Downloaded from www.Manualslib.com manuals search engine Vehicles With Push Button Start
Potential CausesCondition
The key is not in the backup position.I cannot create a MyKey.
An admin key is present when you switch the ignition on.There are no MyKeys programmed to your vehicle.There are no MyKey drivingmodes.
LOCKING AND UNLOCKING
UnlockA
LockB
LiftgateC
Double Locking With the RemoteControl
Press button B twice within three seconds.
Liftgate
Press button C twice within three seconds.
Power Door Locks
•Press the power door lock button on theinstrument panel once. The doors willlock.
•Press the button again. The doors willunlock.
SLIDING DOOR
When the rear doors are fully open, makesure that you do not step on the cable ormechanism at the base of the dooraperture.
KEYLESS ENTRY
Locking Your Vehicle
Locking buttons are located on each of thefront doors.
4B-MAX (CB2) Vehicles Built From: 25-06-2012, Vehicles Built Up To: 03-05-2015, CG3574en enGBR, Edition date: 02/2014, Second Printing
Downloaded from www.Manualslib.com manuals search engine Note:Vehicles with push button start: Brieflypress the button.
3.Start the engine.
Vehicles With a Diesel Engine
Note:Engine cranking will not commenceuntil the engine glow plug indicator hasextinguished. This may take several secondsin extremely cold conditions.
Stopping the Engine When YourVehicle is Moving - Vehicles WithPush Button Start
1.Press and hold the button for at leastone second or press it three times withintwo seconds.
2.Move the transmission selector lever toposition N and use the brakes to bringyour vehicle to a safe stop.
3.When your vehicle has stopped, movethe transmission selector lever toposition P or N and switch the ignitionoff.
AUTO-START-STOP
Using Start-Stop
Note:The system is on by default. To switchthe system off, press the switch in theinstrument panel. The system will only beswitched off for the current ignition cycle. Toturn it on, press the switch again.
To stop the engine
1.Stop your vehicle.
2.Move the gear lever to the neutralposition.
3.Release the clutch pedal.
4.Release the accelerator pedal.
The system may not shut down the engineunder certain conditions, for example:
•To maintain the interior climate.
•Low battery voltage.
•The outside temperature is too low ortoo high.
•The driver's door has been opened.
•Low engine operating temperature.
•Low brake system vacuum.
•If a road speed of 3 mph (5 km/h) hasnot been exceeded.
•The driver's safety belt has not beenfastened.
To re-start the engine
Note:The gear lever must be in the neutralposition.
Depress the clutch pedal.
The system may automatically restart theengine under certain conditions, forexample:
•Low battery voltage.
•To maintain the interior climate.
REFUELING
1.Press the flap to open it. Open the flapfully until it engages.
10B-MAX (CB2) Vehicles Built From: 25-06-2012, Vehicles Built Up To: 03-05-2015, CG3574en enGBR, Edition date: 02/2014, Second Printing
