2014 PEUGEOT 4008 stop start

122
Driving

Going into engine START mode

The "AS &G"
warning lamp goes off
and the engine starts automatically:


- with a manual gearbox
, when you fully

depress the clutch pedal.
For safety reasons or to ensure smooth
operation, START mode is invoked
automatically when:

Special cases: START invoked
automatically


- the speed of the vehicle exceeds 2 mph (3 km/h),

- some special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed to assure control of a system.
If the system has been deactivated in
STOP mode, the engine will not start. At any time, press the "AS &G O FF "
switch to
deactivate the system.

Deactivation

In this case the "AS &G"
warning lamp
flashes for few seconds, then goes off.

This operation is per fectly normal.




This is confirmed by the "AS &G O FF "
warning lamp coming on in the instrument
panel or instrument panel screen.

123
4
Driving
The system is reactivated automatically
at every new start using the key or the
START/STOP button.


Reactivation

Press the "AS &G O FF "
switch again.
The system is active again; this is confirmed by
the "AS &G O FF "
warning lamp going off in the
instrument panel or instrument panel screen.

Operating fault

In the event of a malfunction with the system,
the "AS &G O FF "
warning lamp flashes in the
instrument panel or instrument panel screen,
and the system no longer operates.
Have it checked by a PEUGEOT dealer or a
qualified workshop. This system requires a specific
battery with a special specification
and technology (reference numbers
available from a PEUGEOT dealer or a
qualified workshop).
Fitting a battery not listed by PEUGEOT
introduces the risk of malfunction of the
system.

Maintenance

The "Auto Stop & Go" system makes
use of advanced technology. All work
on this type of battery must be done
only by a PEUGEOT dealer or a
qualified workshop.

In the event of a fault in STOP mode, the
vehicle may stall. The following warning lamps
come on in the instrument panel or instrument
panel screen:

It is then necessary to switch off the ignition,
then restart the engine using the key or the
START/STOP button.

131
4
Driving


Visual assistance







Front parking sensors


Deactivation / Activation of the
front and rear parking sensors
The function is deactivated by pressing this
button. The indicator lamp in the button goes off.
Pressing this button again reactivates the
function. The indicator lamp in the button
comes on.



Operating fault

The front parking sensors are triggered when
an obstacle is detected in front, a gear is
engaged (position D for vehicles with a CVT
gearbox) and the speed of the vehicle remains
below 6 mph (10 km/h).
The front parking sensors are interrupted if
the vehicle stops for more than five seconds
in for ward gear, if no further obstacles are
detected or when the speed of the vehicle
exceeds 6 mph (10 km/h).




Remember to deactivate the system if
towing a trailer or caravan.

In bad weather or in winter, ensure that
the sensors are not covered with mud,
ice or snow.
When the vehicle is moving at a speed
below 6 mph (10 km/h), certain sound
sources (motorcycle, lorry, pneumatic
drill, etc.) may trigger the audible
signals of the parking sensor system.
In the event of an problem, when reverse gear
is engaged this lamp in the button flashes,
accompanied by an audible signal. This supplements the audible
signal by displaying bars in the
screen, in front of or behind the
vehicle. If one of the sensors is faulty, it
flashes in the instrument panel
screen.
Contact a PEUGEOT dealer or a qualified
workshop. These bars flash at the start of the manoeuvre
then become fixed from a certain distance
between the vehicle and the obstacle.

9
225
Te c h n i c a l d a t a

* The maximum power corresponds to the value type-approved on a test bed, under conditions defined in European legislation (Directive 1999/99/EC).















Engines and gearboxes


.../S
: model fitted with the Stop & Start (AS&G) function.
PETROL ENGINES


1.6 litre 115



2.0 litre 150



Model codes :

BU

...


NKZ7

NKZ7/S

NKZ0

NKZ0/S



AFYR

AFZ7



AFYV
AFZM



AFYT
AFZH



AFYW
AFZP



Tr a n s m i s s i o n m o d e


2WD



2WD



4WD



2WD



4WD


Cubic capacity (cc)
1 590
1 998
Bore x stroke (mm)
75 x 90
86 x 86
Max power * : EU standard (kW)
86
113
Max power engine speed (rpm)
6 000
6 000
Max torque: EU standard (Nm)
15 4
19 9
Max torque engine speed (rpm)
4 000
4 200
Fuel
Unleaded
Unleaded
Catalytic conver ter
Ye s
Ye s

GEARBOXES

Manual
(5-speed)
Manual
(5-speed)
CVT
(6-speed)

OIL CAPACITY (in litres)











Engine (with filter replacement)
4.2
4.3

232
Te c h n i c a l d a t a

* The maximum power corresponds to the value type-approved on a test bed, under conditions defined in European legislation (Directive 1999/99/EC).
DIESEL ENGINES


1.6 HDi 110



1.8 HDi 150



Model codes
:

BU...


