2014 MITSUBISHI MIRAGE audio

5
Comfort controls
Vents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 2
Heater without air conditioning function (if so
equipped) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 6
Manual air conditioning (if so equipped). . . . . . . .5- 11
Automatic air conditioning (if so equipped) . . . . .5- 17
Important air conditioning operating tips . . . . . . .5- 28
Air purifier (if so equipped) . . . . . . . . . . . . . . . . . .5- 29
AM/FM electronically tuned radio with
CD player (if so equipped) . . . . . . . . . . . . . . . . .5- 30
To play tracks from USB device (if so equipped) .5- 43
To play tracks from a Bluetooth
® device
(vehicles with Bluetooth
® 2.0 interface) . . . . . .5- 56
Steering wheel audio remote control switches
(if so equipped) . . . . . . . . . . . . . . . . . . . . . . . . . .5- 59
Error codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 60
Handling of compact discs . . . . . . . . . . . . . . . . . . .5- 62
Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5- 64
General information about your radio . . . . . . . . . .5- 65
BK0162600US.book 1 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-30 Comfort controls
5AM/FM electronically tuned radio with CD
player
(if so equipped)
N00734301075
The audio system can only be used when the ignition switch or
the operation mode is in ON or ACC.NOTE
To listen to the audio system while the engine is not run-
ning, turn the ignition switch to the “ACC” position or put
the operation mode in ACC.

If a cellular phone is used inside the vehicle, it may create
noise in the audio equipment. This does not mean that
anything is wrong with your audio equipment. In such a
case, use the cellular phone at a place as far away as possi-
ble from the audio equipment.

If foreign objects or water get into the audio equipment, or
if smoke or a strange odor comes from it, immediately
turn off the audio system and have it checked at an autho-
rized Mitsubishi Motors dealer or a repair facility of your
choice. Never try to repair it yourself. Avoid using the
audio system until it is inspected by a qualified person.

If the audio system is damaged by foreign objects, water,
or fire, have the system checked by a qualified Mitsubishi
Motors technician.
Volume and tone control panel
N00711900729
To adjust the volume
N00712000411
Turn the VOL knob clockwise to increase the volume; counter-
clockwise to decrease the volume.
The status will be displayed in the display.1- PWR (On-Off) switch
2- VOL (Volume control) knob
3- Display
4-
/MENU (Mode change) button
5- Sound control button
BK0162600US.book 30 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-34 Comfort controls
5
To eject a discWhen the CD eject button is pressed, the disc automatically
stops and is ejected.NOTE
If you do not remove the disc before 15 seconds have
elapsed, the CD player will automatically reload the disc
and stop.To listen to a music CDPress the CD button if a disc is already in the CD player. The
CD player will enter CD mode and start playback. The track
number and the playing time will appear on the display. The
tracks in the disc will be played continuously.To listen to an MP3 CDThis CD player allows you to play MP3 (MPEG Audio Layer-
3) files recorded on CD-ROMs, CD-Rs (recordable CDs), and
CD-RWs (rewritable CDs) in ISO9660 Level 1/Level 2, Joliet,
and Romeo formats. Each disc can hold up to 255 files in up to
100 folders, up to a maximum of 16 levels. The ID3 tag infor-
mation can be displayed during MP3 playback. For informa-
tion concerning ID3 tags, refer to “CD text and MP3 title
display” on page 5-38.
1. Insert a disc containing MP3 files into the slot.
2. Press the CD button if a disc is already in the CD player.
The display shows “READING”, then playback will
begin.
NOTE
While listening to a disc on which CD-DA (CD-Digital
Audio) and MP3 files have both been recorded, you can
switch between reading of the CD-DA, reading of the
MP3 files, and the external audio input mode by pressing
the CD button for 2 seconds or longer (until you hear a
beep).
For information on the external audio input, refer to “To
use the external audio input function” on page 5-42.

With a disc that contains both CD-DA and MP3 files, the
CD-DA files are automatically played first.

