2014 HONDA CIVIC COUPE ignition

393Continued
Handling the Unexpected
If a Tire Goes Flat
Changing a Flat Tire
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then, stop in a safe plac e. Replace the flat tire with a compact
spare tire. Go to a dealer as soon as possib le to have the full-size tire repaired or
replaced.
1. Park the vehicle on firm, level, and non-slippery surface, and apply the parking
brake.
2. Put the shift lever in
(P.
2. Put the shift lever in
(R.
3. Turn on the hazard warning lights an d turn the ignition switch to LOCK
(0*1.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Changing a Flat Tire
Periodically check the tire pressure of the compact
spare. It should be set to the specified pressure.
Specified Pressure: 60 psi (420 kPa, 4.2 kgf/cm
2)
When driving with the compact spare tire, keep the
vehicle speed under 50 mph (80 km/h). Replace with
a full-size tire as soon as possible.
The compact spare tire and wheel in your vehicle are
specifically for this model. Do not use them with
another vehicle. Do not us e another type of compact
spare tire or wheel with your vehicle.
Do not mount tire chains on a compact spare tire.
If a chain-mounted front tire goes flat, remove one of
the full-size rear tires and replace it with the compact
spare tire. Remove the flat front tire and replace it
with the full-size tire that was removed from the rear.
Mount the tire chains on the front tire.
Automatic transmission (CVT) models
Manual transmission models
All models
14 CIVIC 2D_SI-31TS86210.book 393 ページ ２０１４年１月２９日　水曜日　午後８時９分

406
Handling the Unexpected
Shift Lever Does Not Move
Follow the procedure below if you cannot move the shift lever out of the (P
position.
1.Set the parking brake.
2. Remove the key from the ignition switch.
2. Remove the built-in key from the smart
entry remote.
3. Wrap a cloth around the tip of a small flat-
tip screwdriver. Put it into the shift lock
release slot as shown in the image, and
remove the cover.
4. Insert the key into the sh ift lock release slot.
5. While pushing the key in, press the shift
lever release button and place the shift lever
into
(N.
u The lock is now released. Have the shift
lever checked by a dealer as soon as
possible.
■Releasing the Lock
Automatic transmission (CVT) models
Slot
Cover
Models without smart entry system
Models with smart entry system
All models
Release
Button
Shift Lock
Release Slot
14 CIVIC 2D_SI-31TS86210.book 406 ページ ２０１４年１月２９日　水曜日　午後８時９分

413Continued
Handling the Unexpected
Fuses
Fuse Locations
If any electrical devices are not working,
turn the ignition switch to LOCK
(0*1 and
check to see if any appl icable fuse is blown.
Located near the brake fluid reservoir. Push
the tabs to open the box.
Fuse locations are shown on the fuse box
cover. Locate the fuse in question by the
fuse number and box cover number.
■Engine Compartment Fuse Box
■Circuit protected and fuse rating
Circuit ProtectedAmps
1
EPS70 A
−(40 A)
ABS/VSA Motor30 A
ABS/VSA FSR30 A
Wiper Motor*2
−*330 A
(30 A)
Main Fuse100 A
2
IG Main30 A*2
50 A*3
Fuse Box Main 60 A
Fuse Box Main 260 A
Headlight Main 30 A
ST MG Switch*2
−*330 A
(30 A)
Rear Defogger 40 A IG Main 2
*2
−*330 A
(30 A)
Blower 40 A −(30 A)
Sub Fan Motor 20 A
Main Fan Motor 20 A
3−−
4 −*2
Left Headlight Low Beam*3−
15 A
5START DIAG*2
ST MG*37.5 A
7.5 A
6 −
*2
Right Headlight Low Beam*3−
15 A
7−−
8− −
*1:Models with the smart entry system have an ENGINE START/STOP button
instead of an ignition switch.
*2:Models with smart entry system
*3:Models without smart entry system
9−−
10 − −
11Oil Level7.5 A
12 Fog Lights*(20 A)
13−−
14 Hazard 10 A
15FI Sub15 A
16 IG Coil 15 A
17Stop15 A
18 Horn 10 A
19Premium Amp*(20 A)
20 Right Headlight Low Beam*2
−*315 A
−
21IGP15 A
22 DBW 15 A
23Left Headlight Low Beam*2
Headlight Low Beam*315 A
20 A
24 − −
25MG Clutch7.5 A
26 Washer*2
−*315 A
−
27SMALL20 A
28 Interior Lights 7.5 A
29Backup10 A
Circuit ProtectedAmps
* Not available on all models
14 CIVIC 2D_SI-31TS86210.book 413 ページ ２０１４年１月２９日　水曜日　午後８時９分

415
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK (0*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fu ses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with on e that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 413 to 414.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown Fuse
Fuse Puller
14 CIVIC 2D_SI-31TS86210.book 415 ページ ２０１４年１月２９日　水曜日　午後８時９分