9HD8/S



9HDB/S



6HZ8/S



6HZB

6HZB/S



Tr a n s m i s s i o n m o d e


2WD



4WD



2WD



4WD


Cubic capacity (cc)
1 560
1 798
Bore x stroke (mm)
77 x 88.3
83 x 83.1
Max power * : EU standard (kW)
84
11 0
Max power engine speed (rpm)
3 600
4 000
Max torque: EU standard (Nm)
270
300
Max torque engine speed (rpm)
1 750
2 000 to 3 000
Fuel
Diesel
Diesel
Catalytic conver ter
Ye s
Ye s
Particle emission filter (PEF)
Ye s
Ye s

GEARBOXES

Manual
(6-speed)
Manual
(6-speed)

OIL CAPACITY (in litres)









Engine (with filter replacement)
3.75
5.3














Engines and gearboxes


.../S
: model fitted with the Stop & Start (AS&G) function.

248

Consult your mobile telephone's user manual and enter
the pairing code recorded in step 7 in the telephone.





BLUETOOTH ®
TELEPHONE
WITH VOICE RECOGNITION

The system says " Start the
pairing
procedure on the telephone.
Consult the instructions in the telephone manual
".

If the code is incorrect, the system locks. To clear the code:


- check that the telephone's voice recognition is not activated,

- with the ignition on and the audio system active, press the END
CALL button for 2 seconds, 3 times in succession.


When it detects a Bluetooth
®
compatible mobile telephone, the
system says " Please say the name of the telephone after the
beep
".

After the audible signal, allocate a name to the telephone
by saying the name of your choice.
The system says " Allocate an order of priority between 1 and 7.
One is the highest level of priority
".

Give a number between 1 and 7 to establish the level of
priority of the mobile telephone.

The system says and confi rms the " name of the telephone
" and
the " number
" of its priority.

Answer " Ye s
".
Say " No
" to return to step 13.

The systems says " Pairing complete
" then emits an audible signal
and deactivates the voice recognition.
The services available depend on the network, the SIM card and the compatibility of the Bluetooth
®
telephone used. Check in your telephone user
manual and with your service provider for the services you have access to.

If the system does not detect the Bluetooth
®
compatible mobile
telephone, the matching process stops ands is accompanied by an
audible signal.
If you select a level of priority which has already been allocated to
another telephone, the system asks you if you wish to replace this
level of priority.

301

Level 1


Level 2


Level 3


Comments


Information on the track being played.
Repeat in a loop the track being played.
Play the fi rst 10 seconds of each track.
Play all tracks in random order.
Adjust the audio quality (balance, equaliser, ...).
Select a track or maintain pressure for fast forward or back.
Stop play of the track.
Play or pause the track.
Use the keypad to enter a number then click on the telephone.
Start the call.
Transfer the call from the vehicle to the mobile phone.
Cut the vehicle microphone (the contact no longer hears your voice but stays on hold).
End the call.
Call back the last number.
Select a contact in the vehicle phone book.
Select a contact in the mobile phone book.
Select a contact and press "Edit" to view the numbers.
Select a telephone from the list of connected telephones.
Pair/connect a new telephone.
Delete a telephone from the list of connected telephones.
Register a code used for pairing telephones.
Lock the telephone keypad.
Erase all registered telephones.

331
06

Once the portable player / iPod ®
is
connected, make several successive
presses on the MEDIA
button and
select USB, the source selected is
displayed.
Once the player is selected, play
starts.
Play













Managing a track (or folder)


Stop

Press MEDIA
to change mode or
on RADIO
.
Turn the knob to select a previous or
next track.
Select a folder (or track)

Select a track
Press the knob to select the folder
and go down or up one level.

The knob can also be used for tracks.

USB PLAYER


Press the " 
" or " 
" button to select
the previous or next track respectively.
Press and hold to go faster.
Playing the start of each track

Press the PTY/SCAN
button to start
the play of the fi rst ten seconds of each
track in all folders. "SCAN" appears in
the screen and the corresponding track
number fl ashes.
Press this button again to quit this
mode.