2014 FIAT PANDA roof

ROOF RACK/SKI RACKThe attachments B fig. 65 are located in the areas
illustrated in the figure and can only be accessed with
the doors open and after removing the flaps A
fig. 65 from the roof. The Lineaccessori Fiat includes
a dedicated roof rack/ski rack for this car. Follow
the instructions contained in the assembly kit to fit
the roof rack/ski rack.
Vehicle with longitudinal roof rack bars
The areas for the attachments are highlighted by
reference holes B fig. 65. Holes B are located on the
longitudinal roof rack bars, on the side towards
the vehicle centre line. Do not fit the roof rack in
positions different from those indicated by holes B.
The Lineaccessori Fiat includes a dedicated roof
rack/ski rack for this car with longitudinal roof rack
bars. Follow the instructions contained in the
assembly kit to fit the roof rack/ski rack.
Vehicle with sun roof
There is not roof rack for vehicles with sun roof.
WARNING
After travelling for a short distance,
check that the fixing screws for the
attachments are correctly tightened.
WARNING
Never exceed the maximum permitted
loads (see chapter "Technical
specifications").
fig. 65
F0W0098
70GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Sensor operation may also be
compromised by the presence of dust ,
condensation, dirt or ice on the
windscreen, by traffic conditions (e.g. vehicles
that are driving not aligned with you car, vehicle
driving in a transverse or opposite way on the
same lane, bend with a small radius of curvature),
by road surface conditions and by driving
conditions (e.g. off-road driving). Make sure the
windscreen is always clean. Use specific
detergents and clean cloths to avoid scratching
the windscreen.The sensor operation may also be
limited or absent in some driving, traffic and
road surface conditions.Projecting loads on the roof of the car
may interfere with the correct operation
of the sensor. Before starting make sure
the load is correctly positioned, in order not to
cover the sensor operating range.If the windscreen must be replaced due to
scratches, chipping or breakage, contact
exclusively a Fiat Dealership. Do not
replace the windscreen on your own, risk of
malfunction! It is advisable to replace the
windscreen if it is damaged in the laser sensor
area.
Do not tamper nor operate on the laser
sensor. Do not close the openings in the
aesthetic cover located under the interior
rear view mirror. In the event of a sensor failure,
contact a Fiat Dealership.
IMPORTANT If you are driving on roads close to
trees with protruding branches it is advisable to
deactivate the system to prevent the branches at the
height of the bonnet or the windscreen from
interfering with the system.Do not cover the operating range of the
sensor with stickers or other objects.
Also pay attention to other objects on the
bonnet (e.g. a layer of snow) and make sure they
do not interfere with the light emitted by the
laser.
WARNING
The laser beam is not visible at the
naked eye. Do not look directly, or with
optical instruments (e.g. lenses), at the laser
beam from a distance lower than 10 cm: this
may cause damage to the sight .The laser beam
is also present when the key is at MAR-ON
but its operation is off, not available or
manually deactivated with the display Setup
Menu (see paragraph “Menu items” in this
chapter).
86GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

WARNING
If you wish to have a sound system
installed after purchasing the car, first
contact a Fiat Dealership whose qualified
personnel will give you advise about a sound
system that does not damage the batter y
charge. Excessive non­running consumption
damages the batter y and may cause your
batter y warranty to be terminated.
SETUP
(for versions/markets, where provided)
The system consists of:
❒radio supply leads;
❒radio housing;
❒aerial (on car roof );
❒according to the option requested, the setup
consists of four or six speakers.
Setup for four speakers
(for versions/markets, where provided)
The system consists of:
❒two 165-mm diameter full-range speakers in the
front door panels;
❒two 130-mm diameter full-range speakers in rear
front door panels.Setup for six speakers
(if requested as an optional, as an alternative to the
basic audio level)
The system consists of:
❒two 38-mm diameter tweeters in the front pillar at
the sides of the windscreen;
❒two 165-mm diameter mid-woofer speakers in the
front door panels;
❒two 130-mm diameter full-range speakers in rear
front door panels.
92GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

