Page 363 of 400
361Visual search
Exterior
Electronic key / Keyless Entry and
Star ting 5 4 - 60, 10 4 -105
- opening / closing
- anti-theft protection
- battery
- starting
Welcome lighting 151
Directional lighting 153
Cornering lighting 154
Headlamp height adjustment 152
Changing bulbs 211-215
- front lamps
- foglamps
- direction indicator repeaters
Wipers 155 -15 8
Changing a wiper blade 158, 226
Doors 54- 63
- Keyless Entry and Starting
- opening / closing
- central locking
- emergency control
Alarm 65 - 67
Fuel tank, misfuel
prevention 72-73
Cockpit glass roof 70 -71
Roof bars 230
Accessories 231-232
ESP: ABS, EBA, ASR, DSC 182-185
Tyre under-inflation detection 125 -126
Ty r e
pressures 125, 201, 260
Changing a wheel 202-209
- tools
- removing / refitting
Snow chains 210
Temporary puncture repair kit 196 -201
Boot 55, 64
- opening / closing
- emergency release
Changing bulbs 216 -218
- rear lamps
- 3rd brake lamp
- number plate lamps
- foglamps
Parking sensors 138-139
Reversing camera 140
To w i n g 2 2 7
Towbar 228-229
Door mirrors 86
Door mirror spotlamps 151
Page 377 of 400
5
AdBlue ®
additive
Topping up the AdBlue ®
additive
If the AdBlue ®
additive is spilt outside
of the tank, wash the spillage using
cold water to avoid crystallisation of the
product and damage to surrounding
materials.
If the AdBlue
®
additive has already
formed crystals, wipe them of with a
sponge and hot water.
As soon as the "UREA" warning lamp comes on,
you must fill or top up the additive tank as soon
as possible.
For filling of the AdBlue
®
tank, it is recommended
that you contact a franchised dealer or a
qualified workshop.
This refilling operation forms part of the routine
ser vicing of your vehicle (refer to the ser vicing
booklet).
If the AdBlue
®
additive is completely used up
("starting prevented" or "No start on 0 km"
message), you will not be able to restart the
vehicle.
To allow starting, you can top-up yourself,
adding at least 3.8 litres of the AdBlue
® additive
(equivalent to around 3 000 miles (5 000 km) of
range for the AdBlue
® additive) before making an
appointment with a dealer as soon as possible to
have the AdBlue
® tank filled. If you have to top-up yourself, ensure that the
vehicle is on a flat and level sur face (not over a
kerb or on a slope, ...) so as to ensure correct
filling.
Do not fill the tank when the ambient temperature
is below -10°C.
)
If necessary, use the
screwdriver end of the
towing eye, located in the
boot.
)
Remove the ignition key, or if your vehicle
has one, press the START/STOP button to
switch off the engine.
)
Lift the boot carpet then the cover or spare
wheel for access to the tank filler cap.
)
Unscrew and remove the black cap.
)
Unscrew and remove the 2nd cap (blue).
)
Remove the cap from the AdBlue
®
additive
container
)
To top-up, follow the instructions on the
container.
)
Wipe any splashes of the AdBlue
®
additive
)
Once you have finished topping-up, refit the
blue and then the black cap.
)
Wait for around 5 minutes without doing
anything on the vehicle (opening a door,
radio, …) before switching on the ignition.
Page 383 of 400
5
AdBlue ®
additive
Topping up the AdBlue ®
additive
If the AdBlue ®
additive is spilt outside
of the tank, wash the spillage using
cold water to avoid crystallisation of the
product and damage to surrounding
materials.
If the AdBlue
®
additive has already
formed crystals, wipe them of with a
sponge and hot water.
As soon as the "UREA" warning lamp comes on,
you must fill or top up the additive tank as soon
as possible.
For filling of the AdBlue
®
tank, it is recommended
that you contact a franchised dealer or a
qualified workshop.
This refilling operation forms part of the routine
ser vicing of your vehicle (refer to the ser vicing
booklet).
If the AdBlue
®
additive is completely used up
("starting prevented" or "No start on 0 km"
message), you will not be able to restart the
vehicle.
To allow starting, you can top-up yourself,
adding at least 3.8 litres of the AdBlue
® additive
(equivalent to around 3 000 miles (5 000 km) of
range for the AdBlue
® additive) before making an
appointment with a dealer as soon as possible to
have the AdBlue
® tank filled. If you have to top-up yourself, ensure that the
vehicle is on a flat and level sur face (not over a
kerb or on a slope, ...) so as to ensure correct
filling.
Do not fill the tank when the ambient temperature
is below -10°C.
)
If necessary, use the
screwdriver end of the
towing eye, located in the
boot.
)
Remove the ignition key, or if your vehicle
has one, press the START/STOP button to
switch off the engine.
)
Lift the boot carpet then the cover or spare
wheel for access to the tank filler cap.
)
Unscrew and remove the black cap.
)
Unscrew and remove the 2nd cap (blue).
)
Remove the cap from the AdBlue
®
additive
container
)
To top-up, follow the instructions on the
container.
)
Wipe any splashes of the AdBlue
®
additive
)
Once you have finished topping-up, refit the
blue and then the black cap.
)
Wait for around 5 minutes without doing
anything on the vehicle (opening a door,
radio, …) before switching on the ignition.
Page 400 of 400
9Practical information
DS5_ Additif_en_Chap08_info-pratiques_ed03-2015
Removable screen which prevents the accumulation of snow at the radiator cooling fan.
Very cold climate screen *
Before fitting or removing the screen, ensure that the engine is off and the cooling fan has stopped. It is recommended that the screen be fitted and removed by a CITROËN dealer or a qualified workshop.
Do not forget to remove the very cold climate screen: - when the ambient temperature exceeds 10° C (for example: in summer, ...), - when towing, - at speeds above 75 mph (120 km/h).
Fitting
Offer up the screen to the front of the front b u m p e r. Press on the screen to engage its fixing clips.
Removal
Use a screwdriver as a lever to unclip each retaining clip in turn.
* Depending on country of sale.
