Page 187 of 331
185
E3_en_Chap09_info_pratiques_ed01-2014
Fitting a wheel
Fitting the spare wheel
If your vehicle is fitted with alloy wheels,
when tightening the bolts on fitting, it is
normal to notice that the washers do not
come into contact with the spare wheel.
The wheel is secured by the conical
sur face of each bolt.
List of operations
F Put the wheel in place on the hub.
F S crew in the bolts fully by hand.
F
Pre-tighten the bolts using the wheelbrace 1 o n l y.
After changing a wheel
Have the tightening of the bolts and the
pressure of the spare wheel checked
by a CITROËN dealer or a qualified
workshop without delay.
Have the punctured wheel repaired
and refitted to the vehicle as soon as
possible.
9
Practical information
Page 205 of 331

203
E3_en_Chap09_info_pratiques_ed01-2014
12 V battery
The battery is located under the bonnet.
For access to the (+) terminal:
F
r
elease the bonnet using the interior lever,
then the exterior safety catch,
F
r
aise the bonnet and secure it with its stay,
F
l
ift the plastic cover for access to the (+)
terminal.
Access to the battery
Procedure for starting the engine using another battery or charging a discharged battery.
The presence of this label, in particular
with the Stop & Start system, indicates
the use of a 12 V lead-acid battery with
special technology and specification;
the involvement of a CITROËN dealer
or a qualified workshop is essential
when replacing or disconnecting the
battery.
After refitting the battery, the Stop &
Start system will only be active after a
continuous period of immobilisation of the
vehicle, a period which depends on the
climatic conditions and the state of charge
of the battery (up to about 8 hours).
Before doing any work
Immobilise the vehicle: apply the
parking brake, put the gearbox in
neutral, then switch off the ignition.
Check that all electrical equipment is
switched off.
9
Practical information
Page 215 of 331
213
E3_en_Chap09_info_pratiques_ed01-2014
Roof bars
For safety reasons and to avoid
damaging the roof, it is essential to use
transverse roof bars that are approved
for your vehicle.
Observe the fitting instructions and
the conditions of use given in the
information provided with the roof bars.Version without longitudinal
bars
To install the roof bars, you must secure
them only to the four anchorage points in the
roof frame. These points are masked by the
vehicle's doors when closed.
The roof bar fixings include a stud that should
be introduced into the aperture at each
anchorage point.
Version with longitudinal
bars
You must fit the transverse bars to the
longitudinal bars at the fixing points indicated
by engraved markings on the longitudinal bars.
9
Practical information
Page 216 of 331
214
E3_en_Chap09_info_pratiques_ed01-2014
Maximum load, distributed over the roof
bars, for a loading height not exceeding
40 cm: 80 kg.
This value is subject to change, please
check the maximum load stated in the
instructions provided with he roof bars.
If the height exceeds 40 cm, adapt the
speed of the vehicle to the profile of the
road to avoid damaging the roof bars
and the fixings on the vehicle.
Please refer to national legislation so as
to meet the requirements on carrying
objects that are longer than the vehicle.
Recommendations
F Distribute the load evenly, avoiding overloading on one side.
F
A
rrange the heaviest part of the load as
close as possible to the roof.
F
A
nchor the load securely and fit a warning
flag if part of it overhangs the vehicle.
F
D
rive gently, as the vehicle will be more
liable to the effects of side winds (vehicle
stability may be affected).
F
R
emove the roof bars as soon as they are
no longer needed.
Practical information
Page 219 of 331

