2014 FIAT SCUDO lock

148WARNING
LIGHTS AND
MESSAGESVEHICLE
MAINTENANCETECHNICAL
SPECIFICATIONSINDEXDASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCY
FRONT DIRECTION
INDICATORS fig. 10
To change the bulb, proceed as follows:❒
turn the bulb holder Acounterclock-
wise;
❒
after removing the bulb holder, remove
the bulb pushing it gently and turning
it counterclockwise .
❒
replace the bulb and refit the bulb hold-
er Aby turning it clockwise and lock-
ing it properly.
FRONT FOG LIGHTS fig. 11
The rear headlights contain the bulbs for
the position/stop, direction, reverse and
rear fog lights.SIDE DIRECTION INDICATORS
fig. 12
To change the bulb, proceed as follows:
❒
work on the lens Ato compress the in-
ternal catch, then pull the unit out-
wards;
❒
turn the bulb holder counterclockwise,
remove the snap-fitted bulb and replace
it;
❒
refit the bulb holder in the lens by turn-
ing it clockwise;
❒
refit the unit making sure the catch
clicks into place.
fig. 11
F0P0181m
fig. 10
F0P0179m
fig. 12
A
F0P0297m
139-158 SCUDO LUM GB 07/03/14 08.47 Pagina 148

149
WARNING
LIGHTS AND
MESSAGESVEHICLE
MAINTENANCETECHNICAL
SPECIFICATIONSINDEXDASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCY
REAR LIGHT UNITS
fig. 13
Rear light units contain taillights, brake
light, direction indicators and reversing
light bulbs.fig. 13
F0P0184m
To remove the rear headlights and replace
the bulbs, wide open (180°) the rear dou-
ble doors (see paragraph “Rear double
doors” in section “Dashboard and con-
trols”).fig. 14
F0P0185m
To replace a bulb proceed as follows:❒
Identify the bulb to be substituted;
❒
Remove the two fixing nuts Aand B
❒
From the outside, slide out the trans-
parent group;
❒
Keeping hold of the group, undo the
electrical connector;
❒
Widen the flaps and extract the lamp
holder;
❒
Extract the bulb to be substituted by
slightly pushing and turning it counter-
clockwise (“bayonet” lock) and there-
fore substitute it.
139-158 SCUDO LUM GB 07/03/14 08.47 Pagina 149

151
WARNING
LIGHTS AND
MESSAGESVEHICLE
MAINTENANCETECHNICAL
SPECIFICATIONSINDEXDASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCY
IF AN INTERIOR BULB
BURNS OUTFor the type of bulb and power rating, see
paragraph “When needing to change a
bulb”.
CEILING LIGHT
To replace the bulbs proceed as follows:❒
work in the points shown by the ar-
rows and remove light;
❒
replace bulbs releasing them from the
side contacts; make sure that new bulbs
are correctly clamped between contacts;
❒
secure the light into its housing locking
it properly.
fig. 19
F0P0298m
fig. 20
F0P0234m
❒
rotate lamp-holder by one fourth of
revolution anticlockwise;
❒
change the bulb.
Versions with hatchback fig. 18
❒
working from the outside of the vehi-
cle at the point indicated by the arrow
and remove transparent group A;
❒
change the bulb releasing it from the side
contacts and making sure the new bulb
is correctly fastened between the con-
tacts;
❒
refit the snap-fitted lens unit.
139-158 SCUDO LUM GB 07/03/14 08.47 Pagina 151

153
WARNING
LIGHTS AND
MESSAGESVEHICLE
MAINTENANCETECHNICAL
SPECIFICATIONSINDEXDASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCY
fig. 22
F0P0299m
F1
F2
F4
F5
F6
F7
F8
F9
F10
F11
F12
F13
F14
F15
F16
F1715
–
10
30
30
5
20
10
30
15
15
5
15
30
–
40
Fuse box on the dashboard on passenger sideUSERS FUSE AMPERERear window wiperFree
Headlight aiming device, diagnostic socket, ESC control unit,ventilation, particulate filter pump, steering sensorPower rearview mirror, passenger power windowFront window powerCeiling lights, glovebox light
Multi-function Display, anti-theft alarm siren, sound system,
CD-Changer, Radiotelephone, trailer services control unit, Panel workers protection control unitCigar lighter, load compartment outletRear trimming strip, starting device, instrument panel Diagnostic socket, anti-theft system control unitKit main libre, airbag control unitEngine utilities control unit, trailer utilities control unit
Rain sensor, automatic acclimatiser instrument panel,
ventilation rear part of passenger compartment (combined fittings)Door locking/unlockingFreeRear heated window and door mirrors defroster
❒
Tilt the object holding compartment
and forcibly pull it out so as to access
the fuses.
139-158 SCUDO LUM GB 07/03/14 08.47 Pagina 153

155
WARNING
LIGHTS AND
MESSAGESVEHICLE
MAINTENANCETECHNICAL
SPECIFICATIONSINDEXDASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCY
fig. 24
F1
F2
F3
F1 F4 F3 F4 F5
F0P0241m
F1
F2
F3
F4
F36
F37
F38
F39
F4030
–
40/50
–
15
10
20
–
5
Fuse box in passenger compartment (on battery)USERS FUSE AMPERESeat warming system12V socket –third row seats (combined fittings)
Trailer services control unit and (for versions/markets, where provided) Panel workers protection control unitFreeSwing-door locksSwing-door locksRear window wiper on swing-door
Ventilation rear part of passenger compartment (combined fittings)Folding mirrors
❒
Unhook the cover of the battery com-
partment.
❒
Remove the terminal of the red battery
(+).
After every operation, carefully close
the cover.
139-158 SCUDO LUM GB 07/03/14 08.47 Pagina 155

