
Confirmation signals from the vehicle
The settings are saved in the active profile, re‐
fer to page  35.1."Settings"2."Doors/key"3.Deactivate or activate the desired confir‐
mation signals.▷"Acoustic sig. lock/unlock"▷"Flash when lock/unlock"
Automatic locking
The settings are saved in the active profile, re‐fer to page  35.
1."Settings"2."Doors/key"3.Select the desired function:▷"Lock if no door is opened"
The vehicle locks automatically after a
short period of time if no door is
opened.▷"Lock after start driving"
The vehicle locks automatically after
you drive off.
Retrieving the seat and mirror settings
The driver's seat and exterior mirror positions
used last are stored for the remote control cur‐
rently in use.
When the vehicle is unlocked, these positions
are automatically retrieved if this function was
activated.
Pinch hazard when moving back the seat
If this function is used, first make sure
that the footwell behind the driver's seat is
empty. Otherwise, people might get injured or
objects damaged when the seat is moved
back.◀
The adjustment procedure is interrupted:
▷When a seat position reel is pressed.▷When a button of the seat and mirror mem‐
ory is pressed.
Activating the setting
1."Settings"2."Doors/key"3."Last seat position autom."
Alarm system
The conceptWhen the vehicle is locked, the vehicle alarm
system responds to:
▷Opening a door, the hood or the trunk lid.▷Movements in the interior.▷Changes in the vehicle tilt, e. g., during at‐
tempts at stealing a wheel or when towing
the car.▷Disconnected battery voltage.
The alarm system briefly signals tampering:
▷By sounding an acoustic alarm.▷By switching on the hazard warning sys‐
tem.▷By flashing the daytime running lights.
Arming and disarming the alarm
system
When you unlock or lock the vehicle, either
with the remote control or via the Comfort Ac‐
cess, the alarm system is disarmed or armed at
the same time.
Door lock and armed alarm systemThe alarm system is triggered when the door is
opened, when the vehicle is unlocked via the
door lock.
Panic mode You can trigger the alarm system if you find
yourself in a dangerous situation.
Seite 43Opening and closingControls43
Online Edition for Part no. 01 40 2 956 860 - X/14 

Adjustments in detail1.Forward/back.2.Height.3.Seat tilt.4.Backrest tilt.Thigh support
Pull the lever at the front of the seat and adjust
the thigh support.
Lumbar support The curvature of the seat backrest can be ad‐
justed in a way that it supports the lumbar re‐
gion of the spine. The lower back and the
spine are supported for upright posture.
▷Press the front/rear section
of the reel.
The curvature is increased/
decreased.▷Press the upper/lower sec‐
tion of the reel.
The curvature is shifted up/
down.
Backrest width
Change the width of the back‐
rest using the side wings to ad‐
just the lateral support.
Seite 53AdjustingControls53
Online Edition for Part no. 01 40 2 956 860 - X/14 

Safety mode1.Close the driver's door or reel on the igni‐
tion.2.Press and hold the desired button 1 or 2
until the adjustment procedure is com‐
pleted.
Calling up of a seat position
deactivated
After a brief period, calling up stored seat posi‐
tions is deactivated to save battery power.
To reactivate calling up of a seat position:
▷Open and close the door or trunk lid.▷Press a button on the remote control.▷Press the Start/Stop button.
Mirrors
Exterior mirrors
General information The mirror on the passenger side is more
curved than the driver's side mirror.
Depending on the vehicle equipment, the mir‐
ror setting is stored for the profile currently in
use. When the vehicle is unlocked via the re‐
mote control, the position is automatically re‐
trieved if this function is active.
Note Estimating distances correctly
Objects reflected in the mirror are closer
than they appear. Do not estimate the distance
to the traffic behind you based on what you
see in the mirror, as this will increase your risk
of an accident.◀
At a glance1Adjusting   582Left/right, Automatic Curb Monitor3Fold in and out   59
Selecting a mirror
To change over to the other mirror:
Slide the switch.
Adjusting electrically The setting corresponds to the direc‐
tion in which the button is pressed.
Saving positions
Seat and mirror memory, refer to page  57.
Adjusting manually
In case of electrical malfunction press edges of
mirror.
Automatic Curb MonitorThe concept
If reverse gear is engaged, the mirror glass on
the front passenger side is tilted downward.
This improves your view of the curb and other
low-lying obstacles when parking, e.g.
Activating
1.  Slide the switch to the driver's side
mirror position.
Seite 58ControlsAdjusting58
Online Edition for Part no. 01 40 2 956 860 - X/14 

