2014 Peugeot RCZ display

10
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
CENTRE CONSOLES
1. Audio and telematic system microphone.
2. Courtesy lamp / Map reading lamps / Interior mood lighting.
3. Seat belt and front passenger's airbag warning lamps display.
4. Interior volumetric sensors (alarm).
5. Multifunction screen.
6. Clock.
7. Emergency call button.
Alarm button.
Central locking button.
Hazard warning lamps button.
Dynamic stability control (ESC/ASR/EBA) button.
Parking sensors button.
PEUGEOT services button.
8. PEUGEOT Connect Sound (RD5) and storage compartment, PEUGEOT
Connect Navigation (RT6) or PEUGEOT
Connect Media Navigation (NG4 3D).
9. Heating / air conditioning controls.
10. Front ashtray.
11 . 12 V accessories socket.
12. Active spoiler control.
13. Storage compartment or instrument panel navigator associated with the PEUGEOT
Connect Media Navigation (NG4 3D).
14. Cup holder.
15. Front armrest / USB / auxiliary socket.

61
22 26
56 208, 209
105 147
208, 209
FAMILIARISATION
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
MONITORING
The instrument panel has permanent back-
lighting for improved visibility in all situations,
both day and night.
- With the ignition on, the fuel gauge needle should indicate the level of fuel remaining.
- With the engine running, its associated low level warning lamp should go off.
- With the ignition on, the oil level indicator should display "OK" or "correct",
depending on version, for a few seconds.
If the levels are not correct, top up the levels
which are low.
INSTRUMENT PANEL
- With the ignition on, the orange and red warning lamps come on.
- With the engine running, these warning lamps should go off.
If warning lamps remain on, refer to the page
concerned.
WARNING LAMPS
Illumination of the indicator lamp indicates the
status of the corresponding function.
A. Emergency call.
SWITCH PANEL
B. Deactivation of the interior volumetric and anti-tilt sensors (alarm).
C. Central locking.
D. Deactivation of the DSC/ASR system.
E. Deactivation of the front and rear parking sensors.
F. Access to PEUGEOT services.

140143
18
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
DRIVING SAFELY
1. Limiter mode Selection / Off.
2. Decrease the programmed value.
3. Increase the programmed value.
4. Speed limiter On / Off.
The values must be set with the engine running.
SPEED LIMITER "LIMIT"
1. Cruise control mode Selection / Off.
2. Programme a speed / Decrease the programmed value.
3. Programme a speed / Increase the programmed value.
4. Cruise control Off / Resume.
CRUISE CONTROL "CRUISE"
In order to be programmed or activated, the
vehicle speed must be higher than 25 mph
(40 km/h), with at least fourth gear engaged
on the manual gearbox (second gear for the
automatic gearbox).
DISPLAY IN THE INSTRUMENT
PANEL
Cruise control
Speed limiter
The cruise control or speed limiter mode
appears in the instrument panel when it is
selected.

20
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
OPTIMISE THE USE OF YOUR GEARBOX
With a manual gearbox, move off gently and change up without
waiting. During acceleration change up early.
With an automatic or electronic gearbox, give preference to automatic
mode and avoid pressing the accelerator pedal heavily or suddenly.
The gear shift indicator invites you engage the most suitable gear: as
soon as the indication is displayed in the instrument panel, follow it
straight away.
For vehicles fi tted with an electronic or automatic gearbox, this
indicator appears only in manual mode.
DRIVE SMOOTHLY
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and CO
2
emissions and also helps reduce the background traffi c noise.
CONTROL THE USE OF YOUR ELECTRICAL
EQUIPMENT
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember to make use of equipment that can help keep the temperature
in the passenger compartment down (sunroof and window blinds...).
Switch off the air conditioning, unless it has automatic regulation, as soon
as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the level of light
does not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices
(fi lm, music, video game...), you will contribute towards limiting the
consumption of electrical energy, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
ECO-DRIVING
Eco-driving is a range of everyday practices that allow the motorist to \
optimise their fuel consumption and CO2 emissions.
If your vehicle has cruise control, make use of the system at speeds
above 25 mph (40 km/h) when the traffi c is fl owing well.

