ENGINE BREAK-IN RECOMMENDATIONS • A long break-in period is not required for the engine and drivetrain (transmission
and axle) in your vehicle.
• Drive moderately during the first 300 miles (500 km). After the initial 60 miles
(100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.
• While cruising, brief full-throttle acceleration within the limits of local traffic laws
contributes to a good break-in. Wide-open throttle acceleration in low gear can be
detrimental and should be avoided.
• The engine oil installed in the engine at the factory is a high-quality energy
conserving type lubricant. Oil changes should be consistent with anticipated
climate conditions under which vehicle operations will occur. For the recom-
mended viscosity and quality grades, refer to “Maintaining Your Vehicle”.
NOTE:
A new engine may consume some oil during its first few thousand miles (kilome-
ters) of operation. This should be considered a normal part of the break-in and not
interpreted as an indication to an engine problem or malfunction.
CAUTION!Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may
result.
TURN SIGNAL/LIGHTS LEVER
Headlights/Parking Lights/Automatic Headlights
• Rotate the end of the lever to the first detent for parking lights , the second
detent for headlights , and the third detent for AUTO.
• When set to AUTO, the system automatically turns the headlights on or off based
on ambient light levels.OPERATING YOUR VEHICLE
23
Instrument Panel Dimmer • Rotate the center portion of the lever to the extreme bottom position to fully dim
the instrument panel lights and prevent the interior lights from illuminating when
a door is opened.
• Rotate the center portion of the lever up to increase the brightness of the
instrument panel lights when the parking lights or headlights are on.
• Rotate the center portion of the lever upward to the next detent position to brighten
the odometer and radio controls when the parking lights or headlights are on.
• Rotate the center portion of the lever upward to the last detent to turn on the
interior lighting.
Flash To Pass • Pull the lever toward you to activate the high beams. The high beams will remain
on until the lever is released.
High Beam Operation • Push the lever forward to activate the high beams.
NOTE:
For safe driving, turn off the high beams when oncoming traffic is present to prevent
headlight glare and as a courtesy to other motorists.
Fog Lights • Turn on the parking lights or low beam headlights and pull out the end of the lever.
Turn Signals/Lane Change Assist • Tap the lever up or down once and the turn signal (right or left) will flash three
times and automatically turn off.
OPERATING YOUR VEHICLE
24
4WD...................89
Operation ..............89
Shifting ...............89
Systems ..............89
Airbag..................13
Air Conditioning ............28
Alarm (Security Alarm) .........11
Antifreeze (Engine Coolant) .....114
Arming Theft System (Security
Alarm) ................11
Automatic Headlights .........23
Automatic Temperature
Control (ATC) ............28
Belts, Seat ...............12
Break-In Recommendations,
New Vehicle .............23
BulbReplacement ..........125
Calibration,Compass .........85
Capacities, Fluid ...........114
ChangeOilIndicator.........100
ChangingAFlatTire .........102
Child Restraint .............14
Climate Control .............28
Compass Calibration ..........85
Cooling System
Coolant Capacity .........114
Selection of Coolant
(Antifreeze) ............114
Cruise Control (Speed Control) ....26
Customer Assistance .........126
Defects, Reporting ..........127
Dimmer Control .............24
Dimmer Switch, Headlight ......24
Disarming, Theft System .......12
ECO ...................85
Electronic Speed Control
(Cruise Control) ...........26
Electronic Stability Control (ESC) . .96
Electronic Vehicle Information
Center(EVIC)..........84,86
Emergency, In Case of
Brake Warning Light .......98
Jacking ..............102 Overheating ............101
Engine
Break-In Recommendations . . .23
Compartment ...........113
FuelRequirements .......114
Oil .................114
Oil Selection ...........114
Overheating ............101
Event Data Recorder .........111
Exterior Lights .............125
Flash-To-Pass ..............24
Fluid Capacities ............114
Fluids, Lubricants and Genuine
Parts ................114
FogLights .............23,24
FoldingRearSeat ...........20
Four Wheel Drive Operation ......89
Freeing A Stuck Vehicle .......110
Front Heated Seats ...........22
Fuel
Filler Cap (Gas Cap) ........99
Requirements ..........114
Tank Capacity ..........114
Fuse ..................120
Fuses..................120
Headlights
Automatic .............23
Dimmer Switch ..........24
HighBeam .............24
Heated Seats ..............22
High
Beam/Low Beam Select
(Dimmer)
Switch ..........24
Hood Release .............112
Instrument Cluster ............8
Indicators ..............9
Instrument Cluster Warning
Lights...............8,96
Integrated Power Module (Fuses) . .120
Interior and Instrument Lights .....7
Intermittent Wipers (Delay Wipers) . .25
Inverter Outlet (115V) .........87
Inverter, Power .............87
iPod ®
/USB/MP3 Control ........77
Bluetooth Streaming Audio ....84INDEX
129