2014 Lexus CT200h wheel

5528-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
*: Use of the jack (→P. 5 4 3 )
Location of the emergency tire puncture repair kit, jack and tools
Towing eyelet
Emergency tire puncture repair kit
Jack
*
Wheel nut wrench
Jack handle1
2
3
4
5
CT200h_OM_OM76135E_(EE).book Page 552 Friday, May 30, 2014 11:14 AM

5598-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Turn the compressor switch on to inflate the tire until the recommended tire
inflation pressure is reached. Drive for about 5 km (3 miles) and then perform
step .
Store the kit and then attach the 2
stickers as shown.
Taking precautions to avoid sudden
braking and sharp turns, drive carefully
at under 80 km/h (50 mph) to the
nearest authorized Lexus dealer, tire
dealer or repairer, or another duly quali-
fied and equipped professional for tire
repair or replacement.
■In the following cases, the tire cannot be repaired with the emergency tire puncture
repair kit. Contact any authorized Lexus dealer or repairer, or another duly qualified
and equipped professional.
●When the tire is damaged due to driving without sufficient air pressure
●When the tire lost air pressure due to a crack or damage in the tire sidewall
●When the tire is visibly separated from the wheel
●When the cut or damage to the tread is 4 mm (0.16 in.) long or more
●When the wheel is damaged
●When two or more tires have been punctured
●When there is more than one hole or cut in the damaged tire
16
14
17
CT200h_OM_OM76135E_(EE).book Page 559 Friday, May 30, 2014 1 1:14 AM

5608-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
■Emergency tire puncture repair kit
●The sealant has a limited lifespan. The expiry date is marked on the bottle. The sealant
should be replaced before the expiry date. Contact any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional for replacement.
●The sealant stored in the emergency tire puncture repair kit can be used only once to
temporarily repair a single tire. If the sealant in the bottle and other parts of the kit have
been used and need to be replaced, contact any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional.
●The sealant can be used when the outside temperature is from -30°C (-22 °F) to 60 °C
(140 °F).
●The kit is exclusively designed for size and type of tires originally installed on your vehi-
cle. Do not use it for tires that a different size than the original ones, or for any other
purposes.
●If the sealant gets on your clothes, it may stain.
●If the sealant adheres to a wheel or the surface of the vehicle body, the stain may not be
removable if it is not cleaned at once. Immediately wipe away the sealant with a wet
cloth.
●During operation of the kit, a loud operatio n noise is produced. This does not indicate a
malfunction.
■If the tire is inflated to more than the recommended level
Disconnect the hose from the valve.
Disconnect the hose from the valve, remove the air release cap from the hose and then
reconnect the hose.
Turn the compressor switch on and wait for se veral seconds, then turn it off. Check that
the air pressure indicator shows the recommended level. ( →P. 5 8 5 )
If the air pressure is lower than the recommended level, turn the compressor switch on
again and repeat the inflation procedure until the recommended pressure is reached. Install the air release cap to the end of the
hose and push the protrusion on the air
release cap into the valve to let some air out.
1
2
3
4
CT200h_OM_OM76135E_(EE).book Page 560 Friday, May 30, 2014 1 1:14 AM

5618-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
WA R N I N G
■Precautions for use of the sealant
●Ingesting the sealant is hazardous to your health. If you ingest sealant, consume as
much water as possible, then immediately consult a doctor.
●If sealant gets in eyes or adheres to skin, i mmediately wash it off with water. If discom-
fort persists, consult a doctor.
■When fixing the flat tire
●Stop your vehicle in a safe and flat area.
●Connect the valve and hose securely with the tire installed on the vehicle.
●If the hose is not properly connected to the valve, air leakage may occur or sealant
may be sprayed out.
●If the hose comes off the valve while inflating the tire, there is a risk that the hose will
move abruptly due to air pressure.
●After inflation of the tire has completed, the sealant may splatter when the hose is dis-
connected or some air is let out of the tire.
●Keep back from the tire while it is being re paired, as there is a chance of it bursting
while the repair operation is being performe d. If you notice any cracks or deforma-
tion of the tire, turn off the compressor sw itch and stop the repair operation immedi-
ately.
●The kit may overheat if operated for a long period of time. Do not operate the com-
pressor continuously for more than 10 minutes.
●Parts of the kit become hot during operation. Be careful handling the kit during and
after operation.
●Do not attach the vehicle speed warning sticker to an area other than the one indi-
cated. If the sticker is attached to an area where an SRS airbag is located, such as the
pad of the steering wheel, it may prevent the SRS air bag from operating properly.
■Driving to spread the liquid sealant evenly
●Drive the vehicle carefully at a low speed. Be especially careful when turning and cor-
nering.
●If the vehicle does not drive straight or you feel a pull through the steering wheel, stop
the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If tire infl ation pressure is 130 kPa (1.3 kgf/cm
2 or bar, 19 psi)
or below, this may indicate severe tire damage.
CT200h_OM_OM76135E_(EE).book Page 561 Friday, May 30, 2014 1 1:14 AM

