2014 INFINITI Q70 homelink

23

HomeLink® Universal Transceiver (if so equipped)
The h omeLink system can learn and consolidate the functions of up to 3 differ\
ent
hand-held transmitters, operating items such as garage doors, property g\
ates, outdoor and
indoor lights or alarm systems.
To program the h omeLink® Universal Transceiver:
•

Position


the

handheld

transceiver 1-3 in (26-76 mm) away from the HomeLink surface,
keeping the
h
omeLink indicator light in view.
•

Press


and

hold

the

desired HomeLink button and the handheld transmitter button
simultaneously until the
h omeLink indicator light flashes slowly and then rapidly.
•

Both


buttons

may

be

released when the indicator light flashes rapidly.
To verify the programming is complete, press and hold the h omeLink button and observe
the indicator light:
•

A
solid continuous light indicates the programming is complete, and the HomeLink button

will activate your device.


•
A
blinking light that turns to a solid continuous light after 2 seconds indicates additional
steps are required to complete the programming.
An additional person may make the remaining steps easier. To complete th\
e
programming process:
•

At
the receiver of the device that you are programming to the HomeLink button, press

and release the learn or smart button (the name may vary by manufacture\
r, but it is


usually located near where the hanging antenna wire is attached to the u\
nit). You have
approximately 30 seconds to initiate the following step.
•

Press
and hold the programed HomeLink button for 2 seconds and release.
You may have to repeat the previous 2 steps up to 3 times to complete th\
e programing
process.
h omeLink should now activate your device.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual, the homeLink website at
www.homelink.com or call
1-800-355-3515.
HOMELINK
1276460_14a_Infiniti_Q70_QRG_102813.indd 2310/28/13 2:32 PM