Page 33 of 257
1
31
Monitoring
Warning / indicator lampStateCauseAction / Observations
Airbags
on temporarily. This lamp comes on for a fewseconds when you turn on the
ignition, then goes off. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.
fix
ed. One of the airbag or seat belt pretensioner systems has a fault. Have it checked by a CITROËN dealer or a qualified
workshop.
Power steering fixed. The power steering has a fault. Drive carefully at reduced speed.
Have it checked by a CITROËN dealer or a qualified
workshop.
Driver's seat belt not fastened or unfastened / Frontpassenger's seatbelt unfastened
fixed or flashin
gaccompanied by an increasing audiblesignal.Th
e driver has not fastened or hasunfastened their seat belt.
The front passenger has unfastened
their seat belt. Pull the strap then inser t the ton
gue in the buckle.
Page 40 of 257
38
Monitoring
Monochrome screen C (Audio system / Bluetooth)
This displays the following information:
- time,- date,
- ambient temperature (this flashes if there isa risk of ice),
- status of doors and boot,
- parking sensors,
- audio sources
(radio, CD, USB por t, jack
socket...),
- trip computer (refer to the "Instruments andcontrols" section).
Warning or information messages may appear
temporarily. These can be cleared by pressingthe return button. From
your Audio system / Bluetooth control
panel, you can press: ) the "MENU"
button to gain access to the main menu , )
the "MODE"
button to select the displayof information in "Full screen" or "New
window" mode,
) the "
" or "
" buttons to navigate in a list, )
press the central button to confirm,
or ) the back button to abandon the operationin progress or go back up one level in themenu.
Displays on the screen
Controls
)Press the "MENU"
button to gain access to
the main menu:
- "Multimedia",
- "Telephone",
- "Trip computer",
-
"Bluetooth connection",
- "Personalisation-configuration", )Press the " " or " " buttons to select the menu required, then confirm by pressing
the centre button.
Main menu
Page 45 of 257
43
2
Access
If one of the doors or the boot is stillopen, the central locking does not take place; the vehicle locks then immediately unlocks, identifiable by thesound of the locks rebounding.
When the vehicle is locked, if it isunlocked inadvertently, it will lockagain automatically after thir ty seconds unless a door or the boot is open.
Locking using the
remote control
)Press the closed padlock to lockthe vehicle.
Locking the vehicle
Locking is confirmed by fixed lighting
of the direction indicators for approximatelytwo seconds.
Locking using the key
)Turn the key in the driver's door lock,
towards the rear of the vehicle to lock it.This
function allows you to identify your vehiclefrom a distance, par ticularly in poor light. Your
vehicle must be locked.
Locating your vehicle Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched
on, this code must be recognised in order for starting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and preventsstarting of the engine by anyone who does not have the key.
In the event of a fault,
you are
informed by illumination of this
warning lamp, an audible signal and a messagein the screen.
In this case, your vehicle will not start; contact
a CITROËN dealer as soon as
possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.
) Press the closed padlock on the
remote control.
This will switch on the cour tes
y lamps and the direction indicators will flash for a few seconds.
Check that the doors and boot are fully
closed.
Page 46 of 257
44
Access
CITROËN dealer as soon as possible.
If the batter
y is flat, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.
Changing the battery
)Remove the flat battery from its location. )Fit the new battery into its location
observing the original direction of fitment. )Clip the cover onto the casing.
In the event of a fault with the remote control,
you can no longer unlock, lock or locate your
vehicle. )First of all, use the key in the lock to unlock
or lock your vehicle. )Then, reinitialise the remote control.
Fault with the remote
control
Reinitialisation
)Switch off the ignition and remove the ignition key. )Press the closed padlock immediatelyfor a few seconds. )Turn the key to position 2 (Ignition on). )Switch off the ignition and remove the keyfrom the ignition switch.
The remote control is fully operational again. Battery re
f.: CR2032 / 3 volts.
