2014 FORD MUSTANG ignition

1Headlamp Controls
: Turns the headlamps off. : Turns on parking, instrument panel, license plate and
tail lamps.
: Turns on headlamps.: Autolamps*
Automatically turns the exterior lamps on/off based on
available daylight.
: Pull toward you to turn on the fog lamps*. Note: Y our Mustang has special signature lighting that will normally
be illuminated to give your vehicle its unique character. This feature
is disabled when the vehicle is in P (Park) or when the parking brake
is engaged .
2Cruise Control
To set your cruise control speed:
1. Press the ON control up and release.
2. Accelerate to the desired speed.
3. Press the SET control up and release, then take your foot
off the accelerator. After your speed has been set, you can
press SET +/- to adjust the cruise speed. To disable, press
the OFF control down.
3Information Display Controls
Provides information about various systems on your vehicle.
Use the left-hand, 5-way controls located on the steering
wheel to choose and confirm settings and messages. Refer
to the Information Displays chapter in your Owner’s Manual
for more information.
4Service Engine Soon Light
Illuminates briefly when the ignition is turned on. If
it remains on or is blinking after the engine is started, the
on-board diagnostics system (OBD-II) has detected a
malfunction. Drive in a moderate fashion and contact
your authorized dealer as soon as possible.
5Throttle Control/Transmission Light
Illuminates when a powertrain fault is detected. If
the light remains on or continues to come on, contact
your authorized dealer as soon as possible.
6Steering Wheel Audio Controls
VOL +/- : Press to increase/decrease volume levels. : Press to access the previous/next radio station,
cD track or preset satellite radio channel.
: Press repeatedly to access all possible media sources. : Press to access SYnc® voice recognition*. : Press to access SYnc® phone features*.
7Heated Exterior Mirrors*
If your vehicle is equipped with heated exterior mirrors they
will be activated once the rear windshield defrost has been
turned on.
4/ 2014 mustang /Quick RefeRence Guide
1
Instrument Panel
2
6
*if equipped
3
2014 mustang /Quick RefeRence Guide /5
4
5
7

SYNC is a hands-free, voice recognition system used for entertainment, information and communication.
SYNC…Say the word.
6/2014 mustang /Quick RefeRence Guide
Why do I need a SYNC owner account?
A SYnc owner account is required for Vehicle Health Report
activation and the ability to view your reports online. You’ll
also be able to take advantage of all of SYnc ’s Services and
personalization features, such as saving your Favorites and
Points of Interest (POI). You’ll receive the latest software
updates that add new places, directions and information;
and if you have questions, you’ll get free customer support.
Some services may not be available in your area. c reate
your account by visiting the website or calling the toll-free
number for more information. See the inside front cover of
this guide for details.

Using my phone with SYNC
Note: Enter your phone book contacts with both first and last
names to increase SYnc ’s ability to select the correct contact.
Remember to say the contact name exactly as it is listed in your
phone book.

Making a phone call:
Use SYnc to make a phone call to anyone in your phone
book by pressing voice button
and when prompted, give
a voice command.
For example, you could say “Call Jake Smith at home”. SYnc
repeats the command back to you and dials the number.
Note: You can also make phone calls by pressing the voice
button and when prompted, say the voice command
“ Dial”, then verbally say the phone number.
Answering incoming calls:
Whenever you have an incoming call, you will be able
to see the name and number of the person calling in
your display. Press the phone button
to answer an
incoming call. You can hang up at any time by pressing
and holding the phone button
.
Do not disturb mode:
This feature blocks incoming calls and text messages, and
saves them for later. You still have access to outgoing calls
when this feature is active. Say the voice command, “Do not
disturb on” to enable and “Do not disturb off” t o disable.
Using SYNC to access digital media
Plug in your USB media devices, such as phones and MP3
players, and use SYnc to play all of your favorite music.
Using voice commands to play music:
1. Plug your media player into your USB port.
2. Press the voice button
. When prompted say “USB ”,
then follow-up by saying one of the voice commands.
3. You will hear the command repeated back to you and the
selected item will play.
Getting Started with your SYNC® System
Before you get started
1. Set up your owner account at SyncMyRide.com (U.S.)
or SyncMyRide.ca ( canada). Register by following the
on-screen instructions. After registering you can see
what complimentary services you are eligible for.
2. SYnc uses a wireless connection called
Bluetooth®
to communicate with your phone. Turn Bluetooth
mode on in your phone’s menu options. This lets
your phone find SYnc . If you need more details
on setting up your phone to work with SYnc ,
visit SyncMyRide.com (U.S.) or SyncMyRide.ca
( c anada), or your phone manufacturer’s website.
Pairing your phone with SYNC
In order to use many of the features of SYnc such
as making a phone call, receiving a text or using SYnc
services, you must first connect or pair your phone
with SYnc .
To pair your phone for the first time:
1. Make sure that your vehicle is in (P) Park and your
ignition and radio are turned on.
2. Press the phone button
. When the display indicates
No Phone Found, press OK. 3.
When Add Bluetooth
Device? appears in the
display press OK.
4. When Find SYNC appears
in the display press OK.
When prompted on your
phone’s display, enter the
PIn provided by SYnc into
your phone.
5. The display will indicate
when the pairing
is successful.
Note: The system may prompt
you to:
• Set your phone as primary/
favorite (the primary phone
will receive messages and
voice mails).
• Download your phone book
(this is required to use the full
set of voice commands).
• Turn on 911 Assist
®. Tips:

