2014 FIAT DOBLO COMBI check engine light

216
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERV IC
ING
AND
MAINTENANCE
TECHNICAL
SPECIFICA TIONS
INDEX
INTERIORS
Check regularly that water is not trapped under the mats
(from dripping off shoes, umbrellas, etc.) which could cause
the metal to rust.
Windows
Use specific detergents to clean the windows. Also use
clean cloths to avoid scratching the glass or altering the
transparency.
IMPORTANT Wipe the rear window gently with a cloth
in the direction of the filaments to avoid damaging the heat-
ing device.
Engine compartment
At the end of each winter, thoroughly wash the engine
compartment, taking care to avoid spraying the water jet
directly onto the electronic control units and the relay/fuse
control unit on the left side of the engine compartment
(as you look from behind the wheel). Have this operation
performed at a specialist garage.
IMPORTANT The washing should take place with the en-
gine cold and the ignition key in the STOP position. After
the wash, make sure that the various protective devices
(e.g. rubber caps and guards) have not been removed or
damaged.
Front headlights
IMPORTANT Never use aromatic substances (e.g. petrol)
or ketenes (e.g. acetone) for cleaning the plastic lenses of
the front headlights.
Never use flammable products, such as pe-
troleum ether or modified petrol, to clean
the inside of the vehicle. The electrostatic charges
which are generated by rubbing during cleaning
may cause a fire.
WARNING
Do not keep aerosol cans in the vehicle:
these could explode. Aerosol cans must
not be exposed to temperatures of more than
50 °C. When the vehicle is exposed to sunlight, the
temperature inside can greatly exceed this val-
ue.
WARNING

250
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICAT IO

NS
INDEX
9. Air conditioning leads to higher fuel consumption (on average up to +30%). If the temperature outside is not
too extreme, try and use the air vents.
Driving style
1. After starting the engine you should drive away im-
mediately and slowly, avoiding high revs. Do not warm
up the engine at low or high revs when the vehicle is
stationary; this causes the engine to warm up more
slowly, thereby increasing fuel consumption, emissions
and mechanical component wear.
2. Avoid pointless actions such as revving up when at
traffic lights or before stopping the engine. The latter
action, like double-declutching, is unnecessary and caus-
es increased fuel consumption and pollution.
3. Gear selection: select a high gear as soon as possible
(taking into account normal engine operation and traf-
fic conditions) without pushing the engine to high revs
during the intermediate gears. Using low gears at high
revs to get excellent acceleration increases fuel con-
sumption, harmful emissions and engine wear.
PRACTICAL ADVICE FOR REDUCING FUEL
CONSUMPTION AND HARMFUL EMISSIONS
Vehicle condition
1. Have checks and
servicingcarried out in accordance
with the “Scheduled servicing plan”.
2. Check tyre pressure regularly, at least once every four
weeks. Excessively low pressures will increase con-
sumption because rolling resistance will be higher. In
these conditions, the tyre will wear and performance
will decay faster.
3. Use snow tyres only when the weather conditions
make them absolutely necessary. They increase con-
sumption and noise.
4. Do not travel with a heavy load: the weight of the
vehicle (especially when driving in town) and its trim
greatly affect fuel consumption and stability.
5. Remove roof racks or ski racks after use. These ac-
cessories reduce the vehicle’s aerodynamic penetra-
tion and have a negative effect on fuel consumption.
6. It is better to use a trailer to transport particularly bulky objects.
7. Use the vehicle’s air vents if possible: travelling with the windows open impairs aerodynamics.
8. Use electrical devices only for the amount of time needed. The heated rear window, auxiliary headlights,
windscreen wipers and fan heater use up a consider-
able amount of current, causing increased fuel con-
sumption (up to +25% in the urban cycle).

268
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXBrake fluid– checking levels and topping up ................. 203
– specifications .................... 248
Brake lights – bulb replace ment.............. 176
Brakes – brake fluid (type) ..... 246-248
– checking levels and topping up ................. 203
– handbrake .......................... 135
– technical specifications .... 225
Bulbs – bulb types ................. 170-171
– general information on replace ment ............... 169
C apability for Isofix
child seat .............................. 125 Capacities
– technical data (quantities) ........................ 246
Carrying children .................. 120
Carrying children safely ....... 125 – Isofix child seat capability .............................125
Catalytic converter .............. 113
Central lo cking ........................ 77
Changing a wheel .................. 156
– general information and warnings .................... 156
– tyre and wheel types ....... 228
– tyre inflation pressure .... 229
Changing bulbs – bulb types ......................... 170
– exterior ............................. 172
– general information ........ 169
– interio r .............................. 178 Checking le
vels ...................... 199
– brake fluid ......................... 204
– engine c oolant ................. 203
– engine oil ........................... 202
– windscreen/rearscreen/ headlamp washer fluid ... 203
Child safety device .................. 80
Child seats .............................. 120
– capability for Isofix child seat ..................................... 125
– suitability for using child seats .................124-127
Cigar ligh ter ............................. 58
Cleaning and maintenance – body .................................... 214
– engine compartment ...... 216
– fabric seats ........................ 217
– interio rs ............................ 216
– leather upho lstery ........... 217
– plastic parts ....................... 217
– windows .............................. 61

270
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXDPF (diesel particulate filter) ...................................... 114
E lectrical/electronic devices 110
Emergency starting ................ 155
– bump starting ................... 166
– jump starting .................... 155
Emissions of CO
2................. 257
End of vehicle life .................. 260
Engine codes ........................... 221
Engine compartment – checking le vels ................. 199
– opening/closing the bonnet .......................... 91
– washing .............................. 216
Engine coolant – checking levels and topping up ................. 203
– specifications .................... 248
– temperature gauge and warning light ................. 13Engine coolant temperature
gauge ........................................ 13
– type of coolant ................ 248
Engine coolant temperature overheating warning light .. 145
Engine coolant – checking levels and topping up ......................... 203
– specifications .................... 248
Engine cooling – checking levels and topping up ................. 203
– specifications .................... 248
Engine immobiliser (Fiat CODE) ............................. 4
Engine mark ing ...................... 220
Engine oil consumption ....... 201 – consumption .................... 202
– engine oil specifications .. 247 Engine oil
– checking levels and topping up .................. 202
– consumption .................... 202
– specifications .................... 247
Engine starting ....................... 133
– emergency starting ..134-155
– ignition switch .......................9
– procedure for Diesel versio ns ..............................134
– procedure for petrol versio ns .............................. 133
– stopping the engine ........ 135
– warming up the engine .. 134
Engine
– engine immobiliser (Fiat CODE) ......................... 4
– identification c odes .......... 221
– marking .............................. 220
– technical data ................... 223