2013 VOLVO XC90 specifications

11 Specifications
Fluids
11
291
CategorySpecification
Washer fluid reservoirUse washer fluid solvent in cold weather conditions 6.9 US quarts (6.5 lit-
ers)
Air conditioning systemRefrigerant – R134aB
AThe transmission oil does not normally need to be changed during the service life of the vehicle. However, it may be necessary to replace the oil if the vehicle is often driven in areas of sustained
temperature extremes (hot or cold), when towing a trailer over long distances, for prolonged driving in mountainous areas, or if the vehicle is often driven short distances in temperatures under 40 °F
(5 °C).
BSee page 94 for volumes

11 Specifications
Suspension
11
292
Rear suspension
Individual rear wheel suspension with longitu-
dinal support arms, double link arms and track
rods.
Front suspension
Spring strut suspension with integrated shock
absorbers and control arms linked to the sup-
port frame. Power-assisted rack and pinion
steering. Safety type steering column.

11 Specifications
Engine oil
11
293 Oil specifications
Engine oil must meet the minimum ACEA A5/
B5 . Lower quality oils may not offer the samefuel economy, engine performance, or engine
protection.Volvo recommends Castrol.
Engine designationVolumeA
3.2 6-cyl. B6324S57.18 US qts (6.8 liters)
AIncluding filter replacement.

11 Specifications
Engine specifications
11
294
Engine designationB6324S5
Output
kW/rps179/107
hp/rpm240/6400
Torque
Nm/rps320/53
ft. lbs./rpm236/3200
No. of cylinders6
Bore (mm/in.)3.3/84
Stroke (mm/in.)3.78/96
Cylinder displacement, liters3.19 (194.8 cu in)
Compression ratio10.8:1
Charge air cooler (Intercooler)Turbocharged engines employ a turbo-com-
pressor to force air into the engine inlet mani-
fold and a charge air cooler to cool the com-
pressed inlet air. The resulting increase in air
flow raises pressure in the intake manifold and
increases engine power over that developed by
the normally-aspirated engine. The charge air
cooler (which resembles a radiator) is located
between the turbo-compressor and inlet mani-
fold.Fuel systemThe engine is equipped with a multiport fuel
injection system.

11 Specifications
Electrical system
11
295 General information
12-volt system with voltage controlled gener-
ator. Single wire system in which the chassis
and engine block are used as conductors,
grounded on the chassis.
Battery
Battery3.2 6-cyl.
Voltage12 V
Cold start capacity
(CCA)520 A
Reserve capacity
(RC)100 min
Capacity (Ah)60
If you must replace your battery, be sure to
replace it with a battery of the same cold start
capacity and reserve capacity as the original.
(See the decal on the battery).
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related acces-
sories contain lead and lead compounds,
chemicals known to the state of California
to cause cancer and reproductive harm.
Wash hands after handling.

11 Specifications
Three-way catalytic converter
11
296
Three-way catalytic converter -
general information
•Keep your engine properly tuned. Certain
engine malfunctions, particularly involving
the electrical, fuel or distributor ignition
systems, may cause unusually high three-
way catalytic converter temperatures. Do
not continue to operate your vehicle if you
detect engine misfire, noticeable loss of
power or other unusual operating condi-
tions, such as engine overheating or back-
firing. A properly tuned engine will help
avoid malfunctions that could damage the
three-way catalytic converter.
•Do not park your vehicle over combustible
materials, such as grass or leaves, which
can come into contact with the hot exhaust
system and cause such materials to ignite
under certain wind and weather condi-
tions.
•Excessive starter cranking (in excess of
one minute), or an intermittently firing or
flooded engine can cause three-way cata-
lytic converter or exhaust system over-
heating.
•Remember that tampering or unauthorized
modifications to the engine, the Electronic
Control Module, or the vehicle may be ille-
gal and can cause three-way catalytic con-
verter or exhaust system overheating. This
includes: altering fuel injection settings or
components, altering emission systemcomponents or location, or removing com-
ponents, and/the repeated use of leaded
fuel.
NOTE
Unleaded fuel is required for vehicles with
three-way catalytic converters.

11 Specifications
Overview of information and warning symbols
11

297 Introduction
The symbols in the vehicle's various displays
are divided into three main categories:
•Warning symbols
•Indicator symbols
•Information symbols
The following tables list the most common
symbols, their meaning and the pages in this
manual that provide more detailed information.
Warning/information symbol
This symbol () lights up and glows red if
the condition is related to safety and/or driva-
bility or yellow to alert the driver to e.g., fill the
washer fluid reservoir, etc. In either case, a
message will be displayed in the instrument
panel display.
Symbols in the main instrument panel
Indicator and warning symbols
SymbolDescriptionPage
Warning59
Malfunction indi-
cator light61
SymbolDescriptionPage
Fault in the ABS
system61
Rear fog light60
Stability system
DSTC61
Trailer turn signal
indicator61
Parking brake
applied60
SRS airbag sys-
tem59
SymbolDescriptionPage
Oil pressure warn-
ing light60
Seat belt reminder59
Generator warn-
ing light60
Brake failure
warning light60
High beam indica-
tor58

11 Specifications
Overview of information and warning symbols
11
298
SymbolDescriptionPage
Left turn signal58
Right turn signal58
Other information symbols
SymbolDescriptionPage
Cruise control78
Information symbols in the center
console display
SymbolDescriptionPage
Surround sound254
HD radio257
Audio files269
CD folder269
SymbolDescriptionPage
Bluetooth-con-
nected cell phone273
BluetoothTM
hands-free
273
Information symbols in the ceiling
console
SymbolDescriptionPage
Seat belt reminder56
Occupant weight
sensor28