425Continued
Information
Emissions Testing
Testing of Readiness Codes
Your vehicle has “Readiness Codes,” as part of the onboard self diagnostic system.
Some States use these codes as a test to see if your vehicle's emissions components
are working properly.
The codes may not be read properly if testing is performed just after the battery has
gone dead or been disconnected.
To check if they are set, turn the ignition switch to ON
(w*1, without starting the
engine. The malfunction indicator lamp will co me on for several seconds. If it then
goes off, the readiness codes are set. If it blinks five times, the readiness codes are
not set.
If you are required to have your vehicle te sted before the readiness codes are ready,
prepare the vehicle for retest ing by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engi ne off for six hours or more.
3. Make sure the ambient temperature is between 40 °F and 95 °F (4 °C and 35 °C).
4. Start the engine without touching the ac celerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in
(P (CVT) or (N (manual transmission). Increase the engine
speed to 2,000 rpm, and hold it there for about three minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Testing of Readiness Codes
The readiness codes are erased when the battery is
disconnected, and set again onl y after several days of
driving under a variety of conditions.
If a testing facility determines that the readiness
codes are not set, you may be requested to return at
a later date to complete the test.
If the testing facility determines the readiness codes
are still not set, see a dealer.
14 CIVIC 2D_SI-31TS86210.book 425 ページ ２０１４年１月２９日　水曜日　午後８時９分

434
Index
Fuel Fill Door....................................... 17, 333
Fuses .......................................................... 413
Inspecting and Changing ......................... 415
Locations ......................................... 413, 414
G
Gasoline (Fuel) Economy ................................................. 335
Gauge ....................................................... 81
Information ............................................. 332
Instant Fuel Economy ........................... 81, 86
Low Fuel Indicator ..................................... 69
Refueling ................................................. 332
Gauges ......................................................... 81
Gear Shift Lever Positions
Automatic Transmission (CVT) ......... 305, 307
Manual Transmission ............................... 312
Glass (care) ................................................ 388
Glove Box .................................................. 147
H
Halogen Bulbs ........................................... 364
Handling the Unexpected ........................ 391
HandsFreeLink® (HFL)....................... 233, 264
Automatic Import of Ce llular Phonebook and
Call History .................................... 249, 276
Automatic Transferring ............................ 247
Caller’s ID Information ............................. 247
Displaying Messages ........................ 260, 285 HFL Buttons..................................... 233, 264
HFL Menus ...................................... 235, 266
HFL Status Display ........................... 234, 265
Limitations for Manual Operation ............ 234
Making a Call .................................. 253, 279
Options During a Call ...................... 258, 282
Phone Setup.................................... 240, 270
Receiving a Call ............................... 257, 282
Receiving a Text Message/E-mail...... 259, 283
Ring Tone................................................ 275
Selecting a Mail Account ......................... 284
Speed Dial ....................................... 250, 277
Text Message .................. 245, 259, 274, 283
To Clear the System ................................ 248
To Create a Security PIN .......................... 246
To Set Up a Text Message/E-mail
Options ......................................... 245, 274
Hazard Warning Button .............................. 2
Head Restraints ........................................ 139
Headlights ................................................. 127
Aiming .................................................... 360
Automatic Operation............................... 128
Dimming ......................................... 127, 130
Operating................................................ 127
Heaters (Seat) ........................................... 151
Heating and Cooling System ................... 152
Cooling ................................................... 154
Defrosting the Windshield and
Windows ............................................... 154
Dust and Pollen Filter............................... 384
Heating ................................................... 153 HFL (HandsFreeLink
®) ...................... 233, 264
High Beam Indicator .................................. 73
Hill Start Assist System ..................... 299, 302
I
Identification Numbers ............................ 422
Engine and Transmission ......................... 422
Vehicle Identification............................... 422
Ignition Switch ......................................... 122
Illumination Control ................................ 132
Knob ...................................................... 132
i-MID ........................................................... 83
Immobilizer System .................................. 116
Indicator ................................................... 74
Indicators .................................................... 66
Anti-lock Brake System (ABS) .................... 69
Brake System (Amber) ............................... 66
Charging System............................... 67, 409
CRUISE CONTROL ............................. 75, 316
CRUISE MAIN.................................... 75, 315
Door Open.......................................... 29, 71
ECON Mode ..................................... 75, 314
Electric Power Steering (EPS) System ............................................ 72, 411
Fog Light .................................................. 73
High Beam ................................................ 73
High Temperature ..................................... 70
Immobilizer System ................................... 74
i-VTEC ................................................ 75, 82
Lights On .................................................. 73
14 CIVIC 2D_SI-31TS86210.book 434 ページ ２０１４年１月２９日　水曜日　午後８時９分