2014 INFINITI QX80 check engine

5
Tire Pressure Monitoring System (TPMS) with Tire Inflation Indicator
A CHECK TIRE PRESSURE warning message will appear
in the vehicle information display
01 and the low tire
pressure warning light 02 will illuminate when one or
more tires are low on pressure and air is needed.



•


The tire pressures should be

checked when the tires are cold.
The tires are considered cold after
the vehicle has been parked for 3
hours or more or driven less than 1
mi (1.6 km) at moderate speeds.
When adding air to an under-inflated tire, the TPMS
with Tire Inflation Indicator provides visual and
audible signals to help you inflate the tires to the
recommended COLD tire pressure.
To use the Tire Inflation Indicator:



1.

Move the shift lever to the
P (PARK) position and
apply the parking brake.



2.

Place the ignition switch in the
ON position. Do not start the engine.



3.

Add air to the under-inflated tire and within a few seconds, the hazard \
warning lights

will start flashing.



4.

When the designated tire pressure is reached, the horn will beep once an\
d the hazard

warning flashers will stop.



5.

Repeat this procedure for any additional under-inflated tires.
After tire pressures are adjusted, drive the vehicle at s peeds above 16 MPH (25 km/h). The
CHECK TIRE PRESSURE warning message and low tire pressure warning light will disappear.
When the low tire pressure warning light flashes for approximately 1 min\
ute and then remains
on, the TPMS is not functioning properly. Have the system checked by an \
INFINITI retailer.
Tire pressure rises and falls depending on the heat caused by the vehicl\
e’s operation and
the outside temperature. Low outside temperature can lower the temperature of the ai\
r inside
the tire, which can cause a lower tire inflation pressure. This may caus\
e the low tire pressure
warning light to illuminate. If the warning light illuminates, check the\
tire pressure in your tires.
•

Check the tire pressure (including the spare tire) often and always pr\
ior to long distance trips.
The Tire and Loading Information label contains valuable information. Pl\
ease refer to section 9,
“Technical and consumer information” in your Owner’s Manual for\
the location of the
Tire and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)” , “Starting and driving (section 5)” and the “Maintenance and
do-it-yourself (section 8)” of your Owner’s Manual.
02
01
essential information
1591592_14b_Infiniti_QX80_QRG_093013.indd 59/30/13 9:35 AM

9
Power Liftgate
When the liftgate is closed and locked, the liftgate
will open automatically by:
•


Pushing the power liftgate switch 01 on the
instrument panel.
•


Pushing the liftgate opener switch 02, the
liftgate must be unlocked, or you must have the
Intelligent Key with you (in your pocket or purse).



•


Pressing the
button
03 on the INFINITI
Intelligent Key for more than 1 second.
The power liftgate operation can be turned on or

off by the power liftgate main switch
04 on the
instrument panel.
• When the power liftgate


main switch
04 is
pushed to the OFF
position, power operation is not available using
the power liftgate switch located on the lower part of the
liftgate or the liftgate opener switch

02.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your
Owner’s Manual.
01
04
02
03
INTELLIGENT KEY BATTERY DISCHARGE
If the battery of the Intelligent Key is discharged,
or environmental conditions interfere with the
Intelligent Key operation, start the engine according
to the following procedure:



1.

Move the shift lever to the
P (PARK) position.



2.

Firmly apply the foot brake.



3.

Touch the ignition switch with the Intelligent Key

and a chime will sound.



4.

Within 10 seconds after the chime sounds, push the ignition switch while\
depressing the

brake pedal and the engine will start.
*Laws in some communities may restrict the use of remote starters. Check\
local regulations before using this feature.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and the
“ Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
1591592_14b_Infiniti_QX80_QRG_093013.indd 99/30/13 9:35 AM

13
Outside Mirror Control Switch
Move the control switch 01 right or left to select the
right or left side mirror.
Adjust each mirror to the desired position using the
switch
02.
Move this switch 01 to the center (neutral) position
to prevent accidentally moving the mirror.
POWER FOLDING OUTSIDE MIRRORS
To fold the outside rearview mirrors, push the switch 03 to the
position. To unfold the
outside rearview mirrors, push the switch
03 to the
position. If mirrors are manually operated or bumped, the mirror body can become l\
oose at the

pivot point.
To correct electronic mirror operation, cycle mirrors by pushing the out\
side rearview mirror
folding switch
03 to the
position until completely closed, then push the switch 03 to
the
position until the mirror is completely open.
REVERSE TILT-DOWN FEATURE
When backing up the vehicle, the right or left outside mirrors will turn\
downward automatically
to provide better rear visibility.



1.

Push the ignition switch to the
ON position.



2.

Move the shift lever to the
R (REVERSE) position.



3.

Choose the right or left outside mirror by operating the outside mirror \
control switch.



4.

The outside mirror surfaces move downward.
When one of the following conditions has occurred, the outside mirror su\
rfaces will return
to their original positions.



•

The shift lever is moved to any position other than
R (REVERSE).



•

The outside mirror control switch is set to the center (neutral) posit\
ion.



•

The ignition switch is pushed to the
OFF position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Starting/Stopping the Engine
It is important to make sure the INFINITI Intelligent



Key is with you (that is, in your pocket or purse).
Depress the brake pedal.
Press the ignition switch START/STOP button to start
the engine.
TURNING THE ENGINE OFF
Move the shift lever to the P (PARK) position and apply the parking brake.
Press the ignition switch START/STOP button to turn the engine off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
02
03
1591592_14b_Infiniti_QX80_QRG_093013.indd 139/30/13 9:36 AM