AIR BAGSThe car is fitted with front air bags for driver and
passenger, front side bags for driver and passenger
chest-shoulder protection (for versions/markets,
where provided) and window bags for protecting the
heads of front occupants.
FRONT AIR BAGS
The front (driver and passenger) air bags protect the
front seat occupants in the event of head-on impacts
of medium-high severity, by placing the bag between
the occupant and the steering wheel or dashboard.
Therefore non-deployment in other types of impacts
(side impacts, rear shunts, roll-overs, etc.) does not
indicate a system malfunction.
Front (driver and passenger) air bags are not a
replacement of but complementary to the seat belts,
which you are recommended to always wear, as
specified by law in Europe and most non-European
countries.
In the event of an impact, those not wearing a seat
belt move forwards and may come into contact with
the bag which is still inflating. The protection offered
by the bag is compromised in these circumstances.
Front airbags may not deploy in the following
situations:❒frontal impacts against highly deformable objects
not involving the front surface of the car (e.g.
wing collision against guard rail, etc.);
❒car wedging under other vehicles or protective
barriers (e.g. trucks or guard rails);
they may not provide any additional protection
compared with seat belts, so their activation would
be inappropriate. In these cases, non-deployment
does not indicate a system malfunction.
WARNING
Do not apply stickers or other objects
on the steering wheel, on the dashboard
in the passenger side air bag area, on side
upholstery on roof and on the seats. Never put
objects (e.g. mobile phones) on the passenger's
side dashboard since they could interfere with
correct inflation of the air bag and also cause
serious injur y to the passengers.
Driver's front air bag
This consists of an instantly inflating bag contained in
a special recess in the centre of the steering wheel
fig. 104.
115GETTING TO KNOW
YOUR CARSAFETYSTARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Window bag
This consists of two "curtain" bags housed behind
the side upholstery of the roof fig. 107 and covered
with finishing elements, which protect the heads
of front and rear occupants in the event of a side
impact thanks to a wide bag deployment area.
The deployment of side bags in the event of side
impacts of low severity is not required.
In the event of a side impact, the system provides
best protection if the passenger sits on the seat in a
correct position, thus allowing correct window
bag deployment.
The window bag is not available for the VAN version.
IMPORTANT Do not hook rigid objects to the coat
hooks and to the support handles.IMPORTANT Do not rest your head, arms or elbows
on the door, windows or the area in which the
window bag is located to avoid possible injury during
air bag inflation.
IMPORTANT Never lean your head, arms or elbows
out of the window.
IMPORTANT
Do not wash the seats with water or pressurised
steam (by hand or at automatic seat washing
stations).
The front air bags and/or side bags may be deployed
if the car is subject to violent impacts involving the
underbody area (e.g. violent impacts against steps or
kerbs, big holes or dips in the road etc.).
When the air bag deploys it emits a small amount of
dust: the dust is harmless and does not indicate
the beginning of a fire. The dust may irritate the skin
and eyes however: in this case, wash with neutral
soap and water.
Air bag checking, repair and replacement must be
carried out at a Fiat Dealership.
If the car is scrapped, have the air bag system
deactivated at a Fiat Dealership.
Pretensioners and air bags are deployed in different
ways, according to the type of impact. Failure to
deploy of one of the devices does not necessarily
indicate a system malfunction.
fig. 107
F0W0226
118
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

SAVING FUELHere are some suggestions which can help you to
save fuel and lower harmful emissions.
GENERAL CONSIDERATIONS
Car maintenance
Have checks and adjustments carried out in
accordance with the “Scheduled Servicing Plan”.
Ty r e s
Check the tyre pressures at least once every 4
weeks: if the pressure is too low, consumption levels
increase as resistance to rolling is higher.
Unnecessary loads
Do not travel with an overloaded boot. The weight
of the car and its arrangement greatly affect fuel
consumption and stability.
Roof rack/ski rack
Remove the roof rack or the ski rack from the roof
after use. These accessories lower aerodynamic
penetration and adversely affect consumption levels.
When transporting particularly large objects, use a
trailer if possible.Electrical devices
Only use electrical devices for the amount of time
needed. The heated rear window, additional
headlights, windscreen wipers and heater fan need a
considerable amount of energy, therefore increasing
fuel consumption (by up to 25% in the urban cycle).
Climate control system
The use of the climate control system leads to higher
fuel consumption. If the temperature outside
permits, try to use ventilation only.
Devices for aerodynamic control
The use of non-certified devices for aerodynamic
control may adversely affect air drag and fuel
consumption.
DRIVING STYLE
Starting
Do not warm the engine with the car at a standstill
or at idle or high speed: under these conditions
the engine warms up much more slowly, increasing
consumption and emissions. It is therefore advisable
to move off immediately, slowly, avoiding high speeds:
in this way the engine will warm up more quickly.
126
GETTING TO KNOW
YOUR CAR
SAFETYSTARTING AND
DRIVINGWARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

❒insert the new bulb and make sure that it is
correctly clamped between the contacts;
❒refit the lens A fig. 135.
REPLACING INTERIOR BULBSFor the type of bulb and corresponding power rating,
see the paragraph "Changing a bulb".
FRONT ROOF LIGHT
Versions with multi-bulb roof light
To change the bulbs, proceed as follows:
❒remove the roof light A fig. 137 working at the
points indicated by the arrows;
fig. 136
F0W0214
fig. 137
F0W0066
162
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

❒open the flap B fig. 138 and replace the bulbs C
releasing them from the side contacts. Make
sure that the new bulbs are correctly secured
between the contacts;
❒reclose the flap B fig. 138 and fix the roof light A
fig. 137 in its housing making sure that it is locked.
fig. 138
F0W0067
163GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGESIN AN
EMERGENCYSERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
SINGLE-BULB INTERIOR ROOF LIGHTS
To change the bulbs, proceed as follows:
❒operate in the point shown by the arrow and
remove the roof light A fig. 139;
❒open the flap C fig. 140 and replace the bulb B
releasing it from the side contacts;
❒Insert the new bulb B fig. 140 and make sure that
it is correctly clamped between the contacts;
❒reclose the flap C fig. 140 and fix the roof light A
fig. 139 in its housing making sure that it is locked.
fig. 139