2014 HONDA INSIGHT engine oil

Honda Motor Oil is the pref erred
0W-20 lubricant f or your vehicle. It is
highly recommended that you use
Honda Motor Oil in your vehicle f or
optimum engine protection. Make
sure the API Certif ication Seal says
‘‘For Gasoline Engines’’.The oil viscosity or weight is
provided on the container’s label. You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals shown on the multi-
inf ormation display.
Your vehicle does not require any oil
additives. Additives may adversely
af f ect the engine or transmission
perf ormance and durability.
A very low-viscosity, f uel-ef f icient
0W-20 oil is the engine lubricant f or
your Insight. This oil is f ormulated to
help your engine use less f uel.
A dding Engine Oil
Synthetic Oil
Engine Oil A dditives
311
API CERTIFICATION SEAL
Ambient Temperature
12/07/13 17:16:25 31TM8630_316
Maint enanceTOC
2014 Insight

Changing the oil and filter requires
special tools and access from
underneath the vehicle. The vehicle
should be raised on a service
station- type hydraulic lift for
this service. Unless you have the
knowledge and proper equipment,
you should have this maintenance
done by a skilled mechanic.Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood, and remove the
engine oil f ill cap. Remove the screws with a Phillips-
head screwdriver, and clips with a
f lat-tip screwdriver, then pull the
under-cover down.
Always change the oil and f ilter
according to the maintenance
messages shown on the multi-
inf ormation display. The oil and f ilter
collect contaminants that can
damage your engine if they are not
removed regularly.
1.
2.3.
Changing the Oil and Filter
312
SCREW
CLIP SCREWS
12/07/13 17:16:31 31TM8630_317
Maint enanceTOC
2014 Insight

CONT INUED
Remove the oil drain bolt and
washer from the bottom of the
engine. Drain the oil into an
appropriate container.Remove the oil f ilter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Make sure the oil f ilter gasket is
not stuck to the contacting surface
of the engine. If it is, remove it
bef ore installing a new oil f ilter.Engine oil change capacity
(including f ilter): Refill the engine with the
recommended oil. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to: Make sure to clean of f any dirt
and dust on the contacting surf ace
of a new oil f ilter. Install a new oil f ilter according to
the instructions that come with it.
7.
8.
4. 5. 6.
Changing the Oil and Filter
313
WASHER
OIL FILTER
BOLT
3.4 US qt (3.2)
29 lbf·ft (39 N·m , 4.0 kgf·m)
12/07/13 17:16:41 31TM8630_318
Maint enanceTOC
2014 Insight

Turn of f the engine, let it sit f or
several minutes, then check the oil
level on the dipstick. If necessary,
add more oil.
Put the under-cover back in place
and reinstall the holding clips and
screws. Lock the clips securely by
pushing on the center of each clip.
Reinstall the engine oil f ill cap.
Start the engine. The oil pressure
indicator should go out within 5
seconds. If it does not, turn of f the
engine, and check your work.
Let the engine run f or several
minutes, then check the drain bolt
and oil f ilter f or leaks.
9.
10. 11.
12.
Changing the Oil and Filter
314
Improper disposal of engine oil can be
harmf ul to the environment. If you
change your own oil, please dispose of
the used oil properly. Put it in a sealed
container and take it to a recycling
center. Do not discard it in a trash bin
or dump it on the ground.
12/07/13 17:16:46 31TM8630_319
Maint enanceTOC
2014 Insight

This section covers the more
common problems that motorists
experience with their vehicles. It
gives you inf ormation about how to
safely evaluate the problem and what
to do to correct it. If the problem has
stranded you on the side of the road,
you may be able to get going again.
If not, you will also f ind instructions
on getting your vehicle towed.......................
Compact Spare Tire .348
....................
Changing a Flat Tire .349
.............
If the Engine Won’t Start . 356
................................
Jump Starting .358
..............
If the Engine Overheats . 360
.........
Low Oil Pressure Indicator . 363
12 Volt Battery Charging System .....................................
Indicator .364
.......
Malf unction Indicator Lamp . 365
...............
Brake System Indicator . 366
..............................................
Fuses .367
..............................
Fuse Locations .372
......................
Emergency Towing .374
..........
If Your Vehicle Gets Stuck . 375
Taking Care of the Unexpected
347
12/07/13 17:21:05 31TM8630_352
2014 Insight

