9
WINDSHIELD WIPER AND WASHER SWITCH
Move the lever to the following positions to operate
the windshield wipers:
01 Mist (MIST) – One sweep operation of
the wipers.
02 Intermittent (INT) – Wipers operate
intermittently. The intermittent operation speed
can be adjusted by twisting the time control
ring
03 to increase or decrease wiper speed.
04 Low (LO) – Wipers operate at a continuous,
low speed.
05 High (HI) – Wipers operate at a continuous,
high speed.
06 Pull the lever toward you to activate the washer.
The wipers will operate several times.
WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in
order to replace the wiper blades.
To move the wiper blades to the service position, follow
this procedure:
When the ignition switch is in the ON position or
within 60 seconds of placing the ignition switch
to the OFF position, push the windshield wiper
and washer lever up to the MIST position
01 two
times in less than 0.5 seconds. The windshield wipers will move to the service position
automatically, and the wiper blades can now be replaced.
To move the wiper blades back to the original position:
Pull the windshield wiper and washer lever up for more than 1 second or \
push the lever
down to operate at any wiper speed.
For more information, refer to the “Instruments and controls (section 2)” and the “Maintenance and do-it-yourself
(section 8)” of your Owner’s Manual.
06
01
02
04
05
MIST
Type A (if so equipped) OFF
INT
LO
HI
03
01
02
04
05
MIST
Type B (if so equipped) OFF
INT
LO
HI03
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