The playback sound quality differs depending on the
encoding software and the bit rate. For details, refer to the
user manual of your encoding software.

Depending on file/folder configurations on a disc, it may
take some time before playback starts.

MP3 encode software and writing software are not sup-
plied with this unit.

You may encounter trouble in playing an MP3 or display-
ing the information of MP3 files recorded with certain
writing software or CD recorders (CD-R/RW drivers).

If you record too many folders or files other than MP3
onto a disc, it may take some time before playback starts.

This unit does not record MP3 files.

For information on CD-Rs/RWs, refer to “Notes on CD-
Rs/RWs” on page 5-64.
BK0162600US.book 34 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-39
5
To display the clock
N00702600010
Press the button to switch the clock mode. To exit the clock
mode, press the button.NOTE
While the clock mode is selected, the display will switch
to the applicable operation display whenever the CD
player, external audio input mode or radio, etc. is oper-
ated. Then, if no entries are made for 7 seconds, the dis-
play will automatically return to the clock mode.
To adjust the clock
N00702700011
1. Press and hold the button and the clock display flashes.
2. Press the or button to adjust the “hours” digit.
If you keep pressing the button, fast-forward begins.
3. When the “hours” digit is adjusted, press the button to
flash the “minutes” digit.
Press the or button to adjust the “minutes” digit.
If you keep pressing the button, fast-forward begins.
4. When the time is set, press the button to stop the clock
display from flashing.
A- (Clock) button
CD player mode Clock mode Example
A- (Clock) button
B- (Clock adjustment up) button
C- (Clock adjustment down) button
BK0162600US.book 39 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-42 Comfort controls
5
To use the external audio input function
N00703000011
You can listen to commercially available audio equipment,
such as a portable audio system, from your vehicle’s speakers,
by connecting the audio equipment to the auxiliary audio con-
nector.NOTE
Use a stereo mini-jack connector to connect the audio
equipment to the auxiliary audio connector.
To activate the external audio input mode1. Connect the headphone port of the portable audio system
to the auxiliary audio connector using a commercially
available connection cord.
2. Press the AUX button several times to switch to the AUX
mode. The display will show “AUX” and then the exter-
nal audio input mode will be activated.
3. To deactivate the external audio input mode, press the
AUX button to switch to another mode.
A- Auxiliary Audio connector (Mini-jack)
B- AUX button
C- Display
CAUTION
!
Do not operate the connected audio equipment while
driving.
This could distract you and an accident might occur.
BK0162600US.book 42 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-43
5
NOTE
The connected audio equipment cannot be adjusted using
the vehicle’s audio system.

Depending on the connected audio equipment, it may pro-
duce noise from the speakers.

Use the connected audio equipment’s own power source,
such as its battery.
Noise may be produced from the speakers if the connected
audio equipment is used while charging it using the acces-
sory socket of the vehicle.

Do not activate the external audio input mode when no
audio equipment is connected.
Otherwise, noise may be produced from the speakers.

Connect audio equipment when the external audio input
mode is deactivated or lower the vehicle’s speaker volume
before connecting it.
Noise may be produced from the speakers if audio equip-
ment is connected after the external audio input mode is
activated.

Compared to the CD player mode and radio mode, the
vehicle’s speaker volume will be lower in the external
audio input mode. Therefore, be careful when switching
from the external audio input mode to the CD player mode
or radio mode since the speaker volume will be higher.

Do not use excessive force on the connection cord. Other-
wise, the cord and connectors may be damaged.

If the connection cord alone is left connected to the auxil-
iary audio connector, noise may be produced from the
speakers.

