2014 FORD POLICE INTERCEPTOR UTILITY height adjustment

Introduction 8
Child Safety 17
Child seat positioning...................................19
Booster seats.........................................21
Installing child seats....................................24
Child safety locks......................................34
Safety Belts 35
Fastening the safety belts................................37
Safety belt height adjustment.............................40
Safetybeltwarninglightandindicatorchime..................41
Safety belt-minder.....................................41
Child restraint and safety belt maintenance...................44
Personal Safety System 45
Supplementary Restraints System 46
Driver and passenger airbags.............................48
Front passenger sensing system...........................50
Side airbags..........................................53
Safety canopy curtain airbags.............................54
Crash sensors and airbag indicator.........................56
Airbag disposal........................................64
Keys and Remote Control 65
General information on radio frequencies.....................65
Remote control.......................................65
Locks 69
Locking and unlocking..................................69
Trunk release.........................................72
Interior luggage compartment release.......................74
Table of Contents1
2014 Police(pol)
Owners Guide gf, 3rd Printing, September 2013
USA(fus)

SAFETY BELT HEIGHT ADJUSTMENT
WARNING:Position the safety belt height adjusters so that the
belt rests across the middle of your shoulder. Failure to adjust
the safety belt properly could reduce the effectiveness of the seat belt
and increase the risk of injury in a crash.
•Sedan
•Utility
Your vehicle has safety belt height adjustments for the front outboard
seating positions.
1. Adjust the height of the shoulder belt so the belt rests across the
middle of your shoulder.
2. Slide the adjuster up to raise the belt and push the button and slide it
down to lower the belt.
40Safety Belts
2014 Police(pol)
Owners Guide gf, 3rd Printing, September 2013
USA(fus)

ADJUSTING THE HEADLAMPS
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, an authorized dealer should
check the alignment of your headlamps.
Vertical Aim Adjustment
1. Park the vehicle directly in front of a wall or screen on a level surface,
approximately 25 feet (7.6 meters) away.
•(1) 8 feet (2.4 meters)
•(2) Center height of lamp to
ground
•(3) 25 feet (7.6 meters)
•(4) Horizontal reference line
2. Measure the height of the headlamp bulb center from the ground and
mark an 8 foot (2.4 meter) horizontal reference line on the vertical wall
or screen at this height.
3. Turn on the low beam headlamps to illuminate the wall or screen and
open the hood.
To see a clearer light pattern for adjusting, you may want to block the
light from one headlamp while adjusting the other.
On the wall or screen you will
observe a flat zone of high intensity
light located at the top of the right
hand portion of the beam pattern.
If the top edge of the high intensity
light zone is not at the horizontal
reference line, the headlamp will
need to be adjusted.
242Maintenance
2014 Police(pol)
Owners Guide gf, 3rd Printing, September 2013
USA(fus)