2014 JEEP WRANGLER lock

4. Turn the rear L-shaped lock (located above the shoul-der belt anchorage). 5. Unlatch the header panel latch located at the top of the
windshield.
208 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Front Panel(s) Installation
NOTE:Set the panels on the windshield frame so that
there is no overhang. Also, make sure that the panels are
sitting flush with the body.
1. Install the right panel first, then the left panel. 2. Reinstall the panel(s) using the same steps for removal
in reverse order.
Front Panel(s) Installation With Rear Hard Top
Removed
1. Turn the left and right panels over and move thespacer block (located on the rear of the panel) upward
90 degrees.3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 213

6. Locate the wire harness on the left rear inside corner ofthe vehicle. 7. Release the red locking tab by pulling outward to the
right.Wire Harness Connector
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 215

8. To remove the wiring harness press the tab and pulldownward to disconnect. 9. To remove the washer hose, pinch the grips on hose
connector and pull downward.
Red Locking TabPress Tab To Disconnect
216 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

5. Make sure the plastic sleeves are slid rearward overthe Sunrider® link to lock in the link (Sunrider®
Models only). 6. As you begin to lower the top, fold the sail panels so
that they rest on top of the soft top.
230 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

14. Completely release the latches from the loops on thewindshield frame. If your vehicle is not equipped
with the Sunrider® package, proceed to Step 15. 15. Make sure the plastic sleeves are slid rearward over
the Sunrider® link to lock in the link (Sunrider®
Models only).
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 243

6. Ensure that the top locks into the Sunrider® lockingmechanisms that are located above the front of the rear
doors. 7. Unclip and move the sun visors to the side.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 279

Opening The Sunrider®
1. Unclip and move the sun visors to the side.
2. Release the header latches from the loops on thewindshield frame.
3. Make sure to slide the plastic sleeves forward to unlock the Sunrider® links. 4. Grasp the header and lift the top back. Make sure the
material is folded back as shown.
NOTE: The Sunrider® latch on the door rail should not
be activated for Sunrider® use. If activated, the soft top
must be reinstalled starting from the sail panels.
288 UNDERSTANDING THE FEATURES OF YOUR VEHICLE