2014 JEEP GRAND CHEROKEE four wheel drive

INTRODUCTION
Congratulations on selecting your new Chrysler Group
LLC vehicle. Be assured that it represents precision
workmanship, distinctive styling, and high quality - all
essentials that are traditional to our vehicles.
This is a specialized utility vehicle. It can go places and
perform tasks that conventional passenger cars are not
intended. It handles and maneuvers differently from
many passenger cars both on-road and off-road, so take
time to become familiar with your vehicle.
The two-wheel drive version of this vehicle was designed
for on-road use only. It is not intended for off-road
driving or use in other severe conditions suited for a
four-wheel drive vehicle.
Before you start to drive this vehicle, read the Owner’s
Manual. Be sure you are familiar with all vehicle controls,particularly those used for braking, steering, transmis-
sion, and transfer case shifting. Learn how your vehicle
handles on different road surfaces. Your driving skills
will improve with experience. When driving off-road or
working the vehicle, don’t overload the vehicle or expect
the vehicle to overcome the natural laws of physics.
Always observe federal, state, provincial and local laws
wherever you drive.
As with other vehicles of this type, failure to operate this
vehicle correctly may result in loss of control or a
collision. Refer to “On-Road/Off-Road Driving Tips” in
“Starting And Operating” for further information.
This Owner’s Manual has been prepared with the assis-
tance of service and engineering specialists to acquaint
you with the operation and maintenance of your vehicle.
It is supplemented by Warranty Information, and various
customer-oriented documents. Please take the time to
4 INTRODUCTION

NOTE:Any chassis/suspension or tire size modifications
to the vehicle will effect the performance of the Adaptive
Cruise Control.
Activating Adaptive Cruise Control (ACC)
You can only engage ACC if the vehicle speed is above
0 mph (0 km/h).
The minimum Set Speed for the ACC system is 20 mph
(32 km/h).
When the system is turned on and in the READY state,
the Electronic Vehicle Information Center (EVIC) dis-
plays “ACC Ready.”
When the system is OFF, the EVIC displays “Adaptive
Cruise Control (ACC) Off.”
NOTE: You cannot enable ACC under the following
conditions:
• When in Four-Wheel Drive Low.
Adaptive Cruise Control Buttons
1 — NORMAL (FIXED SPEED) CRUISE CONTROL ON/OFF
2 — SET+/ACCEL
3 — RESUME
4 — SET-/DECEL
5 — DISTANCE SETTING — INCREASE
6 — ADAPTIVE CRUISE CONTROL (ACC) ON/OFF
7 — DISTANCE SETTING — DECREASE
8 — CANCEL 190 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

•The Normal (Fixed Speed) Electronic Speed Control
ON/OFF button is pressed.
• The ignition is turned OFF.
• You switch to Four-Wheel Drive Low.
To Resume
If there is a set speed in memory press the RES (resume)
button and then remove your foot from the accelerator
pedal. The EVIC will display the last set speed.
NOTE:
•If your vehicle stays at standstill for longer than two
seconds, then the system will cancel and the brake
force will be ramped-out. The driver will have to apply
the brakes to keep the vehicle at a standstill.
• ACC cannot be resumed if there is a stationary vehicle
in-front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
To Vary The Speed Setting
To Increase Speed
While ACC is set, you can increase the set speed by
pressing the SET +button.
194 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

•The shift lever/gear selector is removed from the
Drive position.
To Resume Speed
To resume a previously set speed, push the RES button
and release. Resume can be used at any speed above
20 mph (32 km/h).
To Turn Off
The system will turn off and erase the set speed in
memory if:
• The Normal (Fixed Speed) Electronic Speed Control
ON/OFF button is pressed.
• The ignition is turned off.
• You engage Four-Wheel Drive Low.
• The Adaptive Cruise Control (ACC) On/Off button is
pressed.
PARKSENSE® REAR PARK ASSIST — IF
EQUIPPED
The ParkSense® Rear Park Assist system provides visual
and audible indications of the distance between the rear
fascia and a detected obstacle when backing up, e.g.
during a parking maneuver. Refer to ParkSense® System
Usage Precautions for limitations of this system and
recommendations.
ParkSense® will retain the last system state (enabled or
disabled) from the last ignition cycle when the ignition is
changed to the ON/RUN position.
ParkSense® can be active only when the shift lever/gear
selector is in REVERSE. If ParkSense® is enabled at this
shift lever/gear selector position, the system will remain
active until the vehicle speed is increased to approxi-
mately 7 mph (11 km/h) or above. When in REVERSE
and above the system’s operating speed, a warning will
appear within the Electronic Vehicle Information Center
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 213

