Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition
sounds a chime signal to remind you to remove the key.
NOTE:
•The Key-In-Ignition reminder only sounds when the
ignition key is placed in the LOCK or ACC position.
• With either front door open, and the key in the
ignition, both the power door locks and Remote Key-
less Entry (RKE) transmitter will not function.
SENTRY KEY®
The Sentry Key® Immobilizer System prevents unau-
thorized vehicle operation by disabling the engine. The
system does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is locked
or unlocked. The system uses ignition keys which have an embedded
electronic chip (transponder) to prevent unauthorized
vehicle operation. Therefore, only keys that are pro-
grammed to the vehicle can be used to start and operate
the vehicle. The system will shut the engine off in two
seconds if someone uses an invalid key to start the
engine.
NOTE:
A key which has not been programmed is also
considered an invalid key, even if it is cut to fit the
ignition switch lock cylinder for that vehicle.
During normal operation, after turning the ignition
switch to ON/RUN, the Vehicle Security Light will turn
on for three seconds for a bulb check. If the light remains
after the bulb check, it indicates that there is a problem
with the electronics. In addition, if the light begins to
flash after the bulb check, it indicates that someone used
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15
an invalid key to start the engine. Either of these condi-
tions will result in the engine being shut off after two
seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than 10
seconds), it indicates that there is a fault in the electron-
ics. Should this occur, have the vehicle serviced as soon
as possible by an authorized dealer.
CAUTION!
•Always remove the Sentry Key® from the vehicle
and lock all doors when leaving the vehicle unat-
tended.
• The Sentry Key® Immobilizer system is not com-
patible with some aftermarket remote starting sys-
tems. Use of these systems may result in vehicle
starting problems and loss of security protection. All of the keys provided with your new vehicle have
been programmed to the vehicle electronics.
Replacement Keys
NOTE:
Only keys that have been programmed to the
vehicle electronics can be used to start the vehicle. Once
a Sentry Key® has been programmed to a vehicle, it
cannot be programmed to any other vehicle.
At the time of purchase, the original owner is provided
with a four-digit Personal Identification Number (PIN).
This PIN is required for authorized dealer replacement of
keys. Duplication of keys may be performed at an
authorized dealer or by using the Customer Key Pro-
gramming procedure. This procedure consists of pro-
gramming a blank key to the vehicle electronics. A blank
key is one which has never been programmed.
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
NOTE: When having the Sentry Key® Immobilizer
System serviced, bring all vehicle keys with you to an
authorized dealer.
Customer Key Programming
You can program new keys to the system if you have two
valid Sentry Keys® by performing the following proce-
dure:
1. Cut the additional Sentry Key® Transponder blank(s)to match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at
least three seconds, but no longer than 15 seconds.
Then, turn the ignition switch to the LOCK position
and remove the first key. 3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON/RUN position
within 15 seconds. After ten seconds, a chime will
sound. In addition, the Vehicle Security Light will
begin to flash. Turn the ignition switch to the LOCK
position and remove the second key.
4. Insert a blank Sentry Key® into the ignition switch. Turn the ignition switch to the ON/RUN position
within 60 seconds. After 10 seconds, a single chime
will sound. In addition, the Vehicle Security Light will
stop flashing. To indicate that programming is com-
plete, the indicator light will turn on again for three
seconds and then turn off.
The new Sentry Key® is programmed. The Remote
Keyless Entry (RKE) transmitter will also be pro-
grammed during this procedure.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
Bulb Replacement...................... .471
Cleaning ............................ .456
High Beam ........................... .232
High Beam/Low Beam Select Switch .........180
On With Wipers ....................... .179
Passing ............................. .181
Replacing ............................ .471
Switch .............................. .178
Head Restraints ......................... .171
Heated Mirrors .......................... .127
Heated Seats ............................ .167
Heater ................................ .283
Heater, Engine Block ...................... .302
High Beam/Low Beam Select (Dimmer) Switch . . . .180
Hitches Trailer Towing ........................ .386
HomeLink® (Garage Door Opener) ............192
Hood Prop ............................. .176Hood Release
........................... .175
Ignition .................................12
Key..................................12
Lock .................................12
Ignition Key Removal .......................12
Illuminated Entry ..........................21
Immobilizer (Sentry Key) ....................15
Infant Restraint ...........................70
Information Center, Vehicle ..................235
Inside Rearview Mirror .....................124
Instrument Cluster ....................... .217
Instrument Panel and Controls ................216
Instrument Panel Cover .....................457
Instrument Panel Lens Cleaning ...............459
Integrated Power Module (Fuses) ..............464
Interior Appearance Care ....................457
Interior Lighting ......................... .183
Intermittent Wipers (Delay Wipers) .............185
10
INDEX 507
Introduction..............................4
Jacking Instructions ....................... .402
Jack Location ........................... .400
Jack Operation .......................... .400
Jump Starting ............................411
Key-In Reminder ..........................15
Keyless Entry System .......................21
Key, Programming .........................17
Key, Replacement ..........................16
Keys ...................................12
Key, Sentry (Immobilizer) ....................15
Knee Bolster ..............................57
Lane Change and Turn Signals ................227
Lane Change Assist ....................... .180
Lap/Shoulder Belts .........................44
Latches .................................96 Hood
............................... .175
Latch Plate ...............................45
Lead Free Gasoline ....................... .370
Leaks, Fluid ..............................96
Life of Tires ............................ .358
Light Bulbs ..............................96
Lights ..................................96
Airbag ................................63
Back-Up ............................. .475
Battery Saver ......................... .184
Brake Assist Warning ....................336
Brake Warning ........................ .221
Bulb Replacement ...................... .471
Courtesy/Reading ..................... .183
Daytime Running ...................... .182
Dimmer Switch, Headlight .................180
Electronic Stability Program (ESP) Indicator .....336
Engine Temperature Warning ...............220
Exterior ...............................96
508 INDEX
Safety Checks Outside Vehicle.................95
Safety Defects, Reporting ....................495
Safety, Exhaust Gas .........................92
Safety Information, Tire .....................338
Safety Tips ...............................92
Satellite Radio Antenna .....................270
Schedule, Maintenance .....................482
Seat Belt Maintenance ..................... .459
Seat Belt Reminder .........................56
Seat Belts ................................40
And Pregnant Women .....................57
Child Restraint ..........................70
Extender ..............................57
Front Seat .............................44
Inspection .............................93
Operating Instructions ....................45
Pretensioners ...........................51
Rear Seat ..............................44
Reminder ............................ .219Untwisting Procedure
.....................49
Seats ................................. .165
Adjustment .......................... .165
Easy Entry ........................... .171
Heated .............................. .167
Height Adjustment ..................... .166
Lumbar Support ....................... .170
Memory ............................. .171
Power .............................. .166
Reclining ............................ .169
Seatback Release ....................... .171
Tilting .............................. .166
Security Alarm (Theft Alarm) ..................18
Selection of Coolant (Antifreeze) ...............478
Sentry Key (Immobilizer) ....................15
Sentry Key Programming ....................17
Service Assistance ........................ .491
Service Contract ......................... .493
Service Manuals ......................... .496
10
INDEX 513