2014 Lancia Delta warning

180
SAFETY
Never travel with objects on your lap, in front
of your chest or with something between your
lips like a pipe or pencil, etc. In the event of
an impact where the airbags are deployed this could
cause serious injury.Always keep your hands in the correct posi-
tion on the steering wheel whilst driving so
that if the airbags are activated they can in-
flate properly. Do not drive with your body bent for-
ward. Keep the backrest in straight position, rest-
ing your back correctly on it.If someone tried to steal or damage your car,
and in the event of floods, have the airbag
system checked by a Lancia Dealership.
GENERAL WARNINGS
If when turning the key to MAR the ¬warn-
ing light does not turn on or if it stays on
when travelling, there could be a failure in
the safety systems; in this event airbags or preten-
sioners may not be deployed in the event of an im-
pact or, in a lower number of cases, they may de-
ploy accidentally. Before proceeding, contact a Lan-
cia Dealership immediately to have the system
checked.
Do not cover the front seat backrests with covers if
side bags are fitted.
155-182 Delta GB 1ed 26/08/13 11.29 Pagina 180

SAFETY
181
2
With ignition key inserted, at MAR, even if
the engine is off, the airbags can activate al-
so with the car stopped, if it is hit by anoth-
er vehicle. Therefore, even if the car is stationary,
when an active passenger airbag is fitted, DO NOT
install rear facing child restraint systems on the
front passenger seat. Deployment of the airbag fol-
lowing an impact could cause fatal injuries to the
child. Therefore, always deactivate the passenger
airbag when a rear facing child restraint system
is installed on the front passenger seat. The front
passenger seat must also be positioned back as far
as possible in order to avoid the child restraint sys-
tem from coming into contact with the dashboard.
Immediately reactivate the passenger airbag as soon
as the child restraint system has been removed. Al-
so remember that, if the key is turned to STOP, none
of the safety devices (airbags or pretensioners) will
be deployed in the event of collision. Non-deploy-
ment in such cases does not indicate a system mal-
function.
When the ignition key is turned to MAR, the
“warning light turns on and blinks for a few
seconds to remind you that the passenger
airbag will activate in the event of a collision. Then
it should turn off.Do not wash the seats with water or pres-
surised steam (by hand or at automatic car
seat washing stations).The front airbags deploy in the event of more
severe collisions than those required for de-
ploying the pretensioners. For impacts in the
range between the two activation thresholds, pre-
tensioner activation alone is normal.Do not hook rigid objects to clothes hangers
and support handles.The airbag does not replace seat belts; it in-
creases their effectiveness. Furthermore, since
front airbags are not deployed in low speed
collisions, side collisions, rear-end shunts or roll-
overs, the passengers are only protected by the seat
belts which must be fastened at all times.
155-182 Delta GB 1ed 26/08/13 11.29 Pagina 181

STARTING AND DRIVING
185
3
Proceed as follows:
❍engage the handbrake;
❍put the gear lever into neutral;
❍turn the ignition key to MAR: the
m
and
Y
warn-
ing lights on the instrument panel will turn on;
❍wait for the warning lights
Y
and
m
to turn off. The
hotter the engine is, the quicker this will happen;
❍fully depress the clutch pedal without operating the ac-
celerator;
❍turn the ignition key to AVV as soon as the
m
warn-
ing light goes out. Waiting too long will waste the heat-
ing work carried out by the glow plugs.
Release the key as soon as the engine starts.IMPORTANT With cold engine, the accelerator pedal shall
be completely released while turning the ignition key to
AV V.
If the engine does not start at the first attempt, turn the
ignition key to STOP again before repeating the procedure.
If instrument panel
Y
warning light remains lit when the
ignition key is turned to MAR, turn the key to STOP and
then back to MAR; if the warning light remains lit, try the
other keys provided with the vehicle. Contact a Lancia Deal-
ership if you still cannot start the engine.
The
m
warning light will flash for 60 sec-
onds after starting or during prolonged
cranking to indicate a fault with the glow
plug pre-heating system. Use the car normally if the
engine starts and go to a Lancia Dealership as soon
as possible.
183-194 Delta GB 1ed 26/08/13 12.15 Pagina 185

STARTING AND DRIVING
187
3
HANDBRAKEThe handbrake lever is located between the front seats.
Pull the lever upwards to operate the handbrake, until the
car is braked.
The car should be braked after a few clicks
of the lever; if it is not, contact a Lancia Deal-
ership to have it adjusted.
When the handbrake is on and the ignition key is at MAR,
the instrument panel xwarning light will come on.
Proceed as follows to release the handbrake:
❍slightly lift the lever and press release button A - fig. 1;
❍keep button A pressed and lower the lever. The x
warning light on the instrument panel turns off.
Press the brake pedal when carrying out this operation
to prevent the car from moving accidentally.
PARKING
Proceed as follows:
❍stop the engine and engage the handbrake;
❍engage a gear (on a slope, engage first gear if the car
is facing uphill or reverse if it is facing downhill) and
leave the wheels steered.
Block the wheels with a wedge or a stone if the car is
parked on a steep slope.
Do not leave the ignition key on MAR to avoid draining
the battery. Always remove the key when you leave the
car.
Never leave children unattended in the car. Always remove
the ignition key when leaving the car and take it out with
you.
fig. 1
L0E0072m
183-194 Delta GB 1ed 26/08/13 12.15 Pagina 187

