2014 MERCEDES-BENZ CLA fog light

Problems with the rear window defroster
ProblemPossible causes/consequences and
Solutions
The rear window
defroster has
deactivated
prematurely or cannot
be activated.
The battery has not been sufficiently charged.
XSwitch off any consumers that are not required, e.g. reading
lamps, interior lighting or the seat heating.
When the battery is sufficiently charged, the rear window
defroster can be activated again.
Activating/deactivating air-
recirculation mode
Points to observe before use
You can deactivate the flow of fresh air if
unpleasant odors are enteringthe vehicle
from outside. The air already inside the
vehicle will then be recirculated.
If you switch on air-recirculation mode, the
windows can fog up more quickly, in
particular at low temperatures. Only use air-
recirculation mode briefly to prevent the
windows from fogging up.
The operation of air-recirculation mode is the
same for all control panels.
Activating/deactivating
XTurn the SmartKey to position2in the
ignition lock (Ypage 137).
XTo activate:press thebutton.
The indicator lamp in thebutton lights
up.
iAir-recirculation mode is activated
automatically at high outside
temperatures. When air-recirculation mode
is activated automatically, the indicator
lamp in thebutton is not lit.
Outside air is added after about
30 minutes.
XTo deactivate:press thebutton.
The indicator lamp in thebutton goes
out.
iAir-recirculation mode deactivates
automatically:
Rafter approximately five minutes at
outside temperatures below
approximately 41 ‡ (5 †)
Rafter approximately five minutes if the
"Cooling with air dehumidification"
function is deactivated
Rafter approximately 30 minutes at
outside temperatures above
approximately 41‡(5†) if the "Cooling
with air dehumidification" function is
activated
Activating/deactivating the residual
heat function
The residual heat function is only available in
vehicles for Canada with automatic climate
control.
It is possible to make use of the residual heat
of the engine to continue heating the vehicle
for approximately 30 minutes after the engine
has been switched off. The heating time
depends on the temperature that has been
set.
iThe blower will run at a low speed
regardless of the airflow setting.
iIf you activate the residual heat function
at high temperatures, only the ventilation
will be activated. The blower runs at
medium speed.
Operating the climate control systems131
Climate control

opens. Only once the maneuvering process
has been completed and the rear view camera
has switched off does the flap close again. For
technical reasons, the flap may remain open
briefly after the rear view camera has been
deactivated. If you switch off the engine, the
flap will also close.
iThe text of messages shown in the
COMAND display depends on the language
setting. The following are examples of rear
view camera messages in the COMAND
display.
Observe the notes on cleaning
(Ypage 289).
Important safety notes
The rear view camera is only an aid. It is not
a replacement for your attention to your
immediate surroundings. You are always
responsible for safe maneuvering and
parking. When maneuvering or parking, make
sure that there are no persons, animals or
objects in the area in which you are
maneuvering.
Under the following circumstances, the rear
view camera will not function, or will function
in a limited manner:
Rthe tailgate is open
Rin heavy rain, snow or fog
Rat night or in very dark places
Rif the camera is exposed to very bright light
Rif the area is lit by fluorescent light or LED
lighting (the display may flicker)
Rif there is a sudden change in temperature,
e.g. when driving into a heated garage in
winter
Rif the camera lens is dirty or obstructed
Rif the rear of your vehicle is damaged. In
this event, have the camera position and
setting checked at a qualified specialist
workshop.
Activating/deactivating the rear view
camera
XTo activate:make sure that the SmartKey
is in position2in the ignition lock.
XMake sure that in the audio system/
COMAND, the "Activation by R gear"
function is selected; see the separate
operating instructions for the audio
system/COMAND.
XEngage reverse gear.
Guide lines are used to show the area
behind the vehicle in the Audio/COMAND
display.
To deactivate:the rear view camera is
deactivated if you:
Rselect transmission positionP(vehicles
with automatic transmission)
Rdrive forward ten meters
Rshift the transmission fromRto another
position after 15 seconds
Rdrive forwards at a speed of over5mph
(10 km/h)
Displays in the Audio/COMAND display
The rear view camera may show a distorted
view of obstacles, show them incorrectly or
not at all. The rear view camera does not show
objects in the following positions:
Rvery close to the rear bumper
Runder the rear bumper
Rin the area immediately above the tailgate
handle
!Objects not at ground level may appear to
be further away than they actually are, e.g.:
Rthe bumper of a parked vehicle
Rthe drawbar of a trailer
Rthe ball coupling of a trailer tow hitch
Rthe rear section of an HGV
Ra slanted post
Use the guidelines only for orientation.
Approach objects no further than the
bottom-most guideline.
Driving systems183
Driving and parking
Z

