2014 MAZDA MODEL 6 engine

Black plate (16,1)
CAUTION
ØWhen operating a seat, be careful not to put your hands or fingers near the
moving parts of the seat or on the side trim to prevent injury.
ØWhen moving the seats, make sure there is no cargo in the surrounding area. If
the cargo gets caught it could damage the cargo.
Ø(Manual Seat)
When returning a rear-reclined seatback to its upright position, make sure you
hold onto the seatback with your other hand while operating the lever. If the
seatback is not supported, it will flip forward suddenly and could cause injury.
Ø(Power Seat)
The seat-bottom power adjustment is operated by motors. Avoid extended
operation because excessive use can damage the motors.
ØTo prevent the battery from running down, avoid using the power adjustment
when the engine is stopped. The adjuster uses a large amount of electrical
power.
ØDo not use the switch to make more than one adjustment at a time.
NOTE
When returning a rear seat to its original position, also replace the seat belt to its normal position.
Verify that the seat belt pulls out and retracts.
2-4
Essential Safety Equipment
Seats
Mazda6_8DQ8-EA-13L_Edition3 Page16
Friday, June 13 2014 6:20 PM
Form No.8DQ8-EA-13L

Black plate (20,1)
NOTElIf the ignition is switched off while the seat
warmer is operating (High, Mid or Low)
and then switched ON again, the seat
warmer will automatically operate at the
temperature set before switching off the
ignition.
lUse the seat warmer when the engine is
running. Leaving the seat warmer on for
long periods with the engine not running
could cause the battery power to be
depleted.
lThe temperature of the seat warmer cannot
be adjusted beyond High, Mid and Low
because the seat warmer is controlled by a
thermostat.
qSeat Position Memory (Driver's
seat)í
The seat position memory function allows
you to program the driver's seat to a
desired seat position and to call up a
programmed position with the simple
touch of a button.
CAUTION
Do not place fingers or hands around
the bottom of the seat while the seat
memory function is operating. The
seat moves automatically while the
seat memory function is operating
and fingers or hands could get
pinched and injured.
SET button
The seat position can be programmed or
operated using the following operations.
lOperation of the buttons on the side of
the seat.
lOperation using the key.
NOTE
lIndividual seat positions can be
programmed to the two available
programming buttons on the side of the
driver's seat, plus one seat position for each
registered key.
lIf the vehicle has been serviced and the
battery cables disconnected, the
programmed seat positions will have been
erased. Re-program the seat positions.
Programming
1. Switch the ignition OFF.
2. Adjust the seat to the desired position
using the slide lifter and reclining
switches.
Refer to Seat Operation on page 2-5.
3. Press and hold the memory SET button
until a beep sound is heard.
2-8
Essential Safety Equipment
íSome models.
Seats
Mazda6_8DQ8-EA-13L_Edition3 Page20
Friday, June 13 2014 6:20 PM
Form No.8DQ8-EA-13L

Black plate (73,1)
3Before Driving
Use of various features, including keys, doors, mirrors and windows.
Keys .......................................................... 3-2
Keys .................................................... 3-2
Keyless Entry System ......................... 3-3
Advanced Keyless Entry System ............ 3-9
Advanced Keyless Entry System
í..... 3-9
Operational Range ............................ 3-10
Doors and Locks .................................... 3-11
Door Locks ....................................... 3-11
Trunk Lid .......................................... 3-19
Inside Trunk Release Lever
í............ 3-22
Fuel and Emission ................................. 3-24
Fuel and Engine Exhaust
Precautions ........................................ 3-24
Fuel-Filler Lid and Cap ..................... 3-27
Steering Wheel ....................................... 3-29
Steering Wheel .................................. 3-29
Mirrors ................................................... 3-30
Mirrors .............................................. 3-30
Windows ................................................. 3-33
Power Windows ................................ 3-33
Moonroof
í....................................... 3-38
Security System ..................................... 3-41
Modification and Add-On
Equipment ......................................... 3-41
Immobilizer System .......................... 3-41
Theft-Deterrent System
í.................. 3-43Driving Tips ........................................... 3-45
Break-In Period ................................. 3-45
Money-Saving Suggestions .............. 3-45
Hazardous Driving ............................ 3-46
Floor Mat .......................................... 3-46
Rocking the Vehicle .......................... 3-47
Winter Driving .................................. 3-47
Driving In Flooded Area ................... 3-49
Overloading ...................................... 3-49
Driving on Uneven Road .................. 3-50
Towing .................................................... 3-51
Trailer Towing ................................... 3-51
Recreational Towing ......................... 3-51
3-1íSome models.
Mazda6_8DQ8-EA-13L_Edition3 Page73
Friday, June 13 2014 6:21 PM
Form No.8DQ8-EA-13L

