2014.5 VAUXHALL CORSA window

28Keys, doors and windows
Corsa VXR: For pedestrians safety,
the exterior mirrors of the Corsa VXR are released from the holder if they
are struck with sufficient force. Fit mirror housing to holder with latching
lugs and engage by striking gently.
Manual
The exterior mirrors can be folded in
by pressing gently on the outer edge
of the housing.
Heated mirrors
Operated by pressing the Ü button.
Heating works with the engine
running. It is switched off
automatically after a short time.

Keys, doors and windows29Interior mirrors
Manual anti-dazzle
To reduce dazzle, adjust the lever on the underside of the mirror housing.
Automatic anti-dazzle
Dazzle from following vehicles at
night is automatically reduced.
Windows
Windscreen
Heat-reflecting windscreen
The heat-reflecting windscreen has a
coating which reflects solar radiation. Also data signals, e.g. from toll
stations, might be reflected.
The marked areas on the windscreen are not covered with the coating.
Devices for electronic data recording
and fee payment must be attached in
these areas. Otherwise data
recording malfunctions may occur.

30Keys, doors and windows
Windscreen stickers
Do not attach stickers such as toll
road stickers or similar on the
windscreen in the area of the interior
mirror. Otherwise the detection zone
of the sensor and the view area of the camera in the mirror housing could be
restricted.
Manual windows
The door windows can be opened or
closed with the window winders.
Power windows9 Warning
Take care when operating the
power windows. Risk of injury,
particularly to children.
Keep a close watch on the
windows when closing them.
Ensure that nothing becomes
trapped in them as they move.
Power windows can be operated:
■ with the ignition on,
■ within 5 minutes of switching the ignition off,
■ within 5 minutes of turning the ignition key to position 1.
After switching off the ignition, the
window operation is disabled when
the driver's door is opened, then
closed and locked.Operate the control to open or close
the window.
For vehicles with automatic feature,
pull or press the switch again to stop
window movement.
Safety function
If the window glass encounters
resistance during automatic closing, it is immediately stopped and openedagain.
In the event of closing difficulties due
to frost or the like, operate the switch
several times to close the window in
stages.

Keys, doors and windows31
Operating windows from outside
Depending on the equipment level,
the windows can be operated
remotely from outside the vehicle.
Press q or p until all windows have
opened or closed.
Overload
If the windows are repeatedly
operated at short intervals, the
window operation is disabled for
some time.
Fault
If the windows cannot be opened or
closed automatically, activate the window electronics as follows:
1. Close doors.
2. Switch on ignition.
3. Close the window completely and
operate the button for
5 more seconds.
4. Open the window completely and operate the button for
1 more second.
5. Repeat this for each window.Heated rear window
Operated by pressing the Ü button.
Heating functions with the engine running and is switched off
automatically after a short time.
Depending on the engine type, the
heated rear window comes on
automatically when the diesel particle filter is being cleaned.
Sun visors
The sun visors can be folded down or swivelled to the side to prevent
dazzling.

32Keys, doors and windows
If the sun visors have integral mirrors,the mirror covers should be closed
when driving.Roof
Sunroof9 Warning
Take care when operating the
sunroof. Risk of injury, particularly to children.
Keep a close watch on the
movable parts when operating
them. Ensure that nothing
becomes trapped in them as they
move.
Sunroof can be operated with ignition on.
Operated via a rocker switch in the
roof console.
Press the button briefly for activation
in steps. Hold down the button for
longer for automatic opening.
Raise
With the sunroof closed, press ü.
The sunroof is raised at the rear.
Open Press ü again with the sunroof in the
raised position. The sunroof opens
automatically until it reaches its end
position.
To close: press d.

Keys, doors and windows33Caution
When using a roof rack, check thefree movement of the sunroof in
order to avoid damage. It is only
permitted to raise the sunroof
when a roof rack is installed.
Notice
If the top of the roof is wet, tilt
sunroof, allow water to run off and
then open sunroof.
Do not affix any stickers to sunroof.
Close
Hold down d until the sunroof is
completely closed.
Sunblind
The sunblind is manually operated.
Close or open the sunblind by sliding. When the sunroof is open, the
sunblind is always open.
Overload
If the system is overloaded, the powersupply is automatically cut-off for a
short time. The system is protected by
fuses in the fuse box 3 166.
Initialising the sun roof
If the sunroof cannot be operated,
activate the electronics as follows:
with ignition on, close the sunroof and
hold d depressed for at least
10 seconds.
Seek the assistance of a workshop to
have the cause of the fault remedied.

Instruments and controls73
Keep the sensor free from dust, dirt
and ice.
Windscreen washer
Pull lever. Washer fluid is sprayed
onto the windscreen and the wiper
wipes a few times.
Rear window wiper/washer
Push lever forwards. The rear window wiper wipes in interval mode. Switch
off by pushing lever forwards again.
Do not use if the rear window is
frozen.
Switch off in car washes.
If the lever is held forwards, washer
fluid is sprayed onto the rear window.
The rear windscreen wiper comes on
automatically when the windscreen
wiper is switched on and reverse gear
is engaged. Activation or deactivation
of this function can be changed.
Vehicle personalisation 3 95.
Outside temperature
A drop in temperature is indicated
immediately and a rise in temperature
after a time delay.
If the outside temperature drops to
3 °C, the symbol : illuminates in the
Triple-Info-Display or the
Board-Info-Display as a warning for

96Instruments and controls
■Pull turn signal stalk and wiper stalk
simultaneously to the steering
wheel until you hear a confirmation
signal (approx. 3 seconds).
■ The miles display shows P1.■ Push the turn signal stalk (left) up
or down and select the desired
function P1 - P7 .
■ Push the wiper stalk (right) up or
down and select status On or OFF ,
or input a value for speed ( P6) or
value for volume ( P7).
■ Pull turn signal stalk (left) and wiper
stalk (right) simultaneously to the
steering wheel until you hear a
confirmation signal (approx.
3 seconds).
The selected settings are now stored
for the key in the ignition switch. To
activate and deactivate the functions
and set the functions selected, please see the relevant sections.
Repeat the procedure to programme
additional keys.
Programmable functions P1 : Switch on the external lighting
using the remote control (Entry
lighting). Entry lighting 3 105.
P2 : Automatic rear windscreen wiper
when reverse gear is selected. Rear
window wiperwasher 3 73.
P3 : Lane change indication: three
flashes when the lever is moved
slightly. Turn and lane-change
signals 3 101.