)
Unclip the cover using a small screwdriver
at the cutout. )
Lift off the cover.
Page 50 of 257
48
Access
Doors
From out side
)After unlocking the vehicle using the remote control or the key, pull the door
handle.
Opening
From inside
)Pull the interior control lever of a front door;
this unlocks the vehicle completely.
-
when the engine is running,this warning lamp comes on,
accompanied by a message in
the multifunction screen for
a few seconds,
-
when the vehicle is moving
(speed
higher than 6 mph (10 km/h)), this warninglamp comes on, accompanied by an
audible signal and a message in the
multifunction screen for a few seconds.
Closing
When a door is not closed correctly:
Secondary control
For mechanically locking and unlocking the doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Inser t the key in the lock to lock or unlock the door.
Passenger doors
)On the rear doors, check that the child lock
is not on. )Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aperture without
forcing, then without turning, move the latchsideways towards the inside of the door. )Remove the key and refit the cap.
Page 51 of 257
49
2
Access
Boot
Opening
Unlocking and releasing the boot using the remote control
)
Press the centre button on the
remote control for more than one second.The boot lid is released and opens
slightly.
Releasing the boot from the
inside
Openin
g the boot
) Raise the boot lid to its fully open position.
)
Lower the boot lid using one of the interior grab handles.
Closing
Electric boot opening
-when the engine is running
, this
warning lamp comes on, accompanied
by a message in the multifunction
screen for a few seconds,-when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
a message in the multifunction screen for a few seconds.
)
Press the boot opening switch located
on the left of the dashboard (electric boot
opening).or ) Raise the control lever below the driver's
door (mechanical boot opening).
The boot lid is released and opens slightly.
Mechanical boot opening
There is no associated warning for the boot lid
not being fully closed.
Yo u should ensure that the boot is closed correctly.
If the boot is not closed correctl
y:
Page 53 of 257
51
2
Access
Windows
Electric controls
Manual controls
The electric window switches remain operational for about 45 seconds after switching off the ignition or until a front door is opened. During this period of 45 seconds, if you open a door whileoperating a window, the window stops.
Operating the switch again has noeffect until the ignition is switched on again.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, you must reverse themovement of the window. To do this,press the switch concerned.
When operating the passenger electricwindow switches, the driver must ensure that no one is preventing correct closing of the windows.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operatingthe windows.
1.Left hand front electric window switch.2.Right hand front electric windowswitch.3.Right hand rear electric window switch.4.Left hand rear electric window switch.5.
Deactivating the rear electric window switches.To open or close the window, press or pull the
switch. The window stops as soon as the switch is released. T
urn the window winder located on the door
trim panel.
Deactivating the rear window controls
For the safety of your children, press switch 5
to prevent operation of all of the windows,
irrespective of their position.
With the warning lamp on, the switches are
deactivated. With the warning lamp off, theswitches are active.
Model with front electric window
s
Model with front and rear electric windows
Page 54 of 257
52
Access
When the low fuel level in the tank is reached, this warning lamp comes
on in the instrument panel.
Opening the filler cap may result in an inrush of air. This vacuum is entirely normal and results from the sealing of the fuel system.
Fuel tank
Capacity of the tank: approximately 50 litres.
A label on the inside of the filler flap reminds you of the type of fuel to use according to your engine.
Additions of fuel must be of at least 5 litres to be registered by the fuel gauge.
Refuelling
)Open the filler cap by turning it a 1/4 turn to
the left. )Remove the filler cap and hang it on its carrier (on the filler flap). )Fill the tank. Do not continue past the thirdcut-off of the nozzle, as this may causemalfunctions. )Refit the filler cap turning it a 1/4 turn to the right. )Push the filler flap to close it.
Opening
)Raise the lever. When it first comes on,
around 5 litres
of fuel
remain in the tank.
You must refuel as soon as possible to avoid
running out.
If you run out of fuel (Diesel), refer the the
"Checks" section.
