2014 Lexus GS250 lock

651-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
Key of letters inserted in the above table:
IUF: Suitable for ISOFIX forward-facing child restraint systems of univer-sal category approved for use in this mass group.
IL: Suitable for child restraint systems shown in the ISOFIX child restraint system list.
When using a “LEXUS MINI” or “LEXUS MIDI”, adjust the support leg
and the ISOFIX connectors as follows: Lock the ISOFIX connectors
where numbers 3, 4 and 5 can
be seen.
Lock the support leg where 5th
hole can be seen.
X: ISOFIX position not suitable for ISOFIX child restraint systems in this mass group and/or this size class.
*: If the head restraint interferes with your child restraint system, and the head
restraint can be removed, remove the head restraint.
The child restraint system mentioned in the table may not be available out-
side of the EU area.
Other child restraint systems different from the systems mentioned in the
table can be used, but the suitability of the systems must be carefully
checked with the child restraint system manufacturer and retailer.
1
2
GS350_250_OM_OM30E16E_(EE).book Page 65 Tuesday, July 8, 2014 7:11 PM

701-1. For safe use
GS350_250_OM_OM30E16E_(EE)
Installing child restraints
Seat belts (An ELR belt requires a
locking clip)
ISOFIX rigid anchors
Lower anchors are provided for the
outboard rear seats. (Buttons display-
ing the location of the anchors are
attached to the seats.)
Anchor brackets (for top strap)
An anchor bracket is provided for
each rear seat.
Follow the child restraint system manufacturer’s instructions. Firmly
secure child restraints to the seats using a seat belt or ISOFIX rigid
anchors. Attach the top strap wh en installing a child restraint.
GS350_250_OM_OM30E16E_(EE).book Page 70 Tuesday, July 8, 2014 7:11 PM

711-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
■Rear-facing  Baby seat/child seat
Place the child restraint system
on the rear seat facing the rear
of the vehicle.
Run the seat belt through the
child restraint system and
insert the plate into the buckle.
Make sure that the belt is not
twisted.
Install a locking clip near the
tab of the lap and shoulder belt
by inserting the lap and shoul-
der webbing through the
recesses of the locking clip.
Buckle the belt again. If the
belt has any slack, release the
buckle and reinstall the locking
clip.
Installing child restraints using a seat belt
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 71 Tuesday, July 8, 2014 7:11 PM

721-1. For safe use
GS350_250_OM_OM30E16E_(EE)
■Forward-facing  Child seat
Remove the head restraint if it
interferes with your child
restraint system.
Place the child restraint system
on the seat facing the front of
the vehicle.
Run the seat belt through the
child restraint system and
insert the plate into the buckle.
Make sure that the belt is not
twisted.
Install a locking clip near the
tab of the lap and shoulder belt
by inserting the lap and shoul-
der webbing through the
recesses of the locking clip.
Buckle the belt again. If the
belt has any slack, release the
buckle and reinstall the locking
clip.
1
2
3
4
GS350_250_OM_OM30E16E_(EE).book Page 72 Tuesday, July 8, 2014 7:11 PM

751-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
Remove the head restraint.
Secure the child restraint system
using the seat belt or ISOFIX
rigid anchors.
Open the anchor bracket cover,
latch the hook onto the anchor
bracket and tighten the top strap.
Make sure the top strap is securely
latched.
■When installing a child restraint system
You need a locking clip to install the child restraint system. Follow the instructions
provided by the manufacturer of the system. If your child restraint system does not
provide a locking clip, you can purchase the following item from any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional:
Locking clip for child restraint system
(Part No. 73119-22010)
Child restraint systems with a top strap
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 75 Tuesday, July 8, 2014 7:11 PM

781-1. For safe use
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When installing a child restraint system
●If child restraint system regulations exist in the country where you reside, please
contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional for the child restraint system installation.
●When a junior seat is installed, always ensure that the shoulder belt is positioned
across the center of the child’s shoulder. The belt should be kept away from the
child’s neck, but not so that it could fall off the child’s shoulder. Failing to do so may
result in death or serious injury in the event of sudden braking, sudden swerving
or an accident.
●Ensure that the belt and plate are securely locked and the seat belt is not twisted.
●Shake the child restraint system left and right, and forward and backward to
ensure that it has been securely installed.
●After securing a child restraint system, never adjust the seat.
●Follow all installation instructions provided by the child restraint system manufac-
turer.
■To correctly attach a child restraint system to the anchors
When using the lower anchors, be sure that there are no foreign objects around
the anchors and that the seat belt is not caught behind the child restraint system.
Make sure the child restraint system is securely attached, or it may cause death or
serious injury to the child or other passengers in the event of sudden braking, sud-
den swerving or an accident.
GS350_250_OM_OM30E16E_(EE).book Page 78 Tuesday, July 8, 2014 7:11 PM

85
1
1-2. Theft deterrent system
GS350_250_OM_OM30E16E_(EE)
For safety and security
Double locking system
Vehicles employing this system have
labels on the window glass of both
front doors.
Turn the engine switch off, have all the passengers exit the vehicle and
ensure that all the doors are closed.
Using the entry function:
Touch the sensor area on the outside door handle twice within 5 seconds.
Using the wireless remote control:
Press twice within 5 seconds.
Using the entry function: Hold the outside door handle.
Using the wireless remote control: Press .
Unauthorized access to the vehicle is
prevented by disabling the door
unlocking function from both the in terior and exterior of the vehicle.
Setting the double locking system
Canceling the double locking system
CAUTION
■Double locking system precaution
Never activate the double locking system when there are people in the vehicle
because all the doors cannot be opened from inside the vehicle.
GS350_250_OM_OM30E16E_(EE).book Page 85 Tuesday, July 8, 2014 7:11 PM

861-2. Theft deterrent system
GS350_250_OM_OM30E16E_(EE)
Alarm∗
The alarm uses light and sound to give an alert when an intrusion is
detected.
The alarm is triggered in the following situations when the alarm is set:
●A locked door is unlocked or opened in any way other than using the
entry function or wireless remote control. (The door will lock again
automatically.)
●A trunk is opened in any way other than using the entry function, wire-
less remote control or mechanical key.
●The hood is opened.
●The tilt sensor detects a change of vehicle inclination. (if equipped)
Close the doors, trunk and hood,
and lock all the doors using the
entry function or wireless remote
control. The system will be set auto-
matically after 30 seconds.
The indicator light changes from
being on to flashing when the system
is set.
∗: If equipped
The alarm
Setting the alarm system
GS350_250_OM_OM30E16E_(EE).book Page 86 Tuesday, July 8, 2014 7:11 PM