2014 MAZDA MODEL 3 5-DOOR turn signal bulb

4–38
When Driving
Switches and Controls
Turn and Lane-Change
Signals
The ignition must be switched ON to use
the turn and lane-change signals.
Turn Signals
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will self-cancel after
the turn is completed.
If the indicator light continues to fl ash
after a turn, manually return the lever to its
original position.
Right tur n
Left tur n
Right lane change
Left lane change OFF
The turn signal indicators (green) in the
instrument cluster fl ash according to the
operation of the turn signal lever to show
which signal is working.
NOTE
 y
 If an indicator light stays on without
fl ashing or if it fl ashes abnormally, one
of the turn signal bulbs may be burned
out.
 y A personalized function is available to
change the turn indicator sound volume.
(page 9-10 )
Lane-Change Signals
Move the lever halfway toward the
direction of the lane change—until the
indicator fl ashes— and hold it there. It will
return to the off position when released.
Three-Flash Turn Signal
To signal a lane change, operate the turn
signal lever up or down slightly and
release. After releasing the lever, the turn
signal indicator fl ashes three times.
NOTE
The three-fl ash turn signal function can be
switched to operable/inoperable using the
personalization function.
Refer to Personalization Features on page
9-10 .
.B[EB@%$&""@&EJUJPOJOEC







*Some models.6–48
Maintenance and Care
Owner Maintenance
Front turn signal lights, Parking lights/
Front side-marker lights
1. If you are changing the right bulb, start the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right, and turn
off engine.
2. Make sure the headlight switch is off.
3. Pull the center of each plastic retainer and remove the retainers.
R e m ov a l
In s t allat ion
4. Turn the screw counterclockwise and remove it, and then partially peel back
the mudguard.
5. Turn the socket and bulb assembly counterclockwise and remove it. 6. Disconnect the bulb from the socket.
Front turn signal lights
Parking lights/Front side-marker
lights
7. Install the new bulb in the reverse order of the removal procedure.
.B[EB@%$&""@&EJUJPOJOEC







*Some models.6–50
Maintenance and Care
Owner Maintenance
Side turn signal lights * , High-mount
brake light
Due to the complexity and diffi culty of
the procedure, the LED bulbs must be
replaced by an Authorized Mazda Dealer.
NOTE
LED bulb replacement is not possible
because it is built into the unit. Replace
the unit.
Rear turn signal lights, Brake lights/
Taillights/Rear side-marker lights
4–Door
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Pull the center of each plastic retainer and remove the retainers.
3. Remove trunk end trim.
Inst a lla t ion R em ov a l
4. Pull the center of each plastic retainer
and remove the retainers. 5. Peel back the trunk side trim.
R e m ov a l
In s t a lla t ion
6. Turn the socket and bulb assembly counterclockwise and remove it.
7. Disconnect the bulb from the socket.
Rear turn signal lights
.B[EB@%$&""@&EJUJPOJOEC







6–51
Maintenance and Care
Owner Maintenance
Brake lights/Taillights/Rear side-marker lights
8. Install the new bulb in the reverse order of the removal procedure.
5–Door
(Left side)
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Remove the cover.
3. Turn the socket and bulb assembly counterclockwise and remove it. 4. Disconnect the bulb from the socket.
Rear turn signal lights
Brake lights/Taillights/Rear side-
marker lights
5. Install the new bulb in the reverse order of the removal procedure.
6. Insert the cover tabs and install the cover.
NOTE
Verify that the cover is securely installed.
.B[EB@%$&""@&EJUJPOJOEC







6–52
Maintenance and Care
Owner Maintenance
(Right side)
1. Make sure the ignition is switched off, and the headlight switch is off.
2. Turn the knob and remove the cover.
3. Turn the wing bolt and jack screw counterclockwise.
4. Remove the jack
5. Turn the socket and bulb assembly counterclockwise and remove it. 6. Disconnect the bulb from the socket.
Rear turn signal lights
Brake lights/Taillights/Rear side-
marker lights
7. Install the new bulb.
8. Insert the wing bolt into the jack with the jack screw pointing to the down
and turn the wing bolt clockwise to
temporarily tighten it.
.B[EB@%$&""@&EJUJPOJOEC