196
IN AN EMERGENCY
STARTING THE ENGINEGo to a Lancia Dealership immediately if instrument pan-
el Y
warning light remains on constantly.
JUMP STARTING fig. 1
If the battery is flat, the engine may be started using an
auxiliary battery with the same capacity or a little high-
er than the flat one.
fig. 1
L0E0074m
Strictly avoid using a rapid battery charger
for jump starting: this could damage the elec-
tronic systems and the engine fuel supply and
ignition control units.This starting procedure must be carried out
by expert personnel as incorrect manoeuvres
can cause electrical discharges of consider-
able intensity. Furthermore, battery fluid is poiso-
nous and corrosive: avoid contact with skin and
eyes. Keep naked flames away from the battery. No
smoking. Do not cause sparks.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 196

IN AN EMERGENCY
203
4
BOTTLE REPLACEMENT PROCEDURE
To replace the bottle, proceed as follows:
❍disconnect connection A - fig. 7;
❍turn the bottle to be replaced anticlockwise and raise
it;
❍fit the new bottle and turn it clockwise;
❍connect connection A to the bottle and fit the trans-
parent tube B in the dedicated space.
fig. 7
L0E0289m
REPLACING A WHEELGENERAL INSTRUCTIONS
The car may be originally fitted with a space-saver wheel
(for versions/markets, where provided).
Wheel replacement and correct use of the jack and space-
saver wheel call for some precautions as listed below.
The space-saver wheel provided (for ver-
sions/markets, where provided) is specific for
the car; do not use it on other models, or use
the space-saver wheel of other models on your car.
The space-saver wheel must only be used in the
event of emergency. Never use it for more than strict-
ly necessary and never exceed 80 km/h. On the
space-saver wheel there is an orange label, sum-
marising the main warnings regarding space-saver
wheel usage restrictions.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 203

Never remove or cover the label. Never apply
a hub cap on a space-saver wheel. The la-
bel bears the following instructions in four
languages: WARNING! FOR TEMPORARY USE
ONLY! 80 KM/H MAX.! REPLACE WITH STAN-
DARD WHEEL AS SOON AS POSSIBLE. DO NOT
COVER THIS LABEL.
If you change the type of wheel (alloy rims instead
of steel rims) you will have to change the entire set
of fastening bolts with another set of suitably sized
bolts.Alert other drivers that the car is stationary
in compliance with local regulations: hazard
warning lights, warning triangle, etc. Any
passengers on board should leave the car, especial-
ly if it is heavily laden. Passengers should stay
away from on-coming traffic while the wheel is be-
ing changed. If parked on a slope or rough surface,
chock the wheels with wedges or other suitable de-
vices.
204
IN AN EMERGENCY
The jack can only be used for changing
wheels on the car with which it is provided
or on cars of the same model. Never use the
jack for other purposes, such as lifting other car
models. Never use it for repair operations under the
car. Incorrect positioning of the jack may cause the
car to fall. Do not use the jack for loads higher than
those shown on the label. Snow chains cannot be fit-
ted to the space-saver wheel. Therefore, if a front
(drive) wheel is punctured and chains are required,
a rear wheel should be fitted at the front of the car
and the space-saver wheel should be fitted to the
rear. This way, with two normal front driving
wheels, you can install the snow chains on them,
thus resolving the emergency.If the hub cap is not installed properly, it may
detach when the vehicle is running. Never
tamper with the inflation valve. Never intro-
duce tools of any kind between rim and tyre. Reg-
ularly check tyre and space-saver wheel pressure,
complying with the data in the chapter “6”.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 204

MAINTENANCE AND CARE
235
5
SCHEDULED SERVICING PLAN
Thousands of miles
Thousands of kilometres
Months
Check tyre condition/wear and adjust pressure if required
Check operation of lighting system (headlights, direction indicators, hazard warning lights, luggage compartment, passenger compartment, instrument panel warning lights, etc.)Check windscreen wiper/washer operationCheck the position/wear of the windscreen/rear window wiper blades
Check condition and wear of front disc brake pads andbrake pad wear indicator operationCheck rear disc brake pad liner condition and wear
Visually inspect condition of: bodywork exterior, underbody protection,
pipes and hoses (exhaust - fuel supply system - brakes), rubber elements (boots - sleeves - bushes - etc.)
Check cleanliness of bonnet and luggage compartment locks, cleanliness and lubrication of linkages
Check and top up, if required, fluid levels (engine coolant, brake/hydraulic clutch fluid, windscreen washer fluid, battery fluid, etc)Check handbrake lever travel and adjust, if requiredCheck tension of accessory drive belts and adjust, if necessary Check exhaust emissions/fumes21 42 63 84 105
35 70 105 140 175
24 48 72 96 120
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●● ● ● ●
●●
●● ● ● ●
233-256 Delta GB 1ed 26/08/13 13.12 Pagina 235