2014 Citroen C4 boot

4
ACCESS
91

















BOOT

Opening




After unlocking the boot or the ve-
hicle using the remote control or the
key, press the opening control, then
raise the tailgate.



Closing




Lower the tailgate using the interior
grab handle.


If necessary, press down on the tail-
gate to fully close it.







Tailgate release

System allowing the mechanical unlock-
ing of the boot in the event of a battery or
central locking system malfunction.

Unlocking



Fold back the rear seats to gain
access to the lock from inside the
boot.


Insert a small screwdriver into hole A

of the lock to unlock the tailgate.


Move the latch to the left.
If the tailgate is not closed correctly:


- when the engine is running
,
this warning lamp comes on,
accompanied by the display
of an alert message for a few
seconds,

- when the vehicle is moving
(speed
above 6 mph (10 km/h)), this warn-
ing lamp comes on, accompanied by
an audible signal and the display of
an alert message for a few seconds.


Locking after closing
If the fault persists after closing again,
the boot will remain locked.

5
VISIBILITY
111








INTERIOR MOOD LIGHTING

The dimmed passenger compartment
lighting improves visibility in the vehicle
when the light is poor.

Switching on

At night, two interior mood lamps in the front courtesy lamp come on automatically
when the sidelamps are switched on.


Switching off

The interior mood lighting switches off
automatically when the sidelamps are
switched off.
It can be switched off manually by ad-
justing the instrument panel lighting
rheostat button to one of the lowest set-
tings.
This comes on automatically when the
boot is opened and goes off automati-
cally when the boot is closed.




BOOT LAMP






The lighting time varies accord-
ing to the circumstances:


- when the ignition is off, ap-
proximately ten minutes,

- in energy economy mode, ap-
proximately thirty seconds,

- when the engine is running,
no limit.

6
FITTINGS
120





REAR ARMREST

Comfort system for the rear passen-
gers.



Lower the rear armrest for a more
comfortable position.
This also gives access to the ski fl ap.









SKI FLAP

Arrangement for storing and transporting
long objects.

Opening




Lower the rear armrest.


Pull the fl ap handle downwards.


Lower the fl ap.


Load the objects from inside the
boot.

6
FITTINGS
121

















BOOT FITTINGS



1.
Rear parcel shelf


(see details on a following page)

2.
Hooks


(see details on a following page)

3.
12 V accessory socket


(see details on a following page)

4.
Torch


(see details on following pages)

5.
Lashing rings


6.
Storage box


(see details on following pages)

7.
Retaining straps


8.
Storage net

6
FITTINGS
122
To remove the shelf:



unhook the two cords,


raise the shelf slightly, then remove it.
There are several options for storing
the shelf:


- either upright behind the front seats,

- or fl at at the base of the boot.








Rear parcel shelf

The hooks can be used to secure shop-
ping bags.






Hooks

An additional hook under the
shelf is used to hold up the boot
fl oor using its cord, to facilitate
access to the tools and spare
wheel or the temporary puncture
repair kit...

Access to the storage box


To connect a 12 V accessory (max
power: 120 W), remove the cap and
connect an appropriate adaptor.


Turn the key to the ignition on posi-
tion.








12 V accessory socket

6
FITTINGS
123
This is a removable lamp, fi tted in the
boot wall, which can be used to light the
boot or as a torch.
For the boot lamp function, refer to the
"Visibility - § Boot lamp" section.









Torch


Operation
This torch operates with NiMH type re-
chargeable batteries.
It has a battery life of approximately
45 minutes and charges while you are
driving.
Use



Extract the torch from its location
pulling it upwards.


Press the switch, located on the
back, to switch the torch on or off.


Unfold the support, located on the
back, to set down and raise the
torch; for example, when changing
a wheel.


Storing



Put the torch back in place in its lo-
cation starting with the lower part.
If you have forgotten to switch off
the torch, this switches it off auto-
matically.


Raise the boot carpet for access to
the storage box.
This has areas for the storage of a box
of spare bulbs, a fi rst aid kit, two warn-
ing triangles...
It also contains the vehicle tools, the
temporary puncture repair kit...







Storage box

Observe the polarities when fi t-
ting the rechargeable batteries.
Never replace the rechargeable
batteries with normal disposable
batteries. It the torch is not engaged cor-
rectly, it may not charge and may
not come on when the boot is
opened.

9
DRIVING
153

Emergency braking

In the event of failure of the
electronic stability control sys-
tem, signalled by the illumi-
nation of this warning lamp,
braking stability is then not guaranteed.
In this event, stability must be assured
by the driver by repeating alternate
"pull-release" actions on the control
lever A
.
In the event of a failure of the main ser-
vice brake or in an exceptional situation
(e.g. driver taken ill, under instruction,
etc) a continuous pull on the control
lever A
will stop the vehicle.
The electronic stability control provides
stability during emergency braking.
If the emergency braking malfunctions,
the message "Parking brake faulty" will
be displayed.
The emergency braking must
only be used in exceptional cir-
cumstances.











Emergency release

In the event of the electric parking brake
malfunctioning or the battery running
fl at, an emergency device can be used
to release the parking brake manually.
Access to tools
The tools are stowed in the storage box
under the boot carpet.
* Available according to equipment: if
these tools are not present, contact a
CITROËN dealer or a qualifi ed work-
shop to obtain them.
B
Chocks*.

C
Release crank*.

9
DRIVING
154



Immobilise the vehicle (or keep
it stationary, if the brake pedal is
pressed), with the engine running,
by engaging fi rst gear (manual
gearbox) or position M
or R
(elec-
tronic gearbox).


Switch off the engine but leave the
ignition on. If it is not possible to im-
mobilise the vehicle, do not operate
the control and contact a CITROËN
dealer or a qualifi ed workshop with-
out delay.


Immobilise the vehicle by placing
the blocks in front or behind the two
front wheels, opposite to the direc-
tion of the slope.
For safety reasons, after this op-
eration it is essential to contact
a CITROËN dealer or a qualifi ed
workshop without delay to re-
place the protective cover.
Following an emergency unlock-
ing, immobilisation of the vehicle
is no longer assured once the
manual emergency release has
been deployed and the manual
control does not allow the re-ap-
plication of your parking brake.
Take no action, either on the
control lever A
, or stopping start-
ing the engine while the release
crank is engaged.
Take care not to allow moisture
or dust in the proximity of the
protective cover.


Remove the storage box under the
boot carpet for access to the emer-
gency release device.


Pierce the protective cover D
on the
tube E
with the release crank.


Introduce the release crank into the
tube.


Turn the release device clockwise .

For safety reasons
, it is essential

to continue turning the device until it
reaches its stop. The parking brake
is released.


Remove the release crank and stow
it with the chocks in the storage box
under the boot carpet.

- Switch the ignition off and then on
to reinitialise the parking brake. If
the reinitialisation of the parking
brake proves impossible, contact
a CITROËN dealer or a qualifi ed
workshop.

- The subsequent time required for
application may be longer than dur-
ing normal operation.