*Some models.9–8
Specifi cations
Specifi cations
Light Bulbs
Exterior light
Light bulb Category
Wattage ECE R (SAE)
Headlights High beam 65
HB3 (9005)
Low beam 55 H11 (H11)
Daytime running lights 65 HB3 (9005)
Parking lights (Front side-marker lights) 5 WY5W (—)
Front turn signal lights 21 WY21W (7443NA)
Fog lights
* 55 H11 (H11)
Side turn signal lights * LED *1 — (—)
High-mount brake light LED *1 — (—)
Rear turn signal lights 21 WY21W (7443NA)
Brake lights/Taillights/Rear side-marker light 21/5 W21/5W (7443)
Reverse lights 4-Door
18 W16W (921)
5-Door 21 W21W (7440)
License plate lights 5 W5W (—)
*1 LED is the abbreviation for Light Emitting Diode.
Interior light
Light bulb Category
Wattage ECE R
Trunk light (4-Door) 3 —
Luggage compartment light (5-Door) 5 —
Overhead lights (Front)/Map lights
* 8 —
Overhead light (Front) * 10 —
Overhead light (Rear) * 10 —
Vanity mirror lights * 2 —
.B[EB@%$&""@&EJUJPOJOEC







10–4
Index
Fuel Filler lid and cap............................ 3-30
Gauge ............................................ 4-12
Requirements................................. 3-27
Tank capacity .................................. 9-5
Fuel Consumption Display ................. 4-55
Fuel Economy Monitor ....................... 4-54 Ending screen display ................... 4-55
Fuel consumption display ............. 4-55
G
Gauges ................................................... 4-9
Glove Compartment .......................... 5-136
H
Hazard Warning Flasher ...................... 4-45
Hazardous Driving .............................. 3-46
Head Restraint ..................................... 2-10
Headlights Control........................................... 4-33
Flashing ......................................... 4-36
High-low beam .............................. 4-36
Hill Launch Assist (HLA) ................... 4-48
Hood Release ...................................... 6-24
Horn .................................................... 4-44
I
If a Warning Light Turns On or
Flashes................................................. 7-24
Ignition Switch .............................................. 4-2
Ignition not switched off (STOP) warning
beep ..................................................... 7-35
Immobilizer System ............................ 3-41
Indicator Lights ................................... 4-19
BSM OFF ...................................... 4-71
Low engine coolant temperature ... 4-20
Wrench .......................................... 4-20
Inside Trunk Release Lever ................ 3-25
Inspecting Brake/Clutch Fluid Level ... 6-31 Inspecting Coolant Level .................... 6-29
Inspecting Engine Oil Level ............... 6-28
Inspecting Washer Fluid Level............ 6-31
Interior Care ........................................ 6-69
Cleaning the Lap/Shoulder Belt
Webbing ........................................ 6-71
Cleaning the Upholstery and Interior
Trim ............................................... 6-69
Cleaning the Window Interiors ..... 6-71
Dashboard Precautions .................. 6-69
Interior Lights ................................... 5-130 Luggage Compartment Light ...... 5-130
Map Lights .................................. 5-130
Overhead Lights .......................... 5-130
J
Jack ....................................................... 7-4
Jump-Starting ...................................... 7-15
K
Key removed from vehicle warning
beep ..................................................... 7-35
Key Suspend Function .......................... 3-8
Key left-in-luggage compartment warning
beep (With the advanced keyless
function) .............................................. 7-35
Key left-in-vehicle warning beep (With
the advanced keyless function) ........... 7-36
Keyless Entry System ........................... 3-3
Keys ...................................................... 3-2 Key suspend function ...................... 3-8
Transmitter ...................................... 3-4
L
Label Information ................................. 9-2
Lane-Change Signals .......................... 4-38
Liftgate ................................................ 3-20
Light Bulbs Replacement .................................. 6-45
Specifi cations .................................. 9-8
.B[EB@%$&""@&EJUJPOJOEC