........21
Programming Additional Transmitters .........21
10
INDEX 791