Page 587 of 652

5
587
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
If the engine will not start
If the engine will not start even though correct starting procedures are
being followed (→P. 180), consider each of the following points.
■The engine will not start, even though the starter motor operates
normally.
One of the following may be the cause of the problem:
●There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
●The engine may be flooded.
Try to restart the engine again following correct starting proce-
dures. (→P. 1 8 0 )
●There may be a malfunction in the engine immobilizer system.
(→P. 115)
■The starter motor turns over slowly, the interior lights and head-
lights are dim, or the horn does not sound or sounds at a low vol-
ume.
One of the following may be the cause of the problem:
●The battery may be discharged. (→P. 5 9 4 )
●The battery terminal connections may be loose or corroded.
■The starter motor does not turn over.
The engine starting system may be malfunctioning due to an electri-
cal problem such as an open circuit or a blown fuse. However, an
interim measure is available to start the engine. (→P. 588)
RX350_270_EE_48D77E.book 587 ページ 2014年1月24日 金曜日 午前10時4分
Page 588 of 652

588
5-2. Steps to take in an emergency
RX350/270_EE
Emergency start function
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the “ENGINE START STOP” switch
is functioning normally:
Set the parking brake.
Shift the shift lever to P.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch for about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may
be malfunctioning. Have the vehicle checked by any authorized Lexus
dealer or repairer, or another duly qualified and equipped professional.
■The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
●One or both of the battery terminals may be disconnected.
●The battery may be discharged. (→P. 5 9 4 )
●There may be a malfunction in the steering lock system.
Contact any authorized Lexus dealer or repairer, or another duly quali-
fied and equipped professional if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP2
STEP3
STEP4
RX350_270_EE_48D77E.book 588 ページ 2014年1月24日 金曜日 午前10時4分
Page 591 of 652
5
591
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
If the electronic key does not operate properly
Locking and unlocking the side doors and key linked functions
Use the mechanical key (→P. 2 7 )
in order to perform the following
operations (driver’s door only):
Locks all the doors
Closes the windows and moon
roof (turn and hold)
Unlocks all the doors
For some models:
An alarm will sound if the alarm is
set. (→P. 122)
Opens the windows and moon
roof (turn and hold)
If communication between the electronic key and vehicle is interrupted
(→P. 37) or the electronic key cannot be used because the battery is
depleted, the smart entry & start system and wireless remote control can-
not be used. In such cases, the doors can be opened and the engine can be
started by following the procedure below.
RX350_270_EE_48D77E.book 591 ページ 2014年1月24日 金曜日 午前10時4分
Page 593 of 652
5
593
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
■Stopping the engine
Shift the shift lever to P and press the “ENGINE START STOP” switch as you nor-
mally do when stopping the engine.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted.
(→P. 5 0 1 )
■Alarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the
alarm may be triggered. (→P. 1 2 2 )
■Changing “ENGINE START STOP” switch modes
Within 10 seconds of the buzzer sounding, release the brake pedal and press the
“ENGINE START STOP” switch.
The engine does not start and modes will be changed each time the switch is
pressed. (→P. 1 8 1 )
RX350_270_EE_48D77E.book 593 ページ 2014年1月24日 金曜日 午前10時4分
Page 594 of 652
594
5-2. Steps to take in an emergency
RX350/270_EE
If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s
battery is discharged.
You can also call any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
If you have a set of jumper (or booster) cables and a second vehicle
with a battery, you can jump start your vehicle by following the steps
below.
Open the hood. Remove the battery cover. (→P. 4 7 1 )
RX270
STEP1
STEP2
RX350_270_EE_48D77E.book 594 ページ 2014年1月24日 金曜日 午前10時4分
Page 595 of 652

5
595
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
RX350
Connect the jumper cables according to the following procedure:
Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
Connect a positive jumper cable clamp to the positive (+) battery
terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery terminal
on the second vehicle.
Connect the clamp at the other end of the negative cable to a solid,
stationary, unpainted metallic point away from the battery and any
moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain that level for approximately 5 min-
utes to recharge the battery of your vehicle.
Open and close any of the doors with the “ENGINE START
STOP” switch off.
Maintain the engine speed of the second vehicle and start the
engine of your vehicle by turning the “ENGINE START STOP”
switch to IGNITION ON mode.
STEP2
STEP3
STEP4
STEP5
RX350_270_EE_48D77E.book 595 ページ 2014年1月24日 金曜日 午前10時4分
Page 596 of 652

596
5-2. Steps to take in an emergency
RX350/270_EE
■Starting the engine when the battery is discharged
The engine cannot be started by push-starting.
■To prevent battery discharge
●Turn off the headlights and the audio system while the engine is off.
●Turn off any unnecessary electrical components when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.
■When the battery is removed or discharged
●The power back door must be initialized. (if equipped) (→P. 6 3 3 )
●Make sure that the key is not inside the vehicle when recharging or replacing
the battery. The key may be locked in the vehicle if the alarm is activated.
(→P. 1 2 5 )
■Charging the battery
The electricity stored in the battery will discharge gradually even when the vehi-
cle is not in use, due to natural discharge and the draining effects of certain
electrical appliances. If the vehicle is left for a long time, the battery may dis-
charge, and the engine may be unable to start. (The battery recharges automat-
ically during driving.)
Once the vehicle’s engine has started, remove the jumper
cables in the exact reverse order from which they were con-
nected.
Once the engine starts, have the vehicle inspected at any authorized
Lexus dealer or repairer, or another duly qualified and equipped pro-
fessional as soon as possible.STEP6
RX350_270_EE_48D77E.book 596 ページ 2014年1月24日 金曜日 午前10時4分
Page 597 of 652

5
597
5-2. Steps to take in an emergency
When trouble arises
RX350/270_EE
CAUTION
■Avoiding battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flammable
gas that may be emitted from the battery:
●Make sure each jumper cable is connected to the correct terminal and that it is
not unintentionally in contact with any other than the intended terminal.
●Do not allow the + and - clamps of the jumper cables to come into contact with
each other.
●Do not smoke, use matches, cigarette lighters or allow open flame near the bat-
tery.
■Battery precautions
The battery contains poisonous and corrosive acidic electrolyte, while related parts
contain lead and lead compounds. Observe the following precautions when han-
dling the battery:
●When working with the battery, always wear safety glasses and take care not to
allow any battery fluids (acid) to come into contact with skin, clothing or the vehi-
cle body.
●Do not lean over the battery.
●In the event that battery fluid comes into contact with the skin or eyes, immedi-
ately wash the affected area with water and seek medical attention.
Place a wet sponge or cloth over the affected area until medical attention can be
received.
●Always wash your hands after handling the battery support, terminals, and other
battery-related parts.
●Do not allow children near the battery.
NOTICE
■When handling jumper cables
When connecting the jumper cables, ensure that they do not become entangled in
the cooling fans or belt.
RX350_270_EE_48D77E.book 597 ページ 2014年1月24日 金曜日 午前10時4分