2014 FORD FOCUS ELECTRIC door lock

1
2
3
4
5
6
7
8
CR
uiSE C ontRoL
To Set y our Cruise Control Speed
1.
Press and release on.
2. Accelerate to the desired speed.
3. Press and release SEt+, then take your foot off
the accelerator.
After you set your speed, you can adjust your
cruise speed by pressing and releasing SEt +/- .
To disable, press and release oFF.
LEFt VEhiCLE inF oRMAtion DiSPLA y
Provides specific information about various
systems on your vehicle including the status of your
high-voltage battery and the other unique features of
your electric vehicle.
Use the left-hand, 5-way controls located on the
steering wheel to choose and confirm settings and
messages. Refer to the Instrument Cluster chapter of
your Owner’s Manual for more information.
SERViCE VEhiCLE Soon LiGht
Illuminates when a powertrain or high-voltage
charge system fault has been detected. If the
indicator stays on or continues to come on, contact
your authorized dealer as soon as possible.
tiL t/tELESC oPE StEERinG CoL uMn
Unlock the steering wheel by pulling the lever down.
Adjust the steering wheel to the desired position.
Push the lever up to lock the steering wheel in place .
RiGht VEhiCLE inFoRMAtion DiSPLA y
Displays information about Entertainment, Phone,
Navigation* and Surplus. Use the right hand 5-way
controls located on your steering wheel to scroll
through, highlight and make minor adjustments
within a selected menu. Refer to the MyFord Touch
®
chapter in your Owner’s Manual for
more information.
MEDiA StEERinG whEEL ContR oLS
Press + to increase or – to decrease volume levels.
Pull toward you to access voice recognition.
Press to answer an incoming phone call.
Press to end a phone call and exit phone mode .
PuSh Button St ARt–READ y to DRiVE
note: Your intelligent access key must be inside the vehicle
to put the vehicle in “Ready to Drive” mode . The keyless
warning alert sounds when you open the driver’s door and
your vehicle is in RUN.
Allows you to go into “Ready to Drive” mode by
pressing the P owER StAR t/S toP button while
fully pressing down on the brake pedal. A green
“Ready to Drive” indicator light
will appear in the
instrument cluster after you start the vehicle. This
lets you know that the vehicle is turned on and ready
for driving. Press the P owER StAR t/S toP button
again to turn the vehicle off .
hAzARD ContR oL–unL oCK/LoCK
1
3
4
6
8
Instrument Panel
2
7
5
*if equipped67

Convenience
REMotE EntRy iConS
• Press once to lock all doors. Press again within three
seconds to confirm all doors are locked.
• Press
once to unlock the driver’s door. Press again
within three seconds to unlock all doors.
• Press
to activate the panic alarm. Press again or
switch the ignition on to deactivate.
• Press
twice within three seconds to release the
liftgate latch.
• Car finder: Press
twice within three seconds to locate
your vehicle. The horn will sound and the turn signals
will flash.
intELLiGEnt A CCESS KEy
note: Your intelligent access key must be within 3 feet (1 meter)
of the vehicle for intelligent access to function properly.
To unlock the driver’s door, pull the front exterior door
handle. To lock the doors, press the sensor button on
the door handles. To unlock and open the liftgate, press
the exterior liftgate release button near the license plate.
The intelligent access
key also contains a
mechanical key blade
which can be used to
unlock the driver door,
if necessary.
REMotE StARt
Remote start allows you to start the vehicle from outside
the vehicle using your key. To start, press and then press twice within three seconds. Once inside, apply the
brake while pressing the P owER StAR t/S toP button.
Shift into D (Drive) and go. To turn the vehicle off from
outside the vehicle after using your remote start,
press
once.
note: It is also possible to turn your vehicle on and off using the
MyFord® Mobile application on your smartphone.
ChARGinG y ouR VEhiCLE
Your vehicle must be in P (Park) to charge. Press the
indentation located on the charge port door and the
door will rotate open. Plug the charging coupler into the
vehicle’s charge port receptacle and make sure that the
button “clicks” confirming that it is completely engaged.
• When the vehicle detects the connection, each quadrant
of the light ring will flash in a clockwise manner two full
times (indicating the start of a normal charge cycle).
• When you are done charging your vehicle, press the
button on the charging coupler and remove it from the
charge port receptacle.
• Close the charge port door by
pressing and holding the indentation
on the door until the door rotates
counterclockwise and closes. See
your Owner’s Manual for complete
information on charging
your vehicle.
1213
EntER tAinMEnt
No matter how you store your music, SYNC makes it yours
to enjoy when you’re behind the wheel. Press the lower-left,
red corner of the touchscreen. From here, you can easily go
between AM/FM, CD, USB and other media sources.
Set y our Radio Presets
• Touch the Entertainment corner on the touchscreen.
• Touch FM.
• Touch Direct Tune.
• Enter the desired station and touch Enter.
• Touch Presets , and then touch and hold one of the
memory preset buttons to save it. The sound will mute
briefly and return once the station is saved.
uSinG S ynC to A CCESS DiGit AL MEDiA
Plug in your USB media devices, such as phones and MP3
players, and use SYNC to play all of your favorite music. using Voice Commands to Play Music
1.
Plug your media player into your USB port.
2. Pull the voice control
. When prompted, say “USB”,
then follow-up by saying one of the voice commands.
SuRPL uS MoDE
In Surplus mode, either butterflies or a gauge represents
your surplus or status. The number of butterflies matches
the current surplus or status distance, with a maximum of
16 butterflies.
• If you entered your next charge destination in the
navigation system and you see butterflies on your screen,
then you should be able to make your destination, and you
have a Surplus.
• If you see butterflies but did not enter your next charge
destination, then you should be able to achieve the range
estimate shown at the start of your drive, and you have a
positive Status.
See the Instrument Cluster chapter in your Owner’s Manual
for more information.