•
To pair subsequent
phones, please refer to
Pairing Subsequent Phones
in the SYNC chapter of
your Owner’s Manual.
• If you are experiencing
pairing problems, try
performing a clean
pairing by deleting your
services from SYnc
and deleting the SYnc
connection from your
phone; then repeat
the process.
• Make sure that there
are no security features
active on your phone
preventing you from
connecting to SYnc .
2014 mustang/Quick RefeRence Guide /7

8/2014 mustang /Quick RefeRence Guide
Convertible To p*
Using your convertible top
Do not store articles behind the rear seat. Articles
stored in the convertible top stowage compartment
may break the rear glass window when the top is
lowered. The windows automatically lower when
lowering or raising the top. Do not lower the top when
the top material is wet. Remove any leaves or debris
on the outer surface of the top. The convertible top
will not operate unless the vehicle is stationary or
traveling under 3 mph (5 km/h).
Opening the convertible top
Note: Your ignition must be on to open the top. It is
recommended that your engine is running to prevent
draining the battery.
To open the top:
1. Bring the vehicle to a complete stop.
2. Unclamp the latches located where the top meets
the windshield header. To do this, pull down the
latch handles and rotate them rearward until the
latches clear the windshield header.
3. Press and hold the convertible top control
on the overhead console until the windows come
all the way down and the top is completely stored.
Using the convertible top boot*
Make sure the boot is always fully secured before
driving. Improper installation of the boot can result
in the loss or damage of the boot. For information
on installing the boot, removing the boot, and
storing the boot, see the Using the Boot section of
your Owner’s Manual.
Closing the convertible top
Note: The ignition must be on to close the top. It is
recommended that your engine is running to prevent
draining the battery.
To close the top:
1. Bring the vehicle to a complete stop.
2. Press and hold the convertible top control. The
windows will lower completely. The top will
unfold and move forward until it is completely
flush with the windshield header.
Note: Make sure that the latch handles are pulled
down and are in the fully opened position before
the top makes contact with the windshield header.
This allows for hand clearance and proper closure
of the top.
3. Pull down on the driver’s latch handle and
rotate it all the way forward into the
windshield header.
4. Press the latch handle up into the original
stowed position.
5. Pull down on the passenger’s side latch
handle and rotate it all the way forward into
the windshield header.
6. Press the handle up to the original
stowed position.
7. close the rear windows before closing the
front windows.
Note: If the top has been open for an extended period
of time or if the temperature is low, the top material
may shrink slightly. If this happens, pull on the latch
handles or the center grip to fasten to the top.
For more complete information, refer to the
Convertible Top chapter in your Owner’s Manual.
*if equipped
2014 mustang /Quick RefeRence Guide /9
*if equipped

10/2014 mustang /Quick RefeRence Guide
Universal Garage Door Opener*
The HomeLink® universal transmitter is located
on the driver’s visor. It can replace your hand-held
garage door opener and other remote devices.
To program the system, switch the ignition on and:
1. Hold the garage door hand-held transmitter 1 - 3 inches
(2 - 8 centimeters) away from the HomeLink button you
want to program.
2. Press and hold the HomeLink and transmitter buttons
until the indicator light flashes rapidly, then release.
3. On your garage door opener motor, press the learn button.
4. Return to your car. Press and hold the HomeLink button
for 2 seconds, then release. Repeat. Depending on
your garage door opener, you may need to repeat this
sequence a third time.

For more details, visit homelink.com, call
1-800-355-3515 or refer to your Owner’s Manual.
Convenience
Integrated Keyhead Transmitter
> Press once to lock all doors. Press
again within three seconds to confirm all
doors are locked.
> Press
once to unlock the driver’s door.
Press again within three seconds to
unlock all doors.
> Press
to activate the panic alarm.
Press again or turn on the ignition
to deactivate.
> c ar finder: Press
twice within three
seconds to locate your vehicle. The horn
will chirp and the lamps will flash.
> Press
twice within three seconds to
open the trunk.
Adjustable Steering Feel
Using the information display screen and the 5-way
steering wheel controls, choose between Standard,
Sport and Comfort steering feel option modes. The Sport
setting requires a slightly increased steering effort. The
Comfort steering feel requires less effort to steer the
vehicle. The Standard mode is the factory default setting.
Navigation*
The mobile media navigation system allows you to
record CDs, listen to your saved music, play DVDs and
access climate control options in addition to navigating
the vehicle. Refer to the Navigation chapter of your
Owner’s Manual for more information.
*if equipped
2014 mustang /Quick RefeRence Guide /1 1
Rear Seats/Head Restraints
Your vehicle is equipped with
second row outboard non-
adjustable head restraints.
The head restraints can be
rotated forward to improve
rear vision when there are no
rear occupants.
2nd row seat/split-folding rear seats*
One or both rear seat backs (coupe only) can be
folded down to provide additional cargo space.
To lower the seat back(s) from inside the vehicle,
be sure the head restraint is in the upright position,
pull the strap to release the seat back and then
fold the seat back down. When raising the seat
back(s), make sure you hear the seat latch into
place. Pull down on the seat back to ensure
that it has latched.
Pony Projection Lights*
When you open the doors or press the unlock icon
on the keyfob, the Mustang logo will be projected
on the ground from the bottom of the outside
mirror. Clean the bottom of the mirrors regularly
with a soft cloth to remove any mud/dirt/ice so
the image displays clearly.