2014 MERCEDES-BENZ C-Class SEDAN towing capacity

Average weight of the vehicle
occupants (definition)
....................335
Bar (definition) ............................... 335
Changing awheel .......................... 338
Characteristics .............................. 335
Checking ........................................ 315
Definition of terms .........................335
Direction of rotatio n...................... 338
Display message ............................ 242
Distributio nofthe vehicle
occupants (definition) ....................337
DOT, Tire Identification Number
(TIN) .............................................. .334
DOT (Department of
Transportation) (definition) ............335
GAWR (Gross Axle Weight Rating)
(definition) ..................................... 336
GVW (Gross Vehicle Weight)
(definition) ..................................... 336
GVWR (Gross Vehicle Weight
Rating) (definition) .........................336
Important safety notes ..................314
Increased vehicle weight due to
optional equipment (definition) ......335
Kilopascal (kPa) (definition) ...........336
Labeling (overview )........................ 331
Load bearing index (definition) ......337
Load index ..................................... 334
Load index (definition) ...................336
M+S tires ....................................... 316
Maximum loaded vehicle weight
(definition) ..................................... 336
Maximum load on a tire (definition) 336
Maximum permissible tire
pressure (definition) ....................... 336
Maximum tire loa d......................... 329
Maximum tire load (definition) .......336
MOExtended tires ..........................301
Optional equipment weight
(definition) ..................................... 337
PSI (pounds per square inch)
(definition) ..................................... 336
Replacing ....................................... 338
Service life ..................................... 316
Sidewall (definition) .......................337
Speed rating (definition) ................336
Storing ........................................... 338Structure and characteristics
(definition)
..................................... 335
Summer tires ................................. 316
Temperature .................................. 331
TIN (Tire Identification Number)
(definition) ..................................... 337
Tire bea d(definition) ...................... 337
Tire pressure (definition) ................337
Tire pressures (recommended )...... 335
Tire size (data) ............................... 342
Tire size designation, load-bearing
capacity, speed rating .................... 332
Tire tread ....................................... 315
Tire tread (definition) .....................337
Total load limit (definition) .............337
Traction ......................................... 330
Traction (definition) .......................337
Trea dwear ..................................... 330
Uniform Tire Quality Grading
Standard s...................................... 330
Uniform Tire Quality Grading
Standard s(definition) .................... 335
Unladen weight (definition) ............336
Wea rindicato r(definition) .............337
Whee lrim (definition ).................... 335
see Flat tire
Top Tether ............................................ 63
Towing Important safety guidelines ...........308
Installing the towing eye ................309
Removing the towing eye. ..............309
With the rear axle raised ................309
Towing away
With both axles on the ground .......309
Tow-starting
Emergency engine starting ............310
Important safety notes ..................308
Transfer case ..................................... 161
Transmission see Automatic transmission
Transporting the vehicle ..................310
Trim pieces (cleaning instructions) .296
Trip computer (on-board computer) 207
Trip odometer Calling up ....................................... 207
Resetting (on-board computer) ......208 18
Index

R
Lug wrench
R Towing eye Flat tire
Preparing the vehicle
Yourv ehicle may be equipped with:
R MOExtended tires (tires with run-flat
properties) (Y page 301)
Vehicle preparation is not necessary on
vehicles with MOExtended tires.
R a "Minispare" emergency spare wheel
R an emergency spare wheel (only for certain
countries) (Y page 346)
Information on changing/mounting a wheel
(Y page 338).
X Stop the vehicle on solid, non-slippery and
level ground, as far away as possible from
traffic.
X Switch on the hazard warning lamps.
X Secure the vehicle against rolling away
(Y page 164).
X If possible, bring the fron twheels into the
straight-ahead position.
X Switch off the engine.
X Vehicles without KEYLESS-GO: remove
the SmartKey from the ignition lock.
X Vehicles with KEYLESS-GO: open the
driver's door.
The on-board electronics have status 0,
which is the same as the SmartKey having
been removed.
X Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock
(Y page 148).
X All occupants must get out of the vehicle.
Make sure that they are not endangered as
they do so.
X Make sure that no one is near the danger
area while a wheel is being changed.
Anyone who is not directly assisting in the
wheel change should, for example, stand
behind the barrier. X
Get out of the vehicle. Pay attention to
traffic conditions when doing so.
X Close the driver's door. MOExtended tires (tires with run-flat
properties)
General notes With MOExtended tires (tires with run flat
characteristics), you can continue to drive
your vehicle even if there is a total loss of
pressure in one or more tires. The affected
tire must not show any clearly visible damage.
You can recognize MOExtended tires by the
MOExtended marking which appears on the
sidewall of the tire. You will find this marking
next to the tire size designation, the load-
bearing capacity and the speed index
(Y
page 332).
MOExtended tires may only be used in
conjunction with an active tire pressure loss
warning system or with an active tire pressure
monitor.
If the pressure loss warning message
appears in the multifunction display:
R Observe the instructions in the display
messages (Y page 242).
R Check the tire for damage.
R If driving on, observe the following notes.
The maximum driving distance is
approximately 50 miles (80 km) when the
vehicle is partially laden and approximately
18 miles (30 km) when the vehicle is fully
laden.
In addition to the vehicle load, the driving
distance possible depends upon:
R Speed
R Road condition
R Outside temperature
The driving distance possible in run-flat mode
may be reduced by extreme driving
conditions/maneuvers, or it can be increased
through a moderate style of driving. Flat tire
301Breakdown assistance

Number of seats
i The specifications shown on the Tire and
Loading Information placard in the
illustratio nare examples. The number of
seats is vehicle-specific and can differ from
the details shown. The number of seats in
yourv ehicle can be found on the Tire and
Loading Information placard. Maximum number of seats
0002indicates the
maximum number of occupants allowed to
travel in the vehicle. This information can be
found on the Tire and Loading Information
placard. Determining the correct load limit
Step-by-step instructions The following steps have been developed as
required of all manufacturers under Title 49,
Code of U.S.F ederal Regulations, Part 575
pursuant to the "National Traffic and Motor
Vehicle Safety Act of 1966".
X Step 1: Locate the statement "The
combined weight of occupants and cargo
should never exceed XXX kg or XXX lbs." on
your vehicle’s Tire and Loading Information
placard.
X Step 2: Determine the combined weight of
the driver and passengers that will be riding
in your vehicle.
X Step 3: Subtract the combined weight of
the driver and passengers from XXX
kilograms or XXX lbs. X
Step 4: The resulting figure equals the
available amount of cargo and luggage load
capacity. For example, if the "XXX" amount
equals 1400l bs and there will be five
150 lbs passengers in your vehicle, the
amount of available cargo and luggage load
capacity is 650 lbs (1 400 - 750 (5 x 150)
= 650 lbs).
X Step 5: Determine the combined weight of
luggage and cargo being loaded on the
vehicle. That weight may not safely exceed
the available cargo and luggage load
capacity calculated in step 4.
X Step 6 (if applicable): If your vehicle will
be towing a trailer, load from your trailer
will be transferred to your vehicle. Refer to
this Operator's Manual to determine how
this reduces the available cargo and
luggage load capacity of your vehicle
(Y page 329). Loading the vehicle
327Wheels and tires Z