Black plate (75,1)
A code number is stamped on the plate
attached to the key set; detach this plate
and store it in a safe place (not in the
vehicle) for use if you need to make a
replacement key (auxiliary key).
Also write down the code number and
keep it in a separate safe and convenient
place, but not in the vehicle.
If your key (auxiliary key) is lost, consult
your Authorized Mazda Dealer and have
your code number ready.
NOTE
The driver must carry the key to ensure the
system functions properly.
Operation indicator light
Auxiliary key Transmitter
Key code number plate
Pull out the auxiliary key from the key
(transmitter).
Keyless Entry System
This system uses the key buttons to
remotely lock and unlock the doors and
the trunk lid, and opens the trunk lid.
The system can start the engine without
having to take the key out of your purse
or pocket.
It can also help you signal for attention.
Operating the theft-deterrent system is
also possible on theft-deterrent system-
equipped vehicles.
Press the buttons slowly and carefully.
System malfunctions or warnings are
indicated by the following warning lights
or beeps.
For vehicles with the type A instrument
cluster, check the displayed message for
more information and, if necessary, have
the vehicle inspected at an Authorized
Mazda Dealer, according to the indication.
lKEY Warning Light (Red)
Refer to Warning/Indicator Lights on
page 4-23.
lIgnition Not Switched Off (STOP)
Warning Beep
Refer to Ignition Not Switched Off
(STOP) Warning Beep on page 7-39.
lKey Removed from Vehicle Warning
Beep
Refer to Key Removed from Vehicle
Warning Beep on page 7-40.
If you have a problem with the key,
consult an Authorized Mazda Dealer.
If your key is lost or stolen, consult an
Authorized Mazda Dealer as soon as
possible for a replacement and to make
the lost or stolen key inoperative.
Before Driving
Keys
3-3
Mazda6_8DQ8-EA-13L_Edition3 Page75
Friday, June 13 2014 6:21 PM
Form No.8DQ8-EA-13L

Black plate (79,1)
qOperational Range
The system operates only when the driver
is in the vehicle or within operational
range while the key is being carried.
Starting the Engine
NOTE
lStarting the engine may be possible even if
the key is outside of the vehicle and
extremely close to a door and window,
however, always start the engine from the
driver's seat.
If the vehicle is started and the key is not in
the vehicle, the vehicle will not restart after
it is shut off and the push button start is
switched to off.
lThe trunk is out of the assured operational
range, however, if the key (transmitter) is
operable the engine will start.
With the advanced keyless function
Interior antenna
Operational range
Without the advanced keyless function
Interior antenna
Operational range
NOTE
The engine may not start if the key is placed in
the following areas:
lAround the dashboardlIn the storage compartments such as the
glove compartment
lOn the rear parcel shelf
qKey Suspend Function
If a key is left in the vehicle, the functions
of the key left in the vehicle are
temporarily suspended to prevent theft of
the vehicle.
The following are inoperable:
lStarting the engine using the push
button start.
l(With the advanced keyless function)
Operating the request switches.
To restore these functions, perform any
one of the following:
lPress a button on the key which has
had its functions temporarily
suspended.
Before Driving
Keys
3-7
Mazda6_8DQ8-EA-13L_Edition3 Page79
Friday, June 13 2014 6:21 PM
Form No.8DQ8-EA-13L

