Exterior
Keyless Entry and Starting 6 9 -76
Remote control
6
2- 68, 76
-
o
pening / closing
-
b
ack-up control
-
b
attery
Alarm
7
9-82 Lighting controls
1
32-136
Headlamp adjustment
1
38
Guide-me-home lighting
1
35, 136
Welcome lighting
1
37
Directional lighting systems
1
39 -140
Changing bulbs
2
76-280
-
f
ront lamps
-
f
ront foglamps
-
s
ide repeaters
Wiper controls
1
41-145
Changing a wiper blade
2
95 Door mirrors
1
09 -110
Blind spot sensors
2
20 -222
Doors
7
7-78, 83
Keyless Entry and Starting
6
9 -76
-
o
pening / closing
-
em
ergency control
Child lock
1
66
Electric windows
87
- 88
Fuel tank
2
35 -237
Misfuel prevention
2
38
Accessories
3
06-307
Roof bars
2
96
Braking assistance
1
72-173
Trajectory control
1
73 -174
Tyre under-inflation detection
2
14-215
Tyre pressures
2
66, 321
Snow chains
2
75
Boot
6
3, 69, 84- 86
Temporary puncture
repair kit
2
62-266
Changing a wheel
2
67-274
-
t
ools
-
r
emoving / refitting
AdBlue additive, topping up
2
50 -256, 257-259
Changing bulbs
2
81-283
-
r
ear lamps
-
3rd brake lamp
-
n
umber plate lamp
Parking sensors
2
29 -230
To w b a r
2
9 9 - 3 0 0
Quickly detachable towball
3
01-305
Towing
29
7-298
Changing the side spotlamps
(LEDs)
For the replacement of this type of light emitting
diode lamp, contact a CITROËN dealer or a
qualified workshop.
Changing the light guides /
sidelamps
For the replacement of this type of light-
emitting diode lamp, contact a CITROËN dealer
or a qualified workshop.
Changing foglamp bulbs
F Introduce a flat screwdriver in the hole in the finisher.
F
P
ull and lever to unclip the bumper finisher
(the parking sensor stays with the finisher).
F
R
emove the two module fixing screws and
remove it from its housing.
F
D
isconnect the bulb holder connector.
F
T
urn the bulb holder a quarter of a turn and
extract it.
F
P
ull the bulb and change it.
To refit, carry out these operations in reverse
o r d e r.
To replace these bulbs you may also contact a
CITROËN dealer or a qualified workshop.
281
1. Brake lamps (P21/5W).
2. Sidelamps (LEDs) *.
3.
D
irection indicators (PY21W amber).
4.
R
eversing lamp (P21W).
5.
R
ear foglamps (P21W).
Rear lamps
Amber bulbs, such as those for the
direction indicators, must be replaced
by bulbs of the same rating and colour.
The lamps on the tailgate, other than
the guide lamps, are dummy units.
They are there for aesthetic purposes
o n l y.
Changing stop lamp, reversing lamp and direction indicator bulbs
These three bulbs are changed from inside the boot:
F
o
pen the boot,
F
r
emove the access grille from the
corresponding side trim panel,
F
s
lacken the two nuts using a 10 mm tube
spanner then remove the nuts by hand,
F
u
nclip the lamp unit connector,
F
e
xtract the lamp unit carefully pulling in its
middle towards the outside, F
r
emove the foam seal,
F
u
nclip the two small secondary connectors,
F
s
pread the two tabs and remove the bulb
h o l d e r,
F
t
urn the bulb a quarter of a turn and change it.
To reassemble, carry out these operations in
reverse order.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without forcing, so as to avoid damaging
the
lamp.
* LED: light-emitting diodes.
Practical information