217
E3_en_Chap09_info_pratiques_ed01-2014
Accessories
A wide range of accessories and genuine parts is available from the CITROËN dealer network.
These accessories and parts have been tested and approved for reliability and safety.
They are all suitable for your vehicle and benefit from CITROËN's recommendation and warranty.
"Comfort"
Door deflectors, side sun blinds, insulated
module, coat hanger fixed to head restraint,
mobile reading lamp, front and rear parking
sensors, portable ashtray, scented air
freshener, blind for sunroof...
"Transport systems"
Boot carpet, boot liner, boot net, boot spacers,
transverse roof bars, ski carrier, roof box,
towbar, towbar wiring harness, bicycle carrier...
"Styling"
Leather gear lever knob, aluminium foot rest,
alloy wheels, front spoiler, rear diffuser, exterior
expressive stickers...
"Security and safety":
Anti-intrusion alarm, vehicle tracking system,
first aid kit, fire extinguisher, warning triangle,
high visibility vest, wheel security bolts, snow
chains, non-slip covers, front foglamp kit, dog
guard, pet seat belt, seat belt cutter/glass
hammer...
"Protection"
Mats*, seat covers, mud flaps, vehicle cover,
boot...
If a towbar and wiring harness are
fitted outside the CITROËN dealer
network, the installation must be done
strictly in line with the manufacturer's
recommendations. *
T
o avoid any risk of jamming the pedals:
-
e
nsure that mats are correctly positioned
and secured,
-
n
ever fit one mat on top of another.
9
Practical information
Page 312 of 331
E3_en_Chap13_recherche_visuelle_ed01-2014
Boot fittings 83 - 84
- r ear parcel shelf
-
hook
-
s
torage well
-
l
uggage net (accessory)
-
l
uggage net securing
rings
Boot lamp
1
28
Warning triangle
8
5
AdBlue
® t a n k 17 1-173
Interior
Rear door windows 5 6
Manual child lock
1
60
Rear seats
6
0-61
A ir bags
140 -145
Front electric windows
5
5
Deactivating the passenger's front airbag
1
41
Seat belts
1
37-139
Child seats
1
46 -154, 159
ISOFIX child seats
1
55 -157
i-Size child seats
1
58Front seats
5
7-58
Heated seats
5
9
Interior fittings
7
7-81
-
s
un visor
-
g
love box
-
1
2 V accessory socket
- U SB port(s) / Auxiliary socket
- f ront armrest
-
c
oat hooks
Mats
82
Visual search
Page 331 of 331

112
Safety
Locations for ISOFIX child seats
In accordance with European Regulations, this table indicates the options for installing ISOFIX child seats on seats in the vehicle fitted with ISOFIX
mountings.
In the case of universal and semi-universal ISOFIX child seats, the ISOFIX size category, determined by a letter from A
to G
, is indicated on the child
seat next to the ISOFIX logo.
IUF:
seat suitable for the installation of an I
sofix U
niversal seat, F
or ward facing secured using the
upper strap.
IL-SU:
seat suitable for the installation of an I
sofix S
emi- U
niversal seat either:
- rear ward facing fitted with an upper strap or a support leg,
- for ward facing fitted with a support leg,
- an infant car seat fitted with an upper strap or a support leg.
Weight of the child
/ indicative age
Less than 10 kg
(group 0)
Up to about
6 months
Less than 10 kg
(group 0)
Less than 13 kg
(group 0+)
Up to about 1 year
From 9 to 18 kg (group 1)
From about. 1 to 3 years
Type of ISOFIX child seat
Infant car seat
rearward facing
rearward facing
forward facing
ISOFIX size category
F
G
C
D
E
C
D
A
B
B1
1 st
row
Front passenger seat
Not ISOFIX
2
nd
row
Outer rear seats
IL-SU*
IL-SU
IL-SU
IL-SU
IL-SU
IUF
IL-SU
Centre rear seat
Not ISOFIX
Remove and stow the head restraint before installing a child seat on a passenger seat.
Refit the head restraint once the child seat has been removed.
For more information on ISOFIX mountings
and the upper strap, refer to the corresponding
section.
The regulations on carrying children are
specific to each country. Refer to the legislation
in force in your country.
15C 4 C. A0 4 0 CANCELS AND REPLACES
* The ISOFIX infant car seat, secured on the lower rings of a vehicle ISOFIX seat, occupies
two rear seats.