Page 412 of 494
Driving
8
Maintenance
In the event of a malfunction with the system, the "ECO OFF" switch warning lamp flashes, then comes on continuously. Have it checked by a CITROËN dealer or a qualified workshop.
Operating fault
This system requires a specific battery with a special specification and technology (reference numbers available from a CITROËN dealer or a qualified workshop). Fitting a battery not listed by CITROËN introduces the risk of malfunction of the system.
Before doing anything under the bonnet, deactivate the Stop & Start system to avoid any risk of injury resulting from automatic operation of START mode.
The Stop & Start system makes use of advanced technology. All work on this type of battery must be done only by a CITROËN dealer or a qualified
workshop.
In the event of a fault in STOP mode, the vehicle may stall. All of the instrument panel warning lamps come on. Depending on version, an alert message may also be displayed asking you to put the gear lever into position Nand put your foot on the brake pedal.
It is then necessary to switch off the ignition, then restart the engine using the key or the "START/STOP" button.
Reactivation
The system is reactivated automatically at every new start using the key or the "START/STOP" button.
Press the "ECO OFF" switch again. The system is active again; this is confirmed by the switch warning lamp going off and the display of a message.
Deactivation
At any time, press the "ECO OFF" switch to deactivate the system. This is confirmed by the switch warning lamp coming on accompanied by the display of a message.
If the system has been deactivated in STOP mode, the engine restarts immediately.
Page 441 of 494
Audio and Telematics
38
Hazard zone /
Danger zone
alert settings
Press on Navigation to display the primary page.
Press on the secondary page.
Select " Settings ".
Select " Alarm! ".
It is then possible to activate Risk Areas alerts then: - "Audible warning"
- "Alert only when navigating" - "Alert only for overspeed" - "Display speed limits" - Timing: the choice of timing allows the time before giving a Risk Area alert to be defined.
Select " Confirm ".
This series of alerts and displays is only available if Risk Areas have first been downloaded and installed on the system.
T r a f fi c
Traffic information
Display of messages
Press on Navigation to display the primary page.
Press on the secondary page.
Select " Traffic messages ".
Set the:
" On the route ",
" Around ",
" Near destination ", filters to fine-tune the list of messages.
Press again to remove the filter.
Page 479 of 494
Audio and Telematics
76
The following table groups together the answers to the most frequently asked questions concerning your audio system.
Frequently asked questions
Navigation
QUESTIONANSWERSOLUTION
The route calculation is not successful. The route settings may conflict with the current location (exclusion of toll roads on a toll motor way). Check the route settings in the "Navigation" menu.
The POIs do not appear. The POIs have not been selected. Select the POIs in the list of POIs.
The Hazard zone audible warning does not work. The audible warning is not active. Activate audible warnings in the "Navigation" menu.
The system does not suggest a detour around an incident on the route.
The guidance criteria do not take account of TMC messages. Select the "Traffic info" function in the list of route settings.
I receive a Accident-prone area alert which is not on my route.
Other than guidance, the system announces all Hazard zones positioned in a cone located in front of the vehicle. It may provide an alert for a Hazard zone located on nearby or parallel roads.
Zoom in on the map to view the exact position of the Accident-prone area. Select "On the route" to no longer receive alerts other than navigation instructions or to reduce the time for the announcement.
