2014 NISSAN SENTRA warning light

[x] Cancel search: warning light

Page 296 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual TIRE PRESSURE MONITORING
SYSTEM (TPMS)
This vehicle is equipped with the Tire Pressure
Monitoring System (TPMS) . It monitors tire pres-
sure of all tires except the spare. When the low
tire pressure

Page 302 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual ●Whenever working on or near a battery,
always wear suitable eye protectors (for
example, goggles or industrial safety
spectacles) and remove rings, metal
bands, or any other jewelry. Do not lean
ov

Page 319 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual Steering wheelCheck for changes in the steer-
ing system, such as excessive freeplay, hard
steering or strange noises.
Warning lights and chimes Make sure all
warning lights and chimes are operating p

Page 327 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual For further brake and clutch fluid specification
information, refer to “Recommended
fluids/lubricants and capacities” in the “Technical
and consumer information” section of this
manual.
WARNIN

Page 336 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual If the brakes do not operate properly, have the
brakes checked by a NISSAN dealer.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The front (and rear– if so equipped) dis

Page 347 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual Use a cloth1to protect the interior light hous-
ing. If you have a flat tire, see “Flat tire” in the
“In case of emergency” section of this
manual.
TIRE PRESSURE
Tire Pressure Monitoring Syst

Page 356 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual Replacing wheels and tires
When replacing a tire, use the same size, tread
design, speed rating and load carrying capacity
as originally equipped. Recommended types and
sizes are shown in “Wheels an

Page 371 of 388

NISSAN SENTRA 2014 B17 / 7.G Owners Manual Use the following steps to mount the front license
plate:
1Make holes on the plastic finisher at the
location mark (small dimple) using a 0.20 in
(5 mm) drill. Apply light pressure to the drill.
Inst