For information on how to connect and operate the com-
mercially available audio equipment, refer to the owner’s
manual for the commercially available audio equipment.
To play tracks from USB device
(if so equipped)
N00762200056
You can connect your iPod or USB memory device to the USB
input terminal and play music files stored in the iPod or USB
memory device.
See the following section for the types of connectable devices
and supported files.
Refer to “Types of connectable devices and supported file
specifications” on page 3-158.
See the following sections for the connecting methods, “How
to connect an iPod” on page 3-156 and “How to connect a USB
memory device” on page 3-154.
If your vehicle is equipped with a Bluetooth
® 2.0 interface,
you can play music files in your iPod or USB memory device
via voice operation.
Refer to “To play iPod tracks via voice operation” on page 5-47
and “To play USB memory device tracks via voice operation”
on page 5-55.
NOTE
A file protected by copyright might not be able to play-
back.

It is recommended to adjust the equalizer of the connected
device to 0 db or neutral.
BK0162600US.book 43 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-44 Comfort controls
5
iPod control panel and display
N00762300060
To play from an iPod
N00762400087
1. Press the PWR switch to turn on the audio system. The
system turns on in the last mode used.
2. Connect your iPod to the USB input terminal.
Refer to “How to connect an iPod” on page 3-156.
3. Press the CD button several times to switch to the iPod
mode. The input mode changes as follows every time the
CD button is pressed: CD mode → iPod mode →Blue-
tooth
® mode (if so equipped) → AUX mode → CD mode.
The iPod indicator are illuminated and then the iPod mode
will be activated.
4. Once the device is selected, playback starts and indica-
tor appears on the display.
NOTE
Depending on the condition of your iPod, it may take a
longer time before the playback starts.
5. To stop the playback, press the RADIO button or CD but-
ton to switch to a different mode.NOTE
Buttons on the iPod are disabled while the iPod is con-
nected to the audio system.

To adjust the volume and tone, refer to “To adjust the vol-
ume” on page 5-30 and “To adjust the tone” on page 5-31.
1- CD (Mode changeover) button
2- RADIO button
3-
DISP (Title display)/ (Return) button
4-
(USB device active) indicator
5- iPod indicator
6- Display
7- TRACK indicator
8- RPT (Repeat mode) indicator
9- RDM (Random mode)/F-RDM (Folder random mode) indi-
cator
10- SEL (Select) indicator
11- PAGE (Title scroll) button
12-
(Fast-reverse/Track down) button
13-
(Fast-forward/Track up) button
14- PWR (On-Off)/SEL (Select) switch
15- RPT (Repeat) button
16- RDM (Random) button
BK0162600US.book 44 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-45
5
To fast-forward/reverse the track
N00762500033
To fast-forward/reverse the current track, press the button
or button.
Fast-forward
To fast-forward the current track, press the button. While
the button is kept pressed, the track will be fast-forwarded.
Fast-reverse
To fast-reverse the current track, press the button. While
the button is kept pressed, the track will be fast-reversed.To select a desired track
N00762600034
Tr a c k u p
Press the button repeatedly until the desired track number
appears on the display.
Tr a c k d o w n
Press the button repeatedly until the desired track number
appears on the display.NOTE
Pressing the button once during the song will cause
the audio system to restart playback from the beginning of
the song.
To find a track from the iPod menu
N00762700077
You can select desired tracks from the “Playlists”, “Artists”,
“Albums”, “Songs” or “Genre” (vehicles with Bluetooth
® 2.0
interface) menus on your iPod.
Operate the SEL switch to select desired tracks.
The selected menu or category or track is shown in the display.
When this mode is activated by pressing the SEL switch, the
SEL indicator will be displayed in the display.
NOTE
To cancel the selection, press the button to return to the
previous step.

If no operation is performed for 10 seconds or more or
other button is operated after the SEL switch has been
pressed, searching of the desired tracks is canceled.

If no operation is performed for 5 seconds or more after
the track is displayed, playback starts.

When the SEL indicator is not shown on the display and
the SEL switch is operated, the volume adjustment is acti-
vated.Press the SEL switch : To start this mode or to select the menu
or category or track.
Turn the SEL switch : To show the menu or category or track.
BK0162600US.book 45 ページ ２０１３年３月２２日　金曜日　午後２時４１分