Malfunction IndicatorsIf an indicator remains on, there may be a problem; see your dealer
On/Off Indicators
Condition IndicatorsAction is needed by driver
PASSENGER AIRBAG OFF(located on center panel)
SIDE AIRBAG OFF
CRUISE CONTROL on
Bed lights on
Exterior lights on
Turn signals/hazards on
High beams on
Charging system
Low brake fluid
Low oil pressure
Anti\bLock Brake System (ABS)
Variable Torque Management
4WD (VTM\b4)
Malfunction lamp
(check engine light)
Vehicle Stability Assist®(VSA)
Supplemental Restraint System
(SRS)
Daytime Running Lights (DRL) Tire Pressure Monitoring System
(TPMS)*
Parking brake on:
Release
Door/Tailgate open:
Close door(s)/tailgate
In\bBed Trunk open:
Close trunk
Maintenance MinderTM:
Make dealer appointment
A/T Temperature:
Pull over and let engine idleVTM\b4 (blinks):
Pull over and let engine idle
Message indicator*:
Press \fnfo button
*vehicles with navigation
*vehicles without navigation
Low fuel:
Refill
Back window open:
Close back window
Low tire pressure:
Add air
INSTRUMENT PANEL INDICATORS
Immobilizer (blinks):
Use other vehicle key
and see dealer
Briefly appear with each engine start. Red and amber indicators are most critical. Blue
and green indicators are used for general information. See your Owner’s Manual for
more information.
23
CRUISE MAIN on
Vehicle with navigation shown
Seat belt reminder:
Fasten seat belt(s) VSA OFF
14 Ridgeline TRG_ATG\A_NEW STYLE 8/1/201\A3 1\f13 PM Page 3
1819
Press and release the HFL Talk button before you say a command.
HFL Phonebook
\f. Say“Phonebook.”
Store up to 50 names and their phone numbers, which can be used as speed dials.
2. Say “Store.” 3. Say
the name of the contact,
and then the phone number.
4. To call a contact once an entry is stored, say “\fall Mike.”
Press and release the Navi Talk button before you say a command.
Cellular Phonebook*
\f. Say “Display Information.”
Say “\fellular Phone.”
Import your entire cell phone’s address book to the navigation system.
*not available on all phones
2. Say
“Import \fellular
Phonebook.” 3. HFL begins to import your
contacts to the system.4. To call a contact, say “Search
Imported Phonebook” and select
the name and number.
H O M E L I N K®
Program your vehicle to operate up to three remote\bcontrolled devices around your
home, such as garage doors, lighting, or home security systems. Available on RTL.
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold
the HomeLink
button again. Training
complete
YES
NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on.YES
NO
YES
NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.1
Press and hold the desired HomeLink
button and the button on the remote
transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
a
The remote has a rolling code.
Press the “learn” button on the
remote-controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remote-controlled
device should operate. Within 30 seconds, press and hold
the programmed HomeLink button
for 2 seconds.a
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
Training a Button
If you have any problems programming HomeLink, see the owner’s manual included
with the device you are trying to program, call HomeLink at (800) 355\b3\25\f5, or
visit www.homelink.com.
14 Ridgeline TRG_ATG\A_NEW STYLE 8/1/201\A3 1\f14 PM Page 11\A
