200 Intelligent technology
Braking
General information
What affects braking efficiency?
Operating conditions and driving habits
The brakes on today's automobi les are sti ll
subject to wear, depending largely on operat
ing conditions and driving habits
c:> ,&. On
vehicles that are either driven mostly in stop
and-go city traffic or are driven hard, the brake pads should be checked by your author
ized Audi dealer more often than specified in
the
Warranty & Maintenan ce booklet . Failure
to have your b rake pads inspected can result
in red uced brake performance.
On steep slopes, you shou ld use the brak ing
effect of the engine. This way, you prevent un
necessary wear on the brake system. If you
must use yo ur brakes, do not hold the brakes
down continuously. Pump the brakes at inter
va ls.
Moisture or road salt
Unde r certain conditions, for example, when
driving through water or very heavy rain, or
even after washing your vehicle, the braking
effect can be red uced due to moisture (or in
freezing conditions ice) on the brake pads. A
few careful brake applications should dry off the brake pads or remove any ice coatings.
When you are driving at higher speeds with
the windshield wipers on, the brake pads will
briefly touch the brake discs in regular inter
vals so as to improve reaction t ime when brak
ing on wet surfaces. You the driver will not no
tice anything .
The effectiveness of the brakes can be reduced
when the vehicle is dr iven on a salt-covered
road and the brakes are not used . Here too,
you should clean off accumulated salt coat ing
from brake discs and pads with a few careful
applications of the brake
c:> ,& .
Corrosion
There may be a tendency for dirt to build up
on the brake pads and corrosion to form on the
discs if the car is not driven regu larly or
o n Ly for short trips with litt le use of the
brakes.
If the brakes are not used frequently, or if cor
r osion has formed on the discs, it is advisable
to clean off the pads and discs by braking
firmly a few times from a moderately h igh
speed
c:> .&. .
Faults in the brake system
If you shou ld notice a sudden increase in
brake pedal travel, then one of the two brake
circuits may have fai led
c::> .&. .
Low brake fluid level
Malfunctions can occu r in the brake system if
the brake fluid level is too low. The brake fluid
l evel is monitored electronically.
Brake booster
The brake booster works with vacuum pres
su re which is created only when the eng ine is
running
c::> ,& .
Brake lining wear status
Brake lining wear may be checked by visual in
spect ion of the condition of the brake pads
t hr ough the open ings in the wheel. If neces
sary, the wheel may be removed for this in
spect ion
c:> page 266, Changing a wheel.
.8_ WARNING
-You shou ld perform braking maneuvers
for the purpose of cleaning the brake
system only if road conditions permit.
Other road users must not be put at risk -
you may cause an accident!
- Before descending a steep grade, reduce
speed and sh ift transmission into a lower
gear or lower driving range. Do not ride
the brakes or hold the pedal down too
long or too often . This could cause the
brakes to get hot and diminish braking
efficiency.
- Do not "ride the brakes" by resting your
foot on the pedal when you do not intend
to brake. This may cause the brakes to