of unexpected movement of the rear seat
backrest.◀
On the front passenger seat
Deactivating airbags Deactivating the front-seat passenger
airbags
If a child restraint system is used in the front
passenger seat, deactivate the front-seat pas‐
senger airbags; otherwise, there is an in‐
creased risk of injury to the child when the air‐
bags are activated, even with a child restraint
system.◀
After installing a child restraint system in the
front passenger seat, make sure that the front,
knee and side airbags on the front passenger
side are deactivated.
Deactivate the front-seat passenger airbags
automatically, refer to page  98.
Seat position and height
Before installing a child restraint system, move
the front passenger seat as far back as possi‐
ble and adjust its height to the highest and
thus best possible position for the belt and to
offer optimal protection in the event of an acci‐
dent.
If the upper anchorage of the safety belt is lo‐
cated in front of the belt guide of the child seat,
move the passenger seat carefully forward un‐
til the best possible belt guide position is
reached.
Backrest width Backrest width for the child seat
Before installing a child restraint system
in the front passenger seat, the backrest width
must be opened completely. Do not changethe adjustment after this; otherwise, the stabil‐
ity of the child seat will be reduced.◀
Adjustable backrest width: before installing a
child restraint system in the front passenger
seat, open the backrest width completely. Do
not change the backrest width again and do
not call up a memory position.
Child seat security
The rear safety belts and the front passenger
safety belt can be permanently locked to fas‐
ten child restraint systems.
Locking the safety belt
1.Pull out the strap completely.2.Secure the child restraint system with the
belt.3.Allow the strap to be pulled in and pull it
tight against the child restraint system.
The safety belt is locked.
Unlocking the safety belt
1.Unbuckle the belt buckle.2.Remove the child restraint system.3.Allow the strap to be pulled in completely.Seite 62ControlsTransporting children safely62
Online Edition for Part no. 01 40 2 956 860 - X/14 

Everything from A to Z
IndexA ABS, Antilock Brake Sys‐ tem  119 
ACC, Active Cruise Control with Stop & Go  124 
Acceleration Assistant, refer to Launch Control  74 
Activated-charcoal filter  150 
Active Blind Spot Detec‐ tion  115 
Active Cruise Control with Stop & Go, ACC  124 
Adaptive brake lights, refer to Brake force display  117 
Adaptive Light Control  92 
Additives, oil  201 
Adjustments, seats/head re‐ straints  52 
After washing vehicle  221 
Airbags  96 
Airbags, indicator/warning light  97 
Air circulation, refer to Recir‐ culated-air mode  147, 149  
Air, dehumidifying, refer to Cooling function  146, 149  
Air distribution, manual  146, 150  
Air flow, air conditioner  146 
Air flow, automatic climate control  150 
Air pressure, tires  188 
Air vents, refer to Ventila‐ tion  151 
Alarm system  43 
Alarm, unintentional  44 
All around the center con‐ sole  16 
All around the roofliner  17 All around the steering
wheel  14 
All-season tires, refer to Win‐ ter tires  196 
All-wheel-drive  120 
Alternating-code hand-held transmitter  154 
Alternative oil types  202 
Antifreeze, washer fluid  71 
Antilock Brake System, ABS  119 
Anti-slip control, refer to DSC  119 
Anti-theft protection, see through-loading sys‐
tem  161 
Approved axle load  227 
Approved engine oils  202 
Arrival time  86 
Ash tray  157 
Assistance, Roadside Assis‐ tance  216 
Assistance when driving off  123  
Assist system information, on Control Display  89 
Attentiveness assistant  117 
AUTO intensity  149 
Automatic car wash  220 
Automatic climate con‐ trol  145  
Automatic climate control with enhanced features  148 
Automatic Cruise Control with Stop & Go  124 
Automatic Curb Monitor  58 
Automatic deactivation, front- seat passenger airbags  98 
Automatic headlight con‐ trol  92 
Automatic locking  43 Automatic recirculated-air
control  149 
Automatic transmission, see Steptronic transmission  72 
AUTO program, automatic cli‐ mate control  149 
AUTO program, climate con‐ trol  146  
AUTO program, intensity  149 
Auto Start/Stop function  66 
Average fuel consumption  86 
Average speed  86 
Axle loads, weights  227 
B Backrest curvature, refer to Lumbar support  53 
Backrest, width  53 
Band-aids, refer to First aid kit  216  
Bar for tow-starting/ towing  218 
Battery replacement, vehicle battery  212 
Battery replacement, vehicle remote control  34 
Battery, vehicle  212 
Belts, safety belts  55 
Beverage holder, cu‐ pholder  165 
BMW Assist, see user's manual for Navigation, En‐
tertainment and Communi‐
cation 
BMW maintenance sys‐ tem  204 
Bonus range, ECO PRO  176 
Bottle holder, refer to Cu‐ pholders  165 
Brake assistant  119 Seite 230ReferenceEverything from A to Z230
Online Edition for Part no. 01 40 2 956 860 - X/14