158WARNING
LIGHTS AND
MESSAGESVEHICLE
MAINTENANCETECHNICAL
SPECIFICATIONSINDEXDASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCY
fig. 26
A
F0P0243m
Do not start the engine
when towing the vehicle.
WARNING
Before screwing the drawbar
eye, carefully clean the rela-
tive threaded part. Before starting to
tow the vehicle, take care also to
have completely tightened the draw-
bar eye onto the threaded pin.
WARNING
Before starting to tow, disen-
gage the steering lock (see
paragraph “Ignition device” in section
“Dashboard and controls”).
When towing, remember that without
the help of the brake booster and
power steering, a greater effort is re-
quired on the pedal and steering
wheel. Do not use flexible cables for
towing and avoid jerks. During tow-
ing operations make sure that fasten-
ing the joint to the vehicle does not
damage the components in contact
with it. When towing the vehicle, you
must comply with the specific traffic
regulations regarding the tow ring and
how to tow on the road.
WARNING
fig. 27
F0P0608m
TOWING THE VEHICLEThe tow ring provided with the vehicle is
housed in the engine compartment as
shown in fig. 26.
TOW RING HOOKING
Proceed as follows:❒
open the bonnet and release the tow
ring A-fig. 26from its seat;
❒
take away the front or rear door B-
fig. 27using the supplied screwdriver;
❒completely undo the drawbar eye on
the relative threaded pin.
139-158 SCUDO LUM GB 07/03/14 08.47 Pagina 158

161
WARNING
LIGHTS AND
MESSAGESTECHNICAL
SPECIFICATIONSINDEX DASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCYVEHICLE
MAINTENANCE
18 36 54 72 90 108
30 60 90 120 150 180
24 48 72 96 120 144●●●●● ●
●●●●● ●
●●●●● ●
●●●●● ●
●●●●● ●
●● ●
●●●●● ●
●●
●●●●● ●
●●●●● ●
●●●●● ●
SERVICE SCHEDULEService coupons shall be performed every 30,000 km
Thousands of miles
Thousands of kilometres
Months
Check tyre conditions/wear and adjust pressure if required
Check light system operation
(headlights, direction indicators, hazard lights, load compartment lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation and adjust nozzles, if requiredCheck windscreen/rear window blade position/wear
Check brake pads wear and regular operation of
front and rear disc brake pads wear indicator (for versions/markets, where provided)
Check rear drum brake linings wear (for versions/markets, where provided)
Sight inspect the conditions of:
Bodywork and underbody protection, pipes and hoses
(exhaust - fuel - brakes)
Rubber parts (boots, sleeves, bushes, etc.)-Brake and fuel hoses
Check accessory drive belt conditions/tension (excluding engines fitted with automatic belt tighteners)Check and adjust handbrake lever stroke, if requiredCheck exhaust emissionsCheck cleanness of locks and cleanness and lubrication of levers
159-178 SCUDO LUM GB 12/12/13 10.02 Pagina 161

163
WARNING
LIGHTS AND
MESSAGESTECHNICAL
SPECIFICATIONSINDEX DASHBOARD
AND CONTROLSSAFETY
DEVICESCORRECT USE
OF THE VEHICLEIN AN
EMERGENCYVEHICLE
MAINTENANCE
HEAVY-DUTYShould prevailing use of the vehicle be un-
der one of the following specially heavy
conditions:❒
trailer or caravan towing;
❒
dusty roads;
❒
short distances (less than 7-8 km) re-
peated and with external tempera-
tures below zero;
❒
frequently idling engines or long dis-
tance low speed driving (e.g. door-to-
door deliveries) or in case of a long
term inactivity;
❒
driving in the city;
carry out the following checks more fre-
quently than required in the Service
Schedule:
❒
check front disk brake pad conditions
and wear;
❒
check cleanness of locks, bonnet and
boot and lever cleanness and lubrica-
tion;
❒
sight inspect the conditions of: engine,
gearbox, transmission, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.);
❒
check battery charge and fluid level
(electrolyte);
❒
visual check on various drive belt con-
ditions;
❒
check and replace pollen filter, if
required;
❒
check and replace air cleaner, if
required.
ROUTINE
MAINTENANCEEvery 1,000 km or before long journeys,
check and top up if required:❒
engine coolant fluid level;
❒
brake fluid level;
❒
windscreen washer fluid level;
❒
tyre pressure and conditions;
❒
light system operation (headlights, di-
rection indicators, hazard lights, etc.);
❒
windscreen wiper/washer operation
and windscreen/rear window blade
position/wear;
Every 3,000 km check and top up if re-
quired: engine oil level.
You are recommended to use PETRO-
NAS LUBRICANTS, products, designed
and produced specifically for Fiat vehicles
(see table “Capacities” in section “Tech-
nical specifications”).
159-178 SCUDO LUM GB 12/12/13 10.02 Pagina 163