2014 JEEP CHEROKEE ad blue

CavityBlade Fuse Cartridge Fuse Description
F20 10 Amp Red —A/C Compressor Clutch
F21 — —Not Used
F22 5 Amp Tan —Radiator Fan
F23 70 Amp Tan —Body Controller Module (BCM) - Feed 1
F24 — —Not Used
F25 — —Not Used
F26 —30 Amp Pink Fuel Heater - Diesel Only
F27 — —Not Used
F28 15 Amp Blue —Transmission Control Module (TCM)
F29 — —Not Used
F30 10 Amp Red —Engine Control Module (ECM)
F31 — —Not Used
F32 — —Not Used
632 MAINTAINING YOUR VEHICLE

CavityBlade Fuse Cartridge Fuse Description
F33 —30 Amp Pink Driver Door Module (DDM) - If Equipped
F34 —30 Amp Pink Body Controller Module (BCM) - Feed 3
F35 — —Not Used
F36 — —Not Used
F37 —50 Amp Red Voltage Stabilization Module (VSM) -
If Equipped With Stop/Start Engine Option
F38 —50 Amp Red Radiator Fan
F38 —60 Amp Yellow Glow Plugs - Diesel Only - If Equipped
F39 —40 Amp Green HVAC Blower Motor
F40 —20 Amp Blue Trailer Tow Park Light - If Equipped
F41 —60 Amp Yellow Body Controller Module (BCM) - Feed 2
F42 —30 Amp Pink Electric Park Brake (EPB) - Left
F43 20 Amp Yellow —Trailer Tow Left Stop/Turn Light -
If Equipped
7
MAINTAINING YOUR VEHICLE 633

CavityBlade Fuse Cartridge Fuse Description
F56 15 Amp Blue —Ignition Node Module (IGNM)/KIN/RF
Hub/Electric Steering Column Lock (ESL)
F57 20 Amp Yellow —Fuel Pump Motor
F58 10 Amp Red —Occupant Classification Module
F59 — —Not Used
F60 20 Amp Yellow —Power Outlet - Center Console
F61 — —Not Used
F62 10 Amp Red —Heated Mirrors - If Equipped
F63 25 Amp Clear —Front Heated Seats - If Equipped
F64 25 Amp Clear —Heated Steering Wheel / Rear Heated Seats -
If Equipped
F65 15 Amp Blue —HVAC (ECC) / Instrument Panel Cluster
(IPC)
7
MAINTAINING YOUR VEHICLE 635

CavityBlade Fuse Cartridge Fuse Description
F74 —20 Amp Blue Engine Control Module (ECM) Gasoline
Engine - If Equipped
F75 20 Amp Yellow —Cigar Lighter
F76 20 Amp Yellow —Rear Differential Module (RDM) -
If Equipped
F77 10 Amp Red —Fuel Door Release/Brake Pedal Switch
F78 10 Amp Red —Diagnostic Port / Steering Column Control
Module (SCCM) / Digital TV - If Equipped
F79 10 Amp Red —Integrated Center Stack (ICS) / HVAC / Aux
Switch Bank Module (ASBM) / Instrument
Panel Cluster (IPC)
F80 20 Amp Yellow —Radio / CD - If Equipped
F81 — —Not Used
F82 — —Not Used
7
MAINTAINING YOUR VEHICLE 637

CavityBlade Fuse Cartridge Fuse Description
F83 —30 Amp Pink Headlamp Washer Pump - If Equipped
F84 —40 Amp Green Brake System Module (BSM) - Pump Motor
If Equipped With Diesel Engine
F84 —20 Amp Blue Trailer Tow Backup Lights - If Equipped With
Gasoline Engine
F85 — —Not Used
F86 — —Not Used
F87 — —Not Used
F88 15 Amp Blue —Collision Mitigation Module (CMM) /
Electrochromatic Mirror / Smart Camera
Module - If Equipped
F89 10 Amp Red —Headlamp Leveling - If Equipped
F90 — —Not Used
638 MAINTAINING YOUR VEHICLE

Interior Fuses
The interior fuse panel is located in the passenger com-
partment on the left side dash panel under the instru-
ment panel.
CavityBlade Fuse Description
F13 15 Amp Blue Low Beam Left
F32 10 Amp Red Interior Lighting
F36 10 Amp Red Intrusion Module/Siren – If Equipped
F38 20 Amp Yellow Deadbolt All Unlock
F43 20 Amp Yellow Washer Pump Front
F48 25 Amp Clear Fog Lamp Rear Left/Right – If Equipped
F49 7.5 Amp Brown Lumbar Support
F50 7.5 Amp Brown Wireless Charging Pad If Equipped
640 MAINTAINING YOUR VEHICLE

NOTE:On vehicles equipped with HID headlamps,
when the headlamps are turned on, there is a blue hue to
the lights. This diminishes and becomes more white after
approximately 10 seconds, as the system charges.
WARNING!
A transient high voltage occurs at the bulb sockets of
HID headlamps when the headlamp switch is turned
ON. It may cause serious electrical shock or electro-
cution if not serviced properly. See your authorized
dealer for service.
Bi-Halogen Headlamps
1. Unlock upper access door in wheel liner.
2. Reach behind the headlamp housing to access the headlamp bulb cap. 3. Firmly grasp the cap and rotate it counterclockwise to
unlock it.
4. Firmly grasp the bulb and connector assembly and rotate counterclockwise to remove from the housing.
5. Disconnect the bulb from the electrical connector and then connect the replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
6. Install the bulb and connector assembly into the headlamp housing and rotate clockwise to lock it in
place.
644 MAINTAINING YOUR VEHICLE