F0
158
DIESEL FUEL ADDITIVE LEVEL (DIESEL WITH
PARTICLE EMISSIONS FILTER)
The additive reservoir low level is indicated by fi xed illumination
of this warning lamp, accompanied by an audible signal and
a message that the particle emissions fi lter additive level is
too low.
Topping up
The reservoir must be topped up without delay by a PEUGEOT dealer
or a qualifi ed workshop.
USED PRODUCTS
Avoid prolonged contact of used oil or fl uids with the skin.
Most of these fl uids are harmful to health or indeed very corrosive.
Do not discard used oil or fl uids into sewers or onto the ground.
Take used oil to a PEUGEOT dealer or a qualifi ed workshop
(France) or to an authorised waste disposal site.
COOLANT LEVEL
The coolant level should be close to the "MAX" mark but
should never exceed it.
When the engine is warm, the temperature of the coolant is regulated
by the fan.
In addition, as the cooling system is pressurised, wait at least one hou\
r
after switching off the engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap by two turns to allow the \
pressure to drop. When the pressure has dropped, remove the cap and
top up the level. The cooling fan may start after switching off the engine: take
care with articles and clothing that might become caught by the
fan blades.
Fluid specification
The coolant must conform to the manufacturer's recommendations.
SCREENWASH AND HEADLAMP WASH FLUID
In the case of vehicles fi tted with headlamp washers, the low
fl uid level is indicated by an audible signal and a message in
the instrument panel screen.
Top up the reservoir when you next stop the vehicle.
Fluid specification
For optimum cleaning and to avoid freezing, this fl uid must not be
topped up with or replaced with plain water.
In wintry conditions, the use of an ethyl alcohol or methanol base fl uid is
recommended.