If necessary, add oil to bring the
level back to the full mark on the
dipstick (seepage). The engine running generates the
oil pressure. When the Auto Idle
Stop is activated, the engine
is stopped, the oil pressure
is dropped, and the low oil pressure
indicator does not come
on.
Saf ely pull of f the road, and shut
of f the engine. Turn on the hazard
warning lights.
Let the vehicle sit f or a minute.
Open the hood, and check the oil
level (see
page). An engine
very low on oil can lose pressure
during cornering and other driving
maneuvers.
Start the engine and watch the oil
pressure indicator. If it does not go
out within 10 seconds, turn of f the
engine. There is a mechanical
problem that needs to be repaired
bef ore you can continue driving
(see on
).
This indicator should never
come on when the engine is
running. If it starts f lashing or stays
on, the oil pressure has dropped very
low or lost pressure. Serious engine
damage is possible, and you should
take immediate action.
You will also see a ‘‘CHECK
ENGINE OIL LEVEL’’ message on
the multi-information display when
this indicator comes on.
The indicator notif ies you of low oil
pressure and does not measure the
oil level. Check your vehicle’s oil
level at each ref ueling. 1.
2.
3.
4.
249
310
L ow Oil Pressure Indicator
Emergency T owing
363
Running the engine with low oil
pressure can cause serious mechanical
damage almost immediately. Turn of f
the engine as soon as you can saf ely get
the vehicle stopped.
12/07/13 17:22:59 31TM8630_368
T aking Care of t he Unexpect edTOC
page 374
2014 Insight

Î
Î
Î
Î
Specif ications
380
Dimensions
Weights
Seating CapacitiesCapacities
Engine 172.3 in (4,377 mm)
66.7 in (1,695 mm)
56.2 in (1,427 mm)
100.4 in (2,550 mm)
58.3 in (1,481 mm)
58.0 in (1,472 mm)
Length
Width
Height
Wheelbase
Track
Gross vehicle weight rating See the certification label attached
to the driver’s doorjamb. 3.4 US qt (3.2
)
3.2 US qt (3.0)
4.0 US qt (3.8)
Total
Front
Rear 5
2
3
Excluding the oil remaining in the engine Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity: 0.116 US gal (0.44
)
2.6 US qt (2.5
)
4.76 US qt (4.50)
Fuel tank
Engine
coolant
Engine oil
Automatic
transmission
fluid (CVTF)
Windshield
washer
reservoir
Type
BorexStroke
Displacement
Compression ratio
Spark plugs 10.8 : 1
82 cu-in (1,339 cm
)
2.87 x 3.15 in (73.0 x 80.0 mm) 3.0 US qt (2.8
)
5.5 US qt (5.2)
10.6 US gal (40
)
1.165 US gal (4.41)
1.295 US gal (4.90)
Water cooled 4-stroke SOHC i-VTEC gasoline engine with Hybrid Electric Motor
DILFR6J11
Front
Rear
Approx.
1:
2: Change
Total
Change
Including filter
Without filter
Total
Change
Total
U.S. Vehicles
Canada Vehicles
(NGK)
1
2
12/07/13 17:24:52 31TM8630_385
Technical Inf ormationTOC
2014 Insight

CONT INUED
BatteryCharging System ...........................
Indicator .63, 364
............................
Jump Starting .358
..............................
Maintenance .344
............................
Specif ications .381
..............................
Bef ore Driving .243
....................................
Belts,Seat .9,21
...........................
Beverage Holder .154
.......
Bluetooth
HandsFreeLink. 225
Brakes ...........
Anti-lock System (ABS) . 287
.............
Break-in, New Linings . 244
....................
Bulb Replacement .330
...........................................
Fluid .319
...................
Pad Wear Indicator . 286
.......................................
Parking .151
...........
System Indicator . 63, 64, 366
....................................
Accessories .254
ACCESSORY (Ignition Key .....................................
Position) .131
.............
Accessory Power Socket . 155
................
Active Head Restraints . 144
....................
Additives, Engine Oil . 311
.............................
Airbag (SRS) .10, 25
...
Airbags, Additional Information . 25
...
Additional Safety Precautions . 37
..........
AdvancedAirbagSystem . 30
.............................
Airbag Service .36
How the Passenger Airbag Of f ......................
Indicator Works .35
How the Side Airbag Of f ......................
Indicator Works .34
..
How the SRS Indicator Works . 34
How Your Front Airbags .........................................
Work .28
...
How Your Side Airbags Work . 32
How Your Side Curtain Airbags .........................................
Work .33
........................
SRS Components .25
..............
Air Conditioning System . 162
.......................
Air Pressure, Tires .339 ................................
Ambient Meter .72
......................................
Antif reeze .315
Anti-lock Brakes (ABS) ...............................
Indicator .64, 287
...................................
Operation .287
..............
Anti-thef t, Audio System . 219
Anti-thef t Steering Column ............................................
Lock .131
..........................................
Armrest .146
................................
Audio System .168
.......................
Auto Door Locking .109
...................
Auto Door Unlocking . 110
................................
Auto Idle Stop .281
...
Automatic Seat Belt Tensioners . 23
.............
Automatic Speed Control . 222
.
Automatic Transmission (CVT) . 271
..........................
Capacity,Fluid .380
...............
Checking Fluid Level . 318
Paddle Shif ters in the ..............................
D Position .276
Paddle Shif ters in the ...............................
S Position .279
.....
Recommended Shif t Points . 280
.......................................
Shif ting .272
Shif t Lever Position ...............................
Indicators .271 ................
Shif t Lever Positions . 273
....................
Shif t Lock Release . 275
......................
Auxiliary Input Jack .218
I
12/07/23 10:21:22 31TM8630_404
IndexA B C D E F G H I J K L M N O P Q R S T U V W X Y Z
A
B
2014 Insight