FCC.Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
Monitoring range of the sensors
In particular, the detection of obstacles can
be impaired if:
Rdirt on the sensors or anything else
covering the sensors
Rthere is poor visibility, e.g. due to fog, heavy
rain or snow
Ra narrow vehicle traveling in front, e.g. a
motorbike or bicycle
Rthe road has very wide lanes
Rthe road has narrow lanes
Ryou are not driving in the middle of the lane
Rthere are barriers or similar lane borders
Vehicles in the monitoring range are then not
indicated.
Blind Spot Assist monitors the area up to
10 ft(3.0m)behind your vehicle and directly
nextto your vehicle, as shown in the diagram.
For this purpose, Blind Spot Assist uses radar
sensors in the rear bumper.
If the lanes are narrow, vehicles driving in the
lane beyond the lane next to your vehicle may
be indicated, especially if the vehicles are not
driving in the middle of their lane. This may
be the case if the vehicles are driving on the
inner side of their lane.
Due to the nature of the system:
Rwarnings may be issued in error when
driving close to crash barriers or similar
solid lane borders.
Rwarnings may be interrupted when driving
alongside particularly long vehicles, e.g.
trucks, for a prolonged time.
The two sensors for Blind Spot Assist are
integrated into the sides of the rear bumper.
Make sure that the bumper is free of dirt, ice
or slush in the vicinityofthe sensors. For
example, the radar sensors must not be
covered by bicycle racks or overhanging
loads. Following a severe impact or in the
event of damage to the bumpers, have the
function of the radar sensors checked at a
qualified specialist workshop. Blind Spot
Assist may otherwise not work properly.
Indicator and warning display
Blind Spot Assist is not active at speeds below
approximately 20 mph (30 km/h). Vehicles in
the monitoring range are then not indicated.
Yellow indicator lamp/red warning lamp
When Blind Spot Assist is activated, indicator
lampin the exterior mirrors lights up
yellow at speeds of up to 20 mph(30km/h).
At speeds above 20 mph (30 km/h), the
indicator lamp goes out and Blind Spot Assist
is operational.
If a vehicle is detected withinthe monitoring
range of Blind Spot Assist at speeds above
Driving systems189
Driving and parking
Z

iDepending on your vehicle'sequipment,
when the surround lighting and delayed
switch-offexterior lighting are on, the
following light up:
RParking lamps
RFront fog lamps
RLow-beam headlamps
RDaytime running lamps
RSide marker lamps
RSurround lighting in the exterior mirrors
Activating/deactivating the interior
lighting delayedswitch-off
If you activate theInterior Lighting
Delayfunction, the interior lighting remains
on for 20 seconds after you remove the key
from the ignition lock.
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbuttonto select the
Lightssubmenu.
XPressto confirm.
XPress theorbutton to select the
Interior Lighting Delayfunction.
If theInteriorLightingDelayfunction
has been switched on, the vehicle interior
is displayed in orange in the multifunction
display.
XPress thebutton to save the setting.
Vehicle
Activating/deactivating the automatic
door locking mechanism
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbutton to select the
Vehiclesubmenu.
XPressto confirm.
XPress theorbutton to select the
Automatic Door Lockfunction.
When theAutomaticDoorLockfunction
is activated, the vehicle doors are displayed
in orange in the multifunction display.
XPress thebutton to save the setting.
If you activate theAutomatic Door Lock
function, the vehicle is centrally locked above
a speed of around 9 mph (15 km/h).
For further information on the automatic
locking feature, see (Ypage 79).
Activating/deactivating the acoustic
locking verification signal
If you switch on theAcousticLockfunction,
an acoustic signal sounds when you lock the
vehicle.
XPress theorbutton on the
steering wheel to select theSettings
menu.
XPress theorbutton to select the
Vehiclesubmenu.
XPressto confirm.
XPress theorbutton to select the
Acoustic Lockfunction.
If theAcousticLockfunction is activated,
the\nsymbol in the multifunction
display lights up orange.
XPress thebutton to save the setting.
Activating/deactivating the radar sensor
system
XPress theorbutton on the
steering wheel to select theSettmenu.
XPress theorbutton to select the
Vehiclesubmenu.
XPressto confirm.
XPress theorbutton to select
Radar Sensor (See Oper. Manual).
You will see the selected setting:Onor
Off.
XPress thebutton to save the setting.
208Menus and submenus
On-board computer and displays

Display messagesPossible causes/consequences and
Solutions

License Plate Lamp
The leftorright-hand license plate lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Check Left Fog
LamporCheck
Right Fog Lamp
The left-hand or right-hand front fog lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

CheckRearFogLamp
The rear fog lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Check Front Left
Parking lampor
Check Front Right
Parking Lamp
The front left or front right parking or standing lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Backup Light
The backup lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Check Left Tail
LamporCheck
Right Tail Lamp
The left or right-hand tail lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Check Front Left
Sidemarker Lampor
Check Front Right
Sidemarker Lamp
The left or right front side marker lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.
Display messages225
On-board computer and displays
Z

Display messagesPossible causes/consequences and
Solutions

Check Rear Left
Sidemarker Lampor
Check Rear Right
Sidemarker Lamp
The rear leftorright side marker lamp is defective.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

CheckLeftDaytime
Running Lightor
Check Right
Daytime Running
Light
The left-hand or right-hand daytime running lamp is faulty.
XCheck whether you are permitted to replace the bulb yourself
(Ypage 111).
or
XVisit a qualified specialist workshop.

Active Light
System Inoperative
The active light function is defective.
XVisit a qualified specialist workshop.

Malfunction See
Operator's Manual
The exterior lighting is defective.
XVisit a qualified specialist workshop.

AutoLampFunction
Inoperative
The light sensor is defective.
XVisit a qualified specialist workshop.

Switch Off Lights
The lights are still switched on when you leave the vehicle. A
warning tone also sounds.
XTurn the light switch to.
Adaptive Highbeam
Assist Inoperative
Adaptive Highbeam Assist is faulty.
XVisit a qualified specialist workshop.
Adaptive Highbeam
Assist Currently
Unavailable See
Operator's Manual
Adaptive Highbeam Assist is deactivated and temporarily
inoperative. Possible causes are:
Rthe windshield in the camera's field of vision is dirty.
Rvisibility is impaired due to heavy rain, snow or fog.
XClean the windshield.
If the system detects that the camera is fully operational again,
theAdaptive Highbeam Assist Now Availablemessage is
displayed.
Adaptive Highbeam Assist is operational again.
226Display messages
On-board computer and displays