2014 FIAT 500L hood release

VEHICLE SECURITY ALARM — IF EQUIPPED
The Vehicle Security Alarm monitors the vehicle doors
for unauthorized entry and the ignition switch for unau-
thorized operation. While the Vehicle Security Alarm is
armed, interior switches for door locks and liftgate
release are disabled. If something triggers the alarm, the
Vehicle Security Alarm will provide the following au-
dible and visible signals: the horn will pulse, the park
lamps and/or turn signals will flash, and the Vehicle
Security Light in the instrument cluster will flash.
To Arm The System
1. Remove the key from the ignition switch and get outof the vehicle.
2. Lock the door using either the Central Lock/Unlock switch or the Remote Keyless Entry (RKE) transmitter
and close all doors. 3. The horn will sound and the Vehicle Security Light in
the instrument cluster will flash rapidly for approxi-
mately 16 seconds. This shows that the Vehicle Secu-
rity Alarm is arming. During this period, if a door is
opened, the ignition switch is turned to ON/RUN, or
the power door locks are unlocked in any manner, the
Vehicle Security Alarm will automatically disarm.
After approximately 16 seconds, the Vehicle Security
Light will flash slowly. This shows that the Vehicle
Security Alarm is fully armed.
The activation of the Vehicle Security Alarm is followed
by a self-diagnosis stage. If a fault is detected during the
self-diagnosis stage, the horn will sound a second time.
If the horn sounds a second time, check that all doors,
hood and liftgate are closed correctly, then rearm the
system.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15

OPENING AND CLOSING THE HOOD
To open the hood, two latches must be released to open
the hood.
1. Pull the hood release lever located under the left sideof the instrument panel. 2. Move to the outside of the vehicle and push the red
safety catch lever to the left and raise the hood. The
safety catch lever is located under the center front
edge of the hood.
Hood Release Lever
Safety Catch Lever
108 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

CAUTION!
The A/C air filter is identified with an arrow to
indicate airflow direction through the filter. Failure
to properly install the filter will result in the need to
replace it more often.
8. Rotate the glove compartment door back into position.
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should
be lubricated periodically with a lithium based grease,
such as MOPAR® Spray White Lube to assure quiet, easy
operation and to protect against rust and wear. Prior to
the application of any lubricant, the parts concerned should be wiped clean to remove dust and grit; after
lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching
components to ensure proper function. When performing
other underhood services, the hood latch, release mecha-
nism and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR®
Lock Cylinder Lubricant directly into the lock cylinder.
Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield and rear window periodically with a sponge
or soft cloth and a mild nonabrasive cleaner. This will
remove accumulations of salt, waxes, or road film, and
help reduce streaking and smearing.
332 MAINTAINING YOUR VEHICLE

WARNING!(Continued)
•Before replacing a fuse, make sure that the ignition
is off and that all the other services are switched off
and/or disengaged.
• If the replaced fuse blows again, contact an autho-
rized dealer.
• If a general protection fuse for safety systems (air
bag system, braking system), power unit systems
(engine system, gearbox system) or steering system
blows, contact an authorized dealer.
Underhood Fuses
The Front Distribution Unit is located on the right side of
the engine compartment, next to the battery. To access the
fuses, press the release tabs and remove the cover. The ID number of the electrical component correspond-
ing to each fuse can be found on the back of the cover.
Front Distribution Unit
356 MAINTAINING YOUR VEHICLE

Octane Rating......................... .277
Requirements ......................... .277
Tank Capacity ......................... .369
Fueling ............................... .280
Fuses ................................. .355
Garage Door Opener (HomeLink®) ............133
Gasoline, Clean Air ....................... .277
Gasoline (Fuel) .......................... .277
Gasoline, Reformulated .....................277
Gauges Coolant Temperature .....................159
Fuel ................................ .159
Odometer ............................ .166
Tachometer ........................... .161
Gear Ranges ............................ .220
Gear Select Lever Override ..................315
General Information ...................... .276
General Maintenance ...................... .166Glass Cleaning
.......................... .354
Hazard Driving Through Flowing, Rising, or Shallow
Standing Water ........................ .232
Headlights ..............................110
Cleaning ............................ .353
High Beam ........................... .161
Passing ..............................111
Heated Mirrors ............................93
Hill Start Assist .......................... .240
Holder, Cup ............................ .146
HomeLink® (Garage Door Opener) ............133
Hood Release ........................... .108
Ignition Key..................................12
Immobilizer (Sentry Key) ....................13
Infant Restraint ...........................61
10
INDEX 397