22
PETROL - DIESEL MANUAL
OR AUTOMATIC GEARBOX
INSTRUMENT PANELS DIALS
1. Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).
2. Coolant temperature.
Indicates the temperature of the engine coolant (°Celsius).
3. Fuel level.
Indicates the quantity of fuel remaining in the tank.
4. Vehicle speed.
Indicates the current speed of the moving vehicle (mph or km/h).
5. Small display screen.
6. Central display screen.
7. Display management button.
Starts a manual CHECK.
Recalls the service information.
Resets the selected function to zero (trip distance recorder or service indicator).
8. Lighting dimmer button.
Adjusts the brightness of the lighting of the instruments and controls.
With large central display screen
Panel grouping together the vehicle operation indication dials and
warning lamps, with permanent back-lighting.
For more information, refer to the paragraph relating to the button
or function and its associated display.
With small central display screen

1/
MONITORING
DISPLAYS
* According to engine.
** Only on the large central display screen.
***
Only on the large central display screen with PEUGEOT Connect Media (NG4 3D).
Small display screen
A. Trip distance recorder.
(miles or km)
B. Distance recorder.
(miles or km)
C. Service spanner, if a service is due shortly or is overdue.
Central display screen
D. Speed limiter
(mph or km/h) or
Cruise control.
E. Indication of:
- a gear change * ,
or
- the programme or gear (automatic gearbox).
F. Engine oil level indicator,
service indicator.
(miles or km)
These two functions are displayed when the ignition is switched on, then disappear after a few seconds.
Warning and status indicator lamps / CHECK.

Trip computer.
Vehicle speed repeat ** .
Alert messages *** .
Vehicle parameters *** .
Navigation - Guidance *** .
These functions are displayed according to the selection.

24
INSTRUMENT PANEL NAVIGATOR WITH THE LARGE CENTRAL DISPLAY
SCREEN AND PEUGEOT CONNECT MEDIA NAVIGATION (NG4 3D)
Controls
There are four buttons to control the instrument panel large central
display screen:
1. access the main menu, confi rm the selection,
2. move up through the menu,
3. move down through the menu,
4. return to the previous screen, exit from the menu.
Main menu
 Press button 1 for access to the main menu and select one of the
following functions:
- "Vehicle parameters",
- "Choice of language",
- "Choice of units".
 Press button 2 or 3 to move on the screen.
 Press button 1 again to confi rm the selection.
This group of buttons permits:
- when stationary , confi guration of the vehicle's equipment and of
the parameters of the central display (languages, units...),
- while driving , scrolling of the active functions (trip computer,
navigation...). The main menu and its associated functions can only be
accessed when stationary , via buttons
1 to 4 .
A message appears on the central screen, above a certain speed
threshold, indicating that the main menu cannot be displayed.
The trip computer displays can only be accessed while driving, via
buttons 2 and 3 (refer to the "Trip computer" section).

1/
MONITORING
Vehicle parameters *
This menu allows you to activate or deactivate certain driving and
comfort equipment:
- vehicle speed repeat,
- selective unlocking (refer to the "Access" section),
- guide-me-home lighting (refer to the "Visibility" section),
- interior mood lighting (refer to the "Ease of use and comfort" section),
- daytime running lamps ** (refer to the "Visibility" section),
- directional headlamps (refer to the "Visibility" section),
- rear parking sensors (refer to the "Driving" section).
Choice of language
This menu allows you to select the language used by the display:
Deutsch, English, Espanol, Français, Italiano, Nederlands, Portugues,\

Pусский, Portugues-Brasil, Türkçe ** .
Choice of units
This menu allows you to select the units: temperature (°Celsius or
°Fahrenheit) and fuel consumption (l/100 km, mpg or km/l).
* Depending on version.
** Depending on country of sale.