2014 Citroen C3 PICASSO RHD key battery

57
Remote control problem
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F
F
irst of all, use the key in the lock to unlock
or lock your vehicle.
F

T
hen, reinitialise the remote control.Changing the battery
Battery ref.: CR1620 / 3 volts.Reinitialisation
F Switch off the ignition.
F T urn the key to position 2 (Ignition on) .
F

P
ress the closed padlock immediately for a
few seconds.
F

S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. If the battery is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message.
Key reminder
Switching the vehicle off
F Immobilise the vehicle.
F
T urn the key fully towards you to
position 1 (Stop) .
F

R
emove the key from the ignition switch.
F

U
nclip the casing using a coin at the notch.
F

S
lide the flat battery out of its location.
F

S
lide the new battery into its location
observing the original direction.
F

C
lip the casing.
F

R
einitialise the remote control.
do n
ot attach any heavy objects to the
key as this could weigh down on it when
in the ignition switch and cause a fault.
If the key is left in the ignition switch, an
audible signal sounds when the driver's
door is opened.
If the problem persists, contact a CITR
oËn


dealer as soon as possible.
4
Access

63
Activation
F Press button A for more than two seconds.a confirmation message appears on the
multifunction screen, accompanied by an
audible signal.
Deactivation
F Press button A again for more than two seconds.
a

confirmation message appears on the
multifunction screen, accompanied by an
audible signal.
Emergency control
Locking the front and rear
passenger doors
F Insert the key in the lock, located on the edge of the door, then turn it one eighth of
a turn .
Locking the driver's door
F Insert the key in the lock, then turn it to
the left.
Unlocking the driver's door
F Insert the key in the lock, then turn it to the right.
Unlocking the front and rear
passenger doors
F Pull the interior door opening control.
In the event of a failure with the
central locking system, you should
disconnect the battery to lock the boot
and so ensure the complete locking of
the


vehicle.
System which locks or unlocks the doors
mechanically in the event of a malfunction of
the battery or of the central locking.
4
Access

64
F after unlocking the vehicle using the remote control or the key, pull the handle
and raise the tailgate.
boot
- when the engine is running , this
warning lamp comes on, accompanied
by a message on the multifunction
screen for a few seconds,
Tailgate release
Unlocking
F Fold back the rear benchseat to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
Closing
If the tailgate is not closed correctly:
Opening
- when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
a message on the multifunction screen for
a few seconds.
F

L
ower the tailgate using the interior grab
handle. System for mechanical unlocking of the boot
in the event of a battery or central locking
malfunction.
access

129
Stop & StartThe Stop & Start system puts the engine temporarily into standby - SToP mode - during stops in the traffic (red lights, traffic jams, or other...).
The engine restarts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Start system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP
mode
The "ECO" warning lamp comes
on in the instrument panel and the
engine goes into standby:
-

w

ith the 6-speed electronic gearbox
system, at speeds below 5 mph (8 km/h),
when you press the brake pedal or put the
gear lever in position N .
a

time counter calculates the
sum of the periods in ST
oP
m

ode during a journey. It rests
itself to zero every time the
ignition is switched on with
t h e key.
Special cases: STOP mode not
available
STOP mode is not invoked when:
- t he driver's door is open,
-

t
he driver's seat belt is not fastened,
-

t
he vehicle has not exceeded 6 mph
(10
km/h) since the last engine start using
t h e key,
-

t
he engine is needed to maintain a
comfortable temperature in the passenger
compartment,
-
d

emisting is active,
-
s

ome special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed to assure control of a system.
The "ECO" warning lamp flashes for
a few seconds then goes off.
This operation is perfectly normal.
Never refuel with the engine in STOP
mode; you must switch off the ignition
with the key. For your comfort, during parking
manoeuvres, ST
oP m

ode is not
available for a few seconds after
coming out of reverse gear.
ST
oP m

ode does not affect the
functionality of the vehicle, such as for
example, braking, power steering...
9
driving

131
Operating fault
In the event of a fault with the system, the
"ECO OFF" switch warning lamp flashes then
comes on continuously.
Have it checked by a CITR
oËn
dealer or a
qualified workshop.
In the event of a fault in ST
oP m

ode, the
vehicle may stall. All of the warning lamps
in the instrument panel come on. It is then
necessary to switch off the ignition and start
the engine again using the key.
Maintenance
This system requires a battery with a special
specification and technology (reference
numbers available from a CITR
oËn

dealer or a
qualified workshop).
Fitting a battery not listed by CITR
oËn


introduces the risk of malfunction of the
system.
be
fore doing anything under the
bonnet, deactivate the Stop & Start
system to avoid any risk of injury
resulting from automatic operation of
S T a
R
T m o d e .
The Stop & Start system makes use
of advanced technology. All work
on this type of battery must be done
by a CITR
oËn

dealer or a qualified
workshop.
Press the "ECO OFF" switch again.
The system is active again; this is confirmed
by the switch warning lamp going off,
accompanied by a message in the screen.
The system is reactivated automatically
at every new start using the key.
Reactivation
9
Driving

274
Remote control key 54-57
- opening/closing
-
a

nti-theft protection
-


starting
-


battery
Exterior
Lighting controls 6 9 -72
LED daytime running lamps 7 3
Cornering lighting

7
4
Headlamp adjustment
7

5
Changing bulbs
1

62-166
-

f
ront lamps
-


foglamps
-
d

irection indicator repeaters
Door mirrors

5
2
Doors
61
- 63
-


opening/closing
-

c
entral locking
-
em

ergency control
Electric child lock

1
05
Electric windows

5
9 - 60Accessories
1

87-188
Wiper controls
7
6 -78
Changing a wiper blade
1
82
Boot
6
4
Temporary puncture repair kit
1
49 -153
Changing a wheel 1 54-160
- tools
-


removing/refitting
Snow chains

1
61
Changing bulbs
1

67-168
-
r

ear lamps
-
3
rd brake lamp
-
n
umber plate lamps
Rear parking sensors

1
36 -137
Reversing camera

1
38
Towbar
18

5 -18 6
Towing
18

3 -18 4
Hill start assist

1

28
Braking assistance

1

12
Trajectory control

1

13
Tyre pressures

1

96
Fuel tank

6

6 - 67
Misfuel prevention
6

8
Visual search