2014 FORD EXPEDITION reset

engine overheat fuse box cabin filter sport mode fuel type fog light

Page 2 of 8

FORD EXPEDITION 2014 3.G Quick Reference Guide COMMONLY USED SYNC® VOICE COMMANDS
Basic Commands • What can I say?
• List of commands
• Main menu
• Previous
• Next
• Go back
• Exit
• Help
• Vehicle heal

Page 3 of 8

FORD EXPEDITION 2014 3.G Quick Reference Guide page 5 page 4
INSTRUMENT PANEL
*if equipped
6
12
34
5
78
1
2
3
4
5
6
7
8

LighTing C
OnTROL Turns the headlamps off. Turns on the parking lamps. Turns on the headlamps. Autolamps:
Au

page 5 page 4
INSTRUMENT PANEL
*if equipped
6
12
34
5
78
1
2
3
4
5
6
7
8

LighTing C
OnTROL Turns the headlamps off. Turns on the parking lamps. Turns on the headlamps. Autolamps:
Automatically turns the
exterior lamps on/off based
on available daylight.
Turns on fog lamps by
pulling the control
toward you.
WinDShiELD WiPERS/
WAShERS
Rotate the end of the control
away from you to increase the
wiper speed and toward you to
decrease the wiper speed.
Press the end of the stalk
• Quickly for a single swipe
without fluid
• Hold briefly for three swipes
with washer fluid
• Hold for a longer
wash cycle.
To operate your rear
window wiper
Rotate the rear wiper control
to 1 (intermittent speed), 2
(normal speed) or O (off). For
a rear wash cycle, rotate and
hold the rear wiper control to
either
position. Note:
For optimal wiper
performance, clean your blades
and glass regularly.
Refer to your Owner’s Manual
for more information.
ABS W ARning LighTIlluminates briefly when
the ignition is turned on. If
it illuminates when you are
driving, this indicates a
malfunction. You will continue
to have the normal braking
system (without ABS) unless
the brake warning lamp

is also illuminated. Have
the system checked by your
authorized dealer.
SERViCE EnginE
SOOn LighT
Illuminates briefly when
the ignition is turned on. If
it remains on or is blinking
after you start the engine,
the On-Board Diagnostics
(OBD-II) system has detected
a malfunction. Drive in a
moderate fashion (avoid heavy
acceleration and deceleration)
and contact your authorized
dealer as soon as possible.
inFORMATiOn DiSPLAYThe information display
provides important vehicle
information through a constant
monitoring of vehicle systems.
The system will notify you of
potential vehicle problems by
displaying system warnings
followed by a long indicator
chime. For more information
about your vehicle’s functions,
please see your Owner’s Manual.
ADJUSTABLE PEDALS
Let you move your brake and
accelerator pedals closer.
Located to the left of your
steering column, press the
arrow to move the pedals
closer to you, or the to move
the pedals farther away from
you. The pedals should only be
adjusted when the vehicle is
stopped and in P (Park).
CRUiSE COnTROL
To set the speed
1. Press and release On.
2. Accelerate to the
desired speed.
3. Press SET+ and take your
foot off the accelerator.
•
To set a higher or lower
speed, press and hold
SET+/SET- or press
SET+/SET- repeatedly
until you reach the
desired speed.
• To cancel a set speed, tap
the brake pedal. The set
speed will not be erased.
• To return to a previously
set speed, press RES .
• To turn off, press OFF or
turn off the ignition.
STEERing WhEEL
COnTROLS
Press VOL+/VOL- to
increase/decrease your
volume level.
Press
to access
the previous/next radio station,
CD track or preset satellite
radio channel.
Press MEDiA repeatedly
to access all possible
media sources.
Press VOiCE* to access
voice recognition.
Press
to access SYNC®
phone features.

Page 8 of 8

FORD EXPEDITION 2014 3.G Quick Reference Guide naViga Tion SYSTem*
Set your destination by using your
touchscreen or voice commands.
To program a destination using
the touchscreen
1. Press the DEST button and “Accept” when
the “Terms

naViga Tion SYSTem*
Set your destination by using your
touchscreen or voice commands.
To program a destination using
the touchscreen
1. Press the DEST button and “Accept” when
the “Terms of Use” screen appears.
2. Select from the following:
a. Quick: allows you to cancel the route,
access emergency destinations (such as
police stations or hospitals), save your
favorite destinations to presets for quick
access, find the nearest point of interest
(POI), and recall a previous destination
or entry from your address book to set
as a current destination.
b. Standard: allows you to set a
destination using any of the following:
i. Address Book
ii. Previous Destination
iii. Phone Number
iv. Map
v. Street Address
vi. POI
vii. Freeway Exit/Entrance or
Intersection
c. Edit Route: allows you to make any
adjustments to the currently selected
navigation route such as:
FUNCTION
page 15 page 14
i. Cancel
ii. Detour
iii. View Route
iv. Edit Route Preferences
v. Edit Traffic Preferences
vi. Edit Destination/Way Points
vii. Edit Turn List
Note: Periodic map updates are available at an additional cost.
Call 1-800-NAVMAPS (in Mexico, call 01-800-557-5539)
or visit www.navigation.com/ford.
rear View camera*
The rear view camera system is located on the liftgate
and provides a video image of the area behind the
vehicle. The display will automatically appear on the
navigation system screen* or in the rearview mirror
whenever the vehicle is in R (Reverse) and uses colors
(green, yellow and red) to alert you of your proximity
to objects.
forward and reVerSe SenSing SYSTemS*
If your vehicle is equipped with forward and reverse sensing systems, they may warn you
if there is an object in front of or behind the vehicle. The system will sound a warning tone
that increases in frequency as the object gets closer and will sound continuously when the
object is less than 10 inches away.
Note: Visibility aids do not replace the need to watch where the vehicle is moving. Refer to
your Owner’s Manual for safety information, more details and limitations.
UniVerSaL garage door oPener*
Your driver’s side visor has a built-in wireless transmitter that replaces the common hand-
held garage door opener. This system can also be programmed to security systems, entry
gates and home or office lighting. Refer to the Universal Garage Door Opener chapter in
your Owner’s Manual for programming instructions.
*if equipped

oil pressure ad blue engine oil engine overheat homelink fuse box location