Black plate (81,1)
Advanced Keyless Entry
System
í
WARNING
Radio waves from the key may affect
medical devices such as pacemakers:
Before using the key near people who
use medical devices, ask the medical
device manufacturer or your
physician if radio waves from the key
will affect the device.
The advanced keyless function allows you
to lock/unlock the doors and trunk lid, or
open the trunk lid while carrying the key
without using the key.
System malfunctions or warnings are
indicated by the following warning beeps.
lRequest switch Inoperable Warning
Beep
Refer to Request Switch Inoperable
Warning Beep (With the advanced
keyless function) on page 7-40.
lKey Left-in-Trunk Warning Beep
Refer to Key Left-in-trunk Warning
Beep (With the advanced keyless
function) on page 7-40.
lKey Left-in-vehicle Warning Beep
Refer to Key Left-in-vehicle Warning
Beep (With the advanced keyless
function) on page 7-40.NOTE
The advanced keyless entry system functions
can be deactivated to prevent any possible
adverse effect on a user wearing a pacemaker
or other medical device. If the system is
deactivated, you will be unable to start the
engine by carrying the key. Consult an
Authorized Mazda Dealer for details. If the
advanced keyless entry system has been
deactivated, you can start the engine by
following the procedure indicated when the key
battery goes dead.
Refer to Engine Start Function When Key
Battery is Dead on page 4-6.
Before Driving
Advanced Keyless Entry System
3-9íSome models. Mazda6_8DQ8-EA-13L_Edition3 Page81
Friday, June 13 2014 6:21 PM
Form No.8DQ8-EA-13L

Black plate (92,1)
CAUTION
ØBefore opening the trunk lid,
remove any snow and ice
accumulation on it. Otherwise, the
trunk lid could close under the
weight of the snow and ice
resulting in injury.
ØBe careful when opening/closing
the trunk lid during strong winds.
If a strong gust blows against the
trunk lid, it could close suddenly
resulting in injury.
ØFully open the trunk lid and make
sure that it stays open. If the trunk
lid is only opened partially, it
could slam shut by vibration or
wind gusts resulting in injury.
ØWhen loading or unloading
luggage in the trunk, turn off the
engine. Otherwise, you could get
burned by the heat of the exhaust
gas.
qOpening and Closing the Trunk Lid
Opening the trunk lid with Electric
trunk lid opener (With the advanced
keyless function)
A locked trunk lid can also be opened
while the key is being carried.
Press the electric trunk lid opener on the
trunk lid, and then raise the trunk lid when
the latch releases.
Electric trunk lid
opener
NOTElWhen opening the trunk lid with the doors
and the trunk lid locked, it may require a
few seconds for the trunk lid latch to
release after the electric trunk lid opener is
pressed.
lThe trunk lid can be closed when the doors
are locked with the key left in the vehicle.
However, to prevent leaving the key in the
vehicle, the trunk lid can be opened by
pressing the electric trunk lid opener. If the
trunk lid cannot be opened despite doing
this procedure, press the electric trunk lid
opener to fully open the trunk lid after
pushing the trunk lid completely closed.
3-20
Before Driving
Doors and Locks
Mazda6_8DQ8-EA-13L_Edition3 Page92
Friday, June 13 2014 6:21 PM
Form No.8DQ8-EA-13L

Black plate (93,1)
Opening the trunk lid with the remote
release button
Push the remote release button.
NOTE
If the vehicle battery is dead or there is a
malfunction in the electrical system and the
trunk lid cannot be unlocked, the trunk lid can
be opened by performing the emergency
procedure.
Refer to When Trunk Lid Cannot be Opened on
page 7-42.
Closing the trunk lid
To close, lower the trunk lid slowly using
the trunk lid grip recess, and then push the
trunk lid closed using both hands.
Do not slam it. Pull up on the trunk lid to
make sure it is secure.
Trunk lid grip recess
qTrunk Light
The trunk light is on when the lid is open
and off when it's closed.
NOTE
To prevent the battery from being discharged,
do not leave the trunk open for a long period
when the engine is not running.
Before Driving
Doors and Locks
3-21
Mazda6_8DQ8-EA-13L_Edition3 Page93
Friday, June 13 2014 6:21 PM
Form No.8DQ8-EA-13L