5698-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
8
When trouble arises
Close the exclusive jump starting terminal cover, and reinstall the fuse box
cover to its original position.
Once the hybrid system starts, have the vehicle inspected at any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional as
soon as possible.
■Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
■To prevent 12-volt battery discharge
●Turn off the headlights and the audio system while the hybrid system is off.
●Turn off any unnecessary electrical components when the vehicle is running at a low
speed for an extended period, such as in heavy traffic.
■When the 12-volt battery is removed or discharged
●The hybrid system may not start. ( →P. 4 6 5 )
●If the 12-volt battery discharges while the shift position is in P, it may not be possible to
shift the shift position to other positions. In this case, the vehicle cannot be towed with-
out lifting both front wheels because the front wheels will be locked. ( →P. 5 1 0 )
●When the 12-volt battery is reconnected, start the hybrid system and confirm that the
shift position can be changed to each position using the shift position indicator.
●Make sure that the key is not inside the vehicle when recharging or replacing the 12-
volt battery. The key may be locked in the vehicle if the alarm is activated. (→P. 8 5 )
■Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when the vehicle
is not in use, due to natural discharge and the draining effects of certain electrical appli-
ances. If the vehicle is left for a long time, the 12-volt battery may discharge, and the
hybrid system may be unable to start. (The 12-volt battery recharges automatically while
the hybrid system is operating.)
WA R N I N G
■Avoiding 12-volt battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flammable gas
that may be emitted from the 12-volt battery:
●Make sure each jumper cable is connected to the correct terminal and that it is not
unintentionally in contact with any other than the intended terminal.
●Do not allow the other end of the jumper cable connected to the “+” terminal to come
into contact with any other parts or metal surfaces in the area, such as brackets or
unpainted metal.
●Do not allow the + and - clamps of the jumper cables to come into contact with each
other.
●Do not smoke, use matches, cigarette lighters or allow open flame near the 12-volt
battery.
9
CT200h_OM_OM76135E_(EE).book Page 569 Friday, May 30, 2014 1 1:14 AM

5768-2. Steps to take in an emergency
CT200h_OM_OM76135E_(EE)
NOTICE
■To avoid damage to the hybrid transmission and other components
●Avoid spinning the wheels and depressing the accelerator pedal more than neces-
sary.
●If the vehicle remains stuck even after these procedures are performed, the vehicle
may require towing to be freed.
CT200h_OM_OM76135E_(EE).book Page 576 Friday, May 30, 2014 11:14 AM

5789-1. Specifications
CT200h_OM_OM76135E_(EE)
Maintenance data (fuel, oil level, etc.)
*1:Unladen vehicle
*2: Vehicles with 16-inch and 17-inch tires
*3: Vehicles with 15-inch tires
■Vehicle identification number
The vehicle identification number (VIN) is the legal identifier for your vehicle.
This is the primary identification number for your Lexus. It is used in register-
ing the ownership of your vehicle.
This number is stamped on the top
left of the instrument panel.
Dimensions
Overall length4350 mm (171.3 in.)
Overall width1765 mm (69.5 in.)
Overall height*11455 mm (57.3 in.)*2
1445 mm (56.9 in)*3
Wheelbase2600 mm (102.4 in.)
Tr e a d
Front1525 mm (60.0 in.)*2
1535 mm (60.4 in.)*3
Rear1520 mm (59.8 in.)*2
1530 mm (60.2 in.)*3
Gross vehicle mass1845 kg (4068 lb.)*2
1790 kg (3946 lb.)*3
Maximum permissible axle
capacityFront1020 kg (2249 lb.)*2
1060 kg (2337 lb.)*3
Rear980 kg (2161 lb.)
Vehicle identification
CT200h_OM_OM76135E_(EE).book Page 578 Friday, May 30, 2014 1 1:14 AM

585
9
9-1. Specifications
Vehicle specifications
CT200h_OM_OM76135E_(EE)
XTy p e A
*: For optimizing fuel economy, ECO tire pressure is recommended. Tire pressure
affects traveling comfort, road noise and steering characteristics.
XTy p e B
XTy p e C
Tires and wheels
Ti r e s i z e195/65R15 91H
Tire inflation pressure
(Recommended cold tire
inflation pressure)
More than 160 km/h
(100 mph)250 kPa (2.5 kgf/cm2
or bar, 36 psi)
160 km/h (100 mph) or
less
XNormal pressure
230 kPa (2.3 kgf/cm2
or bar, 33 psi)
XECO pressure*
270 kPa (2.7 kgf/cm2
or bar, 39 psi)
Wheel size15 × 5 1 /2 J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
Ti r e s i z e205/ 55R16 91W, 205/55R16 91V
Tire inflation pressure
(Recommended cold tire
inflation pressure)More than 160 km/h
(100 mph)240 kPa (2.4 kgf/cm2
or bar, 35 psi)
160 km/h (100 mph)
or less220 kPa (2.2 kgf/cm2
or bar, 32 psi)
Wheel size16 × 6 J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
Ti r e s i z e215/45R17 87W
Tire inflation pressure
(Recommended cold tire
inflation pressure)
XFront tire
230 kPa (2.3 kgf/cm2 or bar, 33 psi)
XRear tire
220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Wheel size17 × 7 J
Wheel nut torque103 N•m (10.5 kgf•m, 76 ft•lbf)
CT200h_OM_OM76135E_(EE).book Page 585 Friday, May 30, 2014 1 1:14 AM