STARTING AND OPERATING
CONTENTS
STARTING PROCEDURES ................395
▫ Automatic Transmission ................395
▫ Keyless Enter-N-Go™ ..................396
▫ Normal Starting ...................... .396
▫ Extreme Cold Weather
(Below –20°F Or 29°C) ................398
▫ If Engine Fails To Start .................398
▫ After Starting ....................... .400
 ENGINE BLOCK HEATER — IF EQUIPPED . . .400
 AUTOMATIC TRANSMISSION ............400▫
Key Ignition Park Interlock ...............402
▫ Brake/Transmission Shift Interlock System . . .402
▫ Fuel Economy (ECO) Mode ..............403
▫ Eight–Speed Automatic Transmission .......404
 FOUR-WHEEL DRIVE OPERATION .........413
▫ Quadra-Trac I® Operating Instructions/
Precautions — If Equipped ..............413
▫ Quadra-Trac II® Operating Instructions/
Precautions — If Equipped ..............413
▫ Shift Positions ....................... .415
5

FUEL SAVER TECHNOLOGY 5.7L ENGINE ONLY
— IF EQUIPPED ...................... .443
 PARKING BRAKE ..................... .443
 ELECTRONIC BRAKE CONTROL SYSTEM . . . .446
▫ Anti-Lock Brake System ................446
▫ Traction Control System (TCS) ............448
▫ Brake Assist System (BAS) ...............448
▫ Electronic Roll Mitigation (ERM) ..........449
▫ Electronic Stability Control (ESC) ..........450
▫ Trailer Sway Control (TSC) ..............453
▫ Hill Start Assist (HSA) .................454
▫ Ready Alert Braking — If Equipped ........456
▫ Rain Brake Support — If Equipped .........456▫
Hill Descent Control (HDC) — If Equipped
(Four-Wheel Drive Models With MP3023
Two-Speed Transfer Case Only) ...........457
▫ Select Speed Control (SSC) — If Equipped
(Four-Wheel Drive Models With MP3023
Two-Speed Transfer Case Only) ...........460
▫ ESC Activation/Malfunction Indicator Light
And ESC OFF Indicator Light ............464
 TIRE SAFETY INFORMATION .............465
▫ Tire Markings ....................... .465
▫ Tire Identification Number (TIN) ...........469
▫ Tire Terminology And Definitions ..........471
▫ Tire Loading And Tire Pressure ...........472
 TIRES — GENERAL INFORMATION ........477
▫ Tire Pressure ....................... .477
5
STARTING AND OPERATING 391

▫Trailer Hitch Receiver Cover Removal (Summit
Models) — If Equipped .................518
▫ Trailer And Tongue Weight ..............519
▫ Towing Requirements ..................520
▫ Towing Tips ........................ .525
 SNOW PLOW ........................ .527
RECREATIONAL TOWING (BEHIND
MOTORHOME, ETC.) ...................528
▫ Towing This Vehicle Behind Another Vehicle . .528
▫ Recreational Towing – Two-Wheel Drive
Models ............................ .529
▫ Recreational Towing — Quadra–Trac II® /
Quadra–Drive® II Four-Wheel Drive
Models ............................ .529
394 STARTING AND OPERATING

When parking on a hill, apply the parking brake before
shifting the transmission to PARK. As an added precau-
tion, turn the front wheels toward the curb on a downhill
grade and away from the curb on an uphill grade.
NOTE:On four-wheel drive vehicles be sure that the
transfer case is in a drive position.
WARNING!
• Never use the PARK position as a substitute for the
parking brake. Always apply the parking brake
fully when parked to guard against vehicle move-
ment and possible injury or damage.
• Your vehicle could move and injure you and others
if it is not in PARK. Make sure the transmission is
in PARK before leaving the vehicle.
(Continued)
WARNING! (Continued)
•It is dangerous to shift out of PARK or NEUTRAL
if the engine speed is higher than idle speed. If
your foot is not firmly pressing the brake pedal, the
vehicle could accelerate quickly forward or in re-
verse. You could lose control of the vehicle and hit
someone or something. Only shift into gear when
the engine is idling normally and your foot is
firmly pressing the brake pedal.
• Unintended movement of a vehicle could injure
those in or near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running. Before exiting a vehicle, always apply the
parking brake, shift the transmission into PARK,
turn the engine OFF, and remove the Key Fob.
When the ignition is in the OFF position, the
(Continued)
